Tektronix Tektronix DPO Training/Tutorials

xx

Tektronix DPO

ZZZ

Demo 1 Board

Instruction Manual

www.tektronix.com

071253900*

*P

071-2539-00

Copyright © Tektronix. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries
or suppliers, and are protected by national copyright laws and international treaty provisions.

Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication
supersedes that in all previously published material. Specifications and price change privileges reserved.

TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.

Contacting Tektronix

Tektronix, Inc.
14200 SW Karl Braun Drive
P.O . Bo x 50 0
Beaverton, O
USA

For product information, sales, service, and technical support:

In North America, call 1-800-833-9200.
World w ide, visi t www.tektronix.com to find contacts in your area.

R 97077

DPO Demo 1 Board

The Tektronix DPO Demo 1 board provides signals you can use to demonstrate
features of Tektronix oscilloscopes.

Signals

Connections

Plug a USB cable between your computer and the Demo 1 board. When you apply
power to the demo board, a green LED on the board turns on.

Figure 1: USB Power connector and LED, connection points, and signal names

I2CBus

Demo 1 Board Instruction Manual 1

Board label. I2C SDA, SCLK

Description. This is the I

and a serial EEPROM.

There are several different types of data packets.

2

C (Inter-IC Communication) bus signal between the uC