• Please read these instructions carefully before first use.
• This product has been designed for indoor, domestic use
only. Any commercial use, inappropriate use or failure to
comply with the instructions, the manufacturer accepts no
responsibility and the guarantee will not apply.
• Always plug your appliance:
− into a mains socket with voltage between 220 V and 240V.
− into an earthed electrical socket.
Connecting to the wrong voltage may cause irreparable
damage to the appliance and will invalidate your guarantee.
Do not use an extension lead. If you accept liability for
doing so, only use an extension lead which is in good
condition, has a plug with an earth connection and is
suited to the power rating of the appliance.
• Completely unwind the power cord before plugging into an
earthed socket.
• Use appliance for its intended use only.
• To reduce the risk of contact with hot water emitting from
steam vents, check appliance before each use by holding it
away from body and operating steam button.
• This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be
made by children without supervision.
4
Page 5
• Never pull on the cord to disconnect the appliance from
electrical outlet; instead, grasp plug and pull to disconnect
on the plug to disconnect the appliance.
• Do not allow cord to touch hot surfaces or come into
contact with rough or sharp edges. Let the appliance cool
completely down before putting away. Loop cord loosely
around appliance when storing.
• Always disconnect appliance from the electrical supply
when filling with water or emptying when cleaning, when
removing or refitting accessories and when not in use.
• Care should be taken when using the appliance due to the
emission of steam.
• Do not operate appliance with a damaged cord or if
appliance has been dropped or damaged. To avoid the
risk of electric shock, do not disassemble or attempt to
repair the appliance.Take it to the nearest approved service
centre for examination and repair. Incorrect reassembly or
repair could cause a risk of fire, electrical shock or injury to
persons when the appliance is used.
• Close supervision is necessary for any appliance being
used by or near children.
• Do not leave the appliance unattended while plugged in or
while it is still hot.
• Burns could occur from touching hot metal or plastic parts,
hot water or steam. Use care when you empty a steam
appliance. There may be hot water in the reservoir.
• If an extension cord is absolutely necessary, a cord with
a 16A ampere rating shall be used. A cord rated for less
amperage can result in a risk of fire or electric shock due
to overheating. Care shall be taken to arrange the cord so
that it cannot be pulled or be tripped over.
Page 6
• To protect against a risk of electric shock, do not immerse
the appliance in water or other liquids.
• Do not direct steam at people, animals or clothes while
they are being worn.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that they
do not play with the appliance.
• The use of accessory attachments other than those
provided by the manufacturer is not recommended and
may result in fire, electric shock or personal injury.
• The appliance must be rested on a stable surface. When
placing the appliance on its base, ensure that the surface
on which the base is placed is stable.
• The appliance must not be used if it has been dropped, if
there are visible signs of damage or if it is leaking.
• Check the electrical power cord for sign and wear or
damage prior to use. If the electrical power cord is
damaged, it must be replaced at an approved service
centre to avoid any danger.
• Do not use other descaling products than the one cited in
the IFU.
Before first use
• When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small discharge of
particles. This will not affect the use of the appliance and will disappear quickly.
What water to use?
• Your appliance has been designed to use untreated tap water.
If your water is very hard, mix 50% tap water and 50% bottled demineralised water.
6
Page 7
Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened water, rain water, filtered,
bottled or boiled water, water from refrigerators, batteries or air conditioners as these may damage the appliance. These types
of water contain organic waste, mineral elements that become concentrated when heated and cause spitting, brown staining,
leaking or premature wear on your appliance. If your water is very hard, mix 50% untreated tap water with 50% distilled water
(available in hardware stores). This water contains organic waste materials or minerals that concentrate under the effect of heat
and cause spitting, brown colouring or premature ageing of your appliance.
SAVE THESE INSTRUCTIONS
Environment protection first !
i
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
7
Page 8
BEFORE USE
1
Unlock and remove the water tank.
Remove the water inlet stopper.
Fill the water tank with untreated tap water.
Close the water inlet stopper.
8
Page 9
Return the water tank to its place on the appliance.
Make sure that the water tank is fully set in place
and locked.
ASSEMBLY BOARD
2
GUIDE
View of the finished product and exploded view.
9
Page 10
“CLICK”
Lay down the three parts on a table and clip them
together.
Insert the cover over the board.
Position the four bands around the four hooks.
10
Band the cord and slip the stop element.
Page 11
Tuck away the cord in the back of the cover.
Deploy the hook.
Hang the board on the door hook.
Warning: never use the board and the product on a
flat position.
11
Page 12
ACCESSORIES /
3
*
The door hook allows to hang your garment for
steaming. Do not use the door hook on wooden on
painted doors to avoid damaging the door.
*
The fabric brush opens the weaves of the fabrics for
better steam penetration.
Before removing or attaching the steam brush,
unplug your appliance and allow it to cool down, for
one hour.
*
The steam cover filters water impurities and protects
fabrics from water drips.
This accessory must be used for delicate fabrics
which do not support ironing.
Before removing or attaching the steam cover,
unplug your appliance and allow it to cool down for
one hour.
The crease attachment is used to make pant creases
*
easily or to remove stubborn creases. Put your fabric
in the space between the two accessory parts. Move
the crease at tachment in a downwards motion
starting from the top.
Before removing or attaching the accessory, unplug
your appliance and allow it to cool down for one
hour.
12
* Depending on model
Page 13
*
The travel pouch is used for transpor tation. Before
storing your appliance in the travel pouch, unplug
your appliance then empt y the water tank and
allow the appliance for approximately 1 hour until
completely cool.
The lint pad is a separate accessory and cannot be attached to the steam head.
You can use the lint pad independently from the steamer.
*
The lint pad removes hair, lint and animal fur for a
professional finish.
• To use the lint pad, slowly brush the clothing with
the grain or nap of the fabric.
• The pad can be cleaned by brushing it in the
opposite direction. We recommend cleaning the
pad on an old cloth that can be discarded.
* Depending on model
13
Page 14
40s
OK
ON
4
USE
Warning : Never steam a garment while it is being
worn.
Plug-in the appliance.
Switch on the appliance.
14
Wait until the light stops flashing (approximately
40 seconds). When the light is steady the appliance
is ready to use.
Page 15
Press the steam button with the steam brush facing
away from you holding it in a ver tical position.
For optimal use, move the garment steamer over
your garment from top to bottom.
3 levels of steam: adapt the steam output to your
garment.
For continous steam, lock the steam trigger by
pushing the locker switch down. To release it, push
it up.
15
Page 16
3 sec.
OFF
Press and hold the On/Off button for 3 seconds to
switch the appliance off.
Unplug the appliance.
Warning: Never touch the soleplate of the appliance.
Warning: Never steam a garment with the board on
your legs.
16
Page 17
STANDBY MODE
5
1) For your safety, the appliance is fitted with a
standby monitoring system, which is activated
automatically after approximately 8 minutes
without use.
2) Only the ‘On-Off ’button flashes slowly to indicate
that the appliance is on standby
3) To reactivate the steambrush :
a. Press the ‘ On-Off ’ button and wait until the
button light stops flashing
b. You can start steaming again.
AFTER USE
6
Unlock and remove the water tank.
17
Page 18
Empty the water tank completely.
1h
Return the water tank to its place on the appliance.
Wait for approximately 1 hour for your appliance to
cool completely before storing or using the travel
pouch.
18
Page 19
50%
50%
Water
Water
White Vinegar /
Citric Acid
DESCALING
7
Do this operation in a well ventilated room.
Unlock and remove the water tank.
Remove the water inlet stopper.
Fill the water tank with 50% untreated tap water and
50% white vinegar or citric acid.
Do not use other descaling products.
19
Page 20
40s
OK
ON
Return the water tank to its place on the appliance.
Make sure the water tank is fully set in place and
locked.
Plug-in the appliance.
Switch on the appliance.
Wait until the light stops flashing (approximately
40 seconds). When the light is steady the appliance
is ready to use.
20
Page 21
OK
3 sec.
OFF
Put the steam trigger in the locked position using
the locker.
Place the product on a flat, stable, horizontal and
heat resistant surface.
Allow the appliance to run until the water tank has
completely emptied.
Press and hold the On/Off button for 3 seconds to
switch the appliance off.
Unplug the appliance and pull the water tank out.
21
Page 22
ON
Remove the water inlet stopper and fill the water
tank with untreated tap water.
Return the water tank to its place on the appliance.
Make sure the water tank is fully set in place.
Plug in the appliance.
Switch on the appliance.
22
Page 23
OK
40s
OK
Wait until the light stops flashing (approximately
40 seconds). When the light is steady the appliance
is read y.
Put the steam trigger in the locked position.
place the product on a flat, stable, horizontal and
heat resistant surface.
Allow the appliance to run until the water tank has
completely emptied.
23
Page 24
NO
1H
8
CLEANING
Wait for approximately 1 hour for the appliance to
completely cool.
Only use a soft sponge with water to clean. Do not
use any detergent product.
Never wash or rinse appliance directly over a sink.
24
Page 25
Troubleshooting Guide
PROBLEMPOSSIBLE CAUSESSOLUTIONS
There is no steam.The appliance is not plugged in, or not
The appliance does
not heat.
Water leaks.The water tank is not fully in place or
Steam rate decreases.Calc is building up.Refer to ‘ANTI CALC section in
The steam leaves stains
on the fabric or the
appliance spits
Appliance steams
continuously.
switched on.
The water level is too low.Unplug your appliance and refill it.
The steam pump has not been primed. Press the steam trigger continuously for a
You are using the appliance for the
first time.
The water tank is not fully in place.Ensure that stopper is closed and that the
The appliance is on standby mode.PLEASE REFER TO THE ‘STANDBY’
It is not plugged in, or not switched on. Plug in your appliance and switch on.
The appliance is on standby mode.PLEASE REFER TO THE ‘STANDBY’
the stopper is not closed properly.
You are using water with additives.Never add any additive in the water tank.
The appliance has not been cleaned
enough after the descaling operation.
You are using liquids other than white
vinegar or citric acid to descale the
product.
The steam trigger is on the lock
position.
Check that your appliance is correctly
plugged in and switched on.
few seconds to begin steaming.
Press the steam trigger continuously for a
few seconds to begin steaming.
water tank clicks when put into place.
section.
section.
Ensure that stopper is closed and that the
water tank clicks when put into place.
instructions for use.
Read carefully the ‘ANTI CALC’ section in
instructions for use.
Use only white vinegar or citric acid
during ‘ANTI CALC’ procedure.
Unlock the steam trigger.
Page 26
www.tefal.com
1820000620
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.