Tektronix TDSHT3 User manual
020-3018-00 and Above
TDSHT3 HDMI Co
mpliance Test Software, Option DS
This document
supports the Option DS kit, which provides the necessary
accessories to make connections for the Direct Synthesis method. Figures 1 and 2
show you how to make the connections. The parts list refers to the numbers in
these figures.
NOTE. The accessories are the same for all Sink and Cable tests, except the Sink
Intra-Pair Skew test, which is shown in Figure 2.
The quantity of each part in this kit is indicated in the parts list Qty column.
You can use the Tektronix part numbers provided in the kit parts list to order
replace
Fig. index
number
1-1 131-8489-00 8 Bias-Tees
1-2 174-49
1-3 012-0
1-4 015-
1-5 012-
Tektronix part
number
020-3018-00 1 Accessory kit
44-01
057-01
1016-00
0991-01
Serial no.
effecti
ment parts.
ve
Serial no.
’d
discont
Qty Descrip
8
4
2
4
Matched SMA cable
BNC cables
BNC T-adapter
GPIB cables
tion
NOTE. This is used to connect the oscilloscope to
1, AWG1 to AFG, and A FG to AWG2.
AWG
1-6 119-7601-00 8
2-1 015-0735-00 8 6 dB attenuator
2-2 119-7635-00 8
131-8490-00 8
015-0551-00 2
www.tektronix.com
Copyright © Tektronix
ps rise time filter
120
0–6400 MHz low pass filter
SMA (Male) to SMA (Male) connector
OTE.
N
or 120 ps TTC filters if the connectors are female
connectors.
BNC-SMA adapter
These are required to connect the bias-tees
*P001151500*
001-1515-00
020-3018-00 and Above TDSHT3 HDMI Compliance Test Software, Option DS
Figure 1: Setup diagram for Sink Min/Max, Sink Jitter Tolerance, Sink Deep Color, and Cable tests
2 TDSHT3 HDMI Compliance Test Software Instructions
Loading...