Teknatool 55518TX Users Manual

User Manual

a. Firstly assemble the button battery in watch housing and

check the RX also be connected to power.

b. Touching one time of the RX switch, then touch TX

watch power switch up or down .the LED will be lighted
with red color and be keeping 5 seconds , this means RX
and TX already complete match code operation. Of
course, if these steps failure, the LED will be blinked
twice with Red and be keeping 1.5seconds, attention the
TX power is not enough, the LED color will be dark
red.(General this step need be completed before
assemble, the user don’t need to do this operation.)

c. According to your actual requirement, you may select a

switch in surface of watch to control your machine, such
as: power switch on or off /up speed switch/down speed
switch, one touch or continuous touch one switch is
available till achieving your requirement status.

------Switch on status: Pressing this switch till to more than
2seconds, the LED display will be green. Meaning ON
status is success

------Switch off status: Quickly pressing this switch and
loosing your hand finger, the LED will light with red.

------Switch up/down: quickly press a bit switch or
continuing to press the switch till achieving your target
status.

FCC CAUTION:

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) The device may not cause harmful interference, and
(2) This device must accept any interference received,

including interference that may cause undesired operation

Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment