Tefal DT8150E0 User Manual [ru]

www.tefal.com

DT81XX

ELICAT

TURB

DELICATE TURBO

* EN Depending on model

9* 10* 11*

12*

PRODUCT DESCRIPTION

1. Control panel : On/o and steam level buttons

2. Heated soleplate

3. Water tank lock

4. Continuous steam lock switch

5. Steam trigger

6. Standing base

7. Removable water tank

8. Cord exit

9*. Fabric brush

10*. Steam cover

11*. Crease Attachment

12*. Door hook

* EN Depending on model

Important safety instructions

When using your appliance, basic precautions should always be followed, including the following:

• Read all instructions before using this product.

• This product has been designed for indoor, domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.

• Always plug your appliance:

- into a mains circuit with voltage between 220 V and

240 V.

- into an earthed electrical socket. Connecting to the wrong voltage may cause irreparable damage to the appliance and will invalidate your guarantee.

• Do not use an extension lead. If you accept liability for doing so, only use an extension lead which is in good condition, has a plug with an earth connection and is suited to the power rating of the appliance.

• Completely unwind the power cord before plugging into an earthed socket.

• Use appliance for its intended use only.

• To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by holding it away from body and operating steam button.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way

and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

• Never disconnect the appliance by pulling on the power cord; instead, grasp the plug and pull to remove from the socket outlet.

• Do not allow cord to touch hot surfaces or come into contact with rough or sharp edges. Let the appliance cool completely down before putting away. Loop cord loosely around appliance when storing.

• Always disconnect appliance from the electrical supply when ﬁlling with water or emptying when cleaning, when removing or reﬁtting accessories and when not in use.

• Care should be taken when using the appliance due to the emission of steam.

• Do not operate appliance with a damaged cord or if appliance has been dropped or damaged. To avoid the risk of electric shock, do not disassemble or attempt to repair the appliance.Take it to the nearest approved service centre for examination and repair. Incorrect reassembly or repair could cause a risk of ﬁre, electrical shock or injury to persons when the appliance is used.

• Close supervision is necessary for any appliance being used by or near children.

• Do not leave the appliance unattended while plugged in or while it is still hot.

• Burns could occur from touching hot metal or plastic parts, hot water or steam. Use care when you empty a steam appliance. There may be hot water in the reservoir.

• To protect against a risk of electric shock, do not immerse the appliance in water or other liquids.

• Do not direct steam at people, animals or clothes while they are being worn.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

• The use of accessory attachments other than those provided by the manufacturer is not recommended and may result in ﬁre, electric shock or personal injury.

• The appliance must be rested on a stable surface. When placing the appliance on its base, ensure that the surface on which the base is placed is stable.

• The appliance must not be used if it has been dropped, if there are visible signs of damage or if it is leaking.

• Check the electrical power cord for sign of wear or damage prior to use. If the electrical power cord is damaged, it must be replaced at an approved service centre to avoid any danger.

• Do not use other descaling products than the one cited in the IFU.

Before first use

• When you ﬁrst use the appliance, some smoke or a harmless odour may be produced or there may be a small

discharge of particles. This will not affect the use of the appliance and will disappear quickly.

What water to use?

• Your appliance has been designed to use untreated tap water.

Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened water, rain water, ﬁltered, bottled or boiled water, water from refrigerators, batteries or air conditioners as these may damage the appliance. These types of water contain organic waste, mineral elements that become concentrated when heated and cause spitting, brown staining, leaking or premature wear on your appliance. If your water is very hard, mix 50% untreated tap water with 50% distilled water (available in hardware stores). This water contains organic waste materials or minerals that concentrate under the effect of heat and cause spitting, brown colouring or premature ageing of your appliance.

SAVE THESE INSTRUCTIONS

Environment protection first !

Your appliance contains valuable materials which can be recovered or recycled.



Leave it at a local civic waste collection point.

Problems with your garment steamer?

PROBLEM POSSIBLE CAUSES SOLUTIONS

There is no steam.

The appliance does not heat.

Water leaks.

Steam rate decreases.

The steam leaves stains on the fabric or the appliance spits

Appliance steams continuously.

The appliance is not plugged in, or not switched on.

The water level is too low. Unplug your appliance and reﬁll it.

The steam pump has not been primed.

You are using the appliance for the ﬁrst time.

The water tank is not fully in place.

The appliance is on standby mode.

It is not plugged in, or not switched on. Plug in your appliance and switch on.

The appliance is on standby mode.

The water tank is not fully in place or the stopper is not closed properly.

Scale has built up in the appliance.

You are using water with additives.

The appliance has not been cleaned enough after the descaling operation.

You are using other liquids than white vinegar to descale the product.

The steam trigger is on the lock position. Unlock the steam trigger.

Check that your appliance is correctly plugged in and switched on.

Press the steam trigger continuously for a few seconds to begin steaming.

Ensure that stopper is closed and that the water tank snaps when put into place.

PLEASE REFER TO THE ‘STANDBY’ section.

Ensure that stopper is closed and that the water tank snaps when put into place.

Refer to ‘EASY DESCALING’ section in instructions for use.

Never add any additive in the water tank.

Read carefully the ‘EASY DESCALING’ section in instructions for use.

Use only white vinegar during ‘ANTI CALC’ procedure.

ELICA

TURBO

BEFORE USE

Unlock and remove the water tank.

Remove the water inlet stopper.

Fill the water tank with untreated tap water.

Close the water inlet stopper.

+ 16 hidden pages