TEFAL DV86 series, DV8610 Instructions Manual

9100018172-03 - 05/18

DV86XX

www.tefal.com

2

3

1

11

4
5

12

6

10

9

8

7

fig. 1 fig. 2 fig. 3

fig. 4a

fig. 6

fig. 4b fig. 5

fig. 7 fig. 8

IMPORTANT SAFETY

INSTRUCTIONS

When using your appliance, basic precautions should
always be followed, including the following:

• Read all instructions before using this product.

• To reduce the risk of contact with hot water emitting
from steam vents, check appliance before each use by
holding it away from body and operating steam button.

• Use appliance for its intended use only.

• This product has been designed for domestic or indoor use
only. Any commercial use, inappropriate use or failure to
comply with the instructions, the manufacturer accepts
no responsibility and the guarantee will not apply.

• To protect against a risk of electric shock, do not immerse
the appliance in water or other liquids.

• Do not direct steam at people, animals or iron clothes
while they are being worn.

• Always turn the appliance off before plugging or
unplugging the iron from the electrical outlet. Never pull
on the cord to disconnect the iron from the electrical
outlet; instead, grasp the plug and pull on the plug to
disconnect the appliance.

• Always unplug appliance from electrical outlet when
filling with water, emptying or when not in use.

• Do not operate appliance with a damaged cord or if
appliance has been dropped or damaged.

• To avoid the risk of electric shock, do not disassemble
or attempt to repair the appliance. Take it to the

5

1

nearest authorized TEFAL approved service center for
examination and repair. Incorrect reassembly or repair
can cause a risk of fire, electrical shock or injuries to
persons when the appliance is used.

EN

• This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they are under supervision or have
been provided instructions concerning use of the
appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do
not play with the appliance.

• Do not leave appliance un-attended while plugged in
or while it is still hot.

• Close supervision is necessary for any appliance being
used by or near children.

• Care should be taken when using the appliance due
to the emission of steam; burns could occur from
touching hot metal parts, hot water or steam. Use care
when you empty a steam appliance.

• There may be hot water in the reservoir.

• The use of other accessory attachments than those
provided by TEFAL is not recommended and may result
in fire, electric shock or personal injury.

• If an extension cord is absolutely necessary, a cord
with an ampere rating equal to or greater than the
maximum rating of the iron shall be used. A cord rated
for less amperage can result in a risk of fire or electric
shock due to overheating. When using an extension
cord extra precaution should be taken to ensure that

2

the cord cannot be tripped over or pulled on.

• This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a sage way
and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance
shall not be made by children unless they are older than
8 and supervised

• Keep the iron and its cord out of reach of children less
than 8 years of age when it is energized or cooling down.

• The plug must be removed from the socket before the
water tank is filled with water.

• Do not allow cord to touch hot surfaces. Let Appliance
cool completely down before putting away. Loop cord
loosely around appliance when storing.

• The iron must be used and rested on a stable surface.

• When placing the iron on its stand, ensure that the
surface on which the stand is placed is stable.

• The iron must not be used if it has been dropped, if there
are visible signs of damage or if it is leaking.

• The appliance complies with the technical rules and
standards for safety currently in force (electromagnetic
compatibility, low voltage, environment)

• Check the electrical power for signs of ware e or damage
prior to use. If the electrical power is damaged, it must
be replaced at an approved service center to avoid any
danger.

• WARNING ! The voltage of your electrical installation

3

must correspond to that of the iron (220-240V).
Connecting to the wrong voltage may cause irreversible
damage to the iron and will invalidate the guarantee.

The surfaces which are marked or close to with this

EN

sign are very hot during the use of the appliance. Do
not touch these surfaces before the appliance has
cooled down.

SAVE THESE INSTRUCTIONS

4

DESCRIPTION

1. Water tank cover

2. Temperature control

3. Removable water tank

4. Water tank release button

5. Temperature ready light

6. Cord protector

7. Beaker

8. Steam burst trigger

9. Iron rest support

10. Lint pad

11. Fabric brush accessory

12. Storage

BEFORE USE

Please read the instructions for use and important safeguards carefully.

• Remove any packaging from the appliance.

• Do not plug in or turn on until assembly is complete.

It is normal for a small amount of smoke to be produced the first time the appliance
is used. This will quickly disappear. This product is tested with water, some residual
water may still be in the water tank.

Filling with water

Warning ! Never use 100% distilled or demineralised water as this can cause the
appliance to spit and leak.

• Your steam brush has been designed to operate using untreated tap water. If your water is
very hard (check with your local water authority) it is possible to mix tap water with store­bought distilled or demineralised water in the following proportions:

- 50% untreated tap water,

- 50% distilled or demineralised water.

Important: Heat concentrates the elements contained in water during evaporation.

The types of water listed below may contain organic waste, mineral or chemical elements
that can cause spitting, brown staining, or premature wear of the appliance: water
from clothes dryers, scented or softened water, water from refrigerators, batteries,
air conditioners, rain water, boiled, filtered or bottled water. Also use distilled or
demineralised water only as advised above.

• Remove the water tank by pulling the button and lifting the water tank (Fig.1).

• Remove the water inlet cover.

• Fill the water tank to the top with water until Max mark fig.2 and close it securly. Make sure
that the cover is properly pushed in place - fig.3.

• Completely unwind the power cord. Plug in your steam brush.

5

USE

During use or while unit is heating or cooling, do not rest appliance on its soleplate.
Place the product on its iron rest support (- fig. 4B), heat resistant , flat surface, as the
soleplate will be hot. As the appliance heats, the housing becomes warm. This is normal.

• Once the appliance is plugged in, the light is on. Set the thermostat control dial to the desired
setting - fig.4a.

• After the light turns off, you can begin use as the appliance has reached the appropriate
temperature.

• To begin steaming, press the steam button with the appliance facing away from you, holding
it in a vertical position - fig.7. Press by successive pressure.

The soleplate of the 2 in 1 Steam’n Press will smooth out tough wrinkles from clothes and press
in sharp creases and pleats.

1. Starting Up

When the 2 in 1 Steam ‘n Press is plugged in the soleplate heats.
Do not touch or remove the soleplate cover accessory without letting the soleplate
cool down.

• Plug in the appliance, place it on the iron rest support and wait approximately one minute for
it to reach full temperature before using. The temperature light will turn off.

EN

2. Selecting the temperature

Set the thermostat control dial according to the type of fabric you are ironing. Check the fabric
label for the appropriate setting. (Fig.5)

Fabric temperature regulator

Synthetics
nylon
polyester

Silk
wool

cotton
linen

Start at low temperature • and graduate to high temperature •••. For delicate fabrics we
recommend carrying out a test on a non-visible part of the garment (inner seam). Steam can
only be produced when the thermostat is aligned to ••• setting or more.

As appliance is very hot: never attempt to remove creases from a garment while it
is being worn.

(low temperature)

(medium temperature)

(high temperature)

•

••

•••

Steaming clothes

Before removing or attaching the accessory, unplug your appliance and let it cool
down for one hour minimum.

The 2 in 1 Steam’n Press is equipped with a fabric brush accessory.

• To insert the accessory and slide forward until it locks into place. (Fig.6)

• You can use the appliance with or without the accessory. (Fig.5 to 8)

6