TeeJet STX, NH TJ, NH T90X0 User Manual

F I E L D P I L O T®
U S E R M A N U A L
Assisted Steering Hydraulic Installation Manual for Vehicle Kit Number 91-02299
Fits Only Case STX, NH TJ Series and NH T90X0 Series
(Complete list of model numbers is on page 1.)
FieldPilot
®
FIELDPILOT®
Copyrights
© 2010 TeeJet Technologies. All rights reserved. No part of this document or the computer programs described in it may be reproduced, copied, photocopied, translated, or reduced in any form or by any means, electronic or machine readable, recording or otherwise, without prior written consent from TeeJet Technologies.
Trademarks
Unless otherwise noted, all other brand or product names are trademarks or registered trademarks of their respective companies or organizations.
Limitation of Liability
TEEJET TECHNOLOGIES PROVIDES THIS MATERIAL “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED. NO COPYRIGHT LIABILITY OR PATENT IS ASSUMED. IN NO EVENT SHALL TEEJET TECHNOLOGIES BE LIABLE FOR ANY LOSS OF BUSINESS, LOSS OF PROFIT, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS, OR FOR INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OF ANY KIND, EVEN IF TEEJET TECHNOLOGIES HAS BEEN ADVISED OF SUCH DAMAGES ARISING FROM TEEJET TECHNOLOGIES SOFTWARE.
Installation Instructions for Case and New Holland Model Numbers
STX Steiger: 275,280,325,330,335,375,380,385,425,430, 435, 440, 450, 480, 485, 500, 530, 535, 375Q, 425Q, 440Q, 450Q, 500Q
NH TJ: 275, 280, 325, 330, 375, 380, 425, 430, 450, 480, 500, 530
NH: T9020, T9030, T9040, T9050, T9060
1
FieldPilot
®
PREPARATION
1. Before beginning the installation, thoroughly clean the vehicle to remove dirt and contaminants that might get into the hydraulic circuit.
2. Park the vehicle on a clean, level oor with adequate clearance to work around.
3. Do not attempt to loosen any hydraulic ttings while the engine is running.
4. Allow the motor and the hydraulics to cool until it is no more than warm to the touch before proceeding.
5. Prior to loosening any hydraulic ttings, be sure to have the appropriate plugs and caps available in order to limit loss of hydraulic uid from the open ttings.
PREVENT HYDRAULIC SYSTEM CONTAMINATION. It is essential to thoroughly clean hydraulic system ttings and hose connections prior to disconnecting or removing them. Use a spray
cleaner such as “Brake Clean” to prevent hydraulic system contamination. Note that o-rings used on ORB and ORFF type ttings may be damaged by solvent cleaners such as “Brake Clean”. If a tting is to be cleaned internally, the o-ring should rst be removed and cleaned with a berless cloth.
IMPORTANT
WARNING: HOT, HIGH PRESSURE FLUID HAZARD. Hydraulic oil may be hot and under
extreme pressure. To prevent serious injury or death, relieve system pressure and allow the
system to cool before repairing or disconnecting. Wear proper hand and eye protection when searching for leaks, using wood or cardboard instead of hands. Keep all hydraulic components in good repair.
WARNING: PINCH POINT HAZARD! To prevent serious injury or death, avoid unsafe practice
while manually operating hydraulic steering circuits. Keep others away and stay clear of
mechanical steering linkages.
TO AVOID EXCESS LEAKAGE, DO NOT TURN THE STEERING WHEEL WHILE THE FITTINGS ON THE MANUAL STEERING VALVE ARE DISCONNECTED.
2
FieldPilot
KIT CONTENTS
Unpack the installation kit and identify the required parts.
Item Part Number Description Quantity
A 32-04040 Switch, Engage/Disengage ......................................................................................1
B 350-0037 Washer, Flat - 3/8” SST ...........................................................................................6
C 35-02187 Valve, FieldPilot, PWM, 7.9GPM, CC ......................................................................1
D 45-05396 Cable, Power 3 POS AMP To 3-2 POS WP ............................................................1
E 45-07703 Harness, SCM .........................................................................................................1
F 45-10103 Harness, Valve .........................................................................................................1
G 60-04089 Bolt, Hex- 3/8-16 x 3-3/4” SST .................................................................................2
H 60-07027 Nut, NyLock 3/8-16, SST .........................................................................................6
I 60-04087 Bolt, Hex- 3/8-16 x 3-1/4” SST .................................................................................4
J 65-05216 Bracket, FieldPilot Valve, Case STX, Part 1 ............................................................1
K 65-05217 Bracket, FieldPilot Valve, Case STX, Part 2 ............................................................1
L 68-01227 Hose, Hydraulic - 1/2” x 185”, #8FORF x #8FJIC 90º ..............................................2
M 68-01228 Hose, Hydraulic - 1/2” x 82”, #8FJIC x #12FJIC 90º ................................................1
N 68-01229 Hose, Hydraulic - 1/2” x 82”, #12FJIC x #12FJIC 90º ..............................................1
O 68-01230 Hose, Hydraulic - 3/8” x 86”, #6FJIC x #6FORF 90º ................................................1
P 68-02012 Hydraulic Load Shuttle Tee- #6FORB ...................................................................... 1
Q 68-02026 Adapter, Hydraulic Run Tee - #8ORF ......................................................................2
R 68-02051 Adapter, Hydraulic 90º - #12MJIC x #12FJIC .......................................................... 2
S 68-02052 Adapter, Hydraulic 90º - #12MJIC x #12MORB .......................................................1
T 68-02073 Adapter, Hydraulic - #6MORF x #6MORB ...............................................................2
U 68-02093 Adapter, Hydraulic 90º - #8MJIC x #8FJIC .............................................................. 1
V 68-02094 Adapter, Hydraulic - #8MJIC x #8MORB .................................................................3
W 68-02110 Adapter, Hydraulic - #6FORF x #6MORB ................................................................1
X 68-02145 Adapter, Hydraulic - #12MJIC x M27-2.0 M .............................................................2
Y 68-02173 Adapter, Hydraulic. 90º - #6MJIC x #4MORB ..........................................................1
Z 90-02472 Kit, Patch Antenna Extension 10’ .............................................................................1
®
3
FieldPilot
®
AA 90-50013 Cable Tie Kit, 15 ......................................................................................................2
BB 91-07011 Steering Wheel Switch Kit .......................................................................................1
CC 91-00022 Kit, Articulated Gyro Module ....................................................................................1
DD 98-05103 Installation Manual, Case STX, NH TJ Series and NH T90X0 Series .....................1
Item Part # Description Illustration
A 32-04040 Switch, Engage/Disengage,
Momentary
B 350-0037 Washer, Flat - 3/8” SST
C 35-02187 Valve, FieldPilot, PWM,
7.9GPM, CC
D 45-05396 Cable, PWR 3 POS AMP To
3-2 POS WP
E 45-07703 Harness, SCM
F 45-10103 Harness, Valve
G 60-04089 Bolt, Hex- 3/8-16 x 3-3/4”
SST
4
45-05396 DC: xx/xx
Switched +12v
45-10103 DC:xx/xx
SCM Power I/O
45-07703 DC: xx/xx
Power Cable
Power Cable
Power Cable
Power
Valve Output
A
B
Item Part # Description Illustration
H 60-07027 Nut, NyLock 3/8-16, SST
I 60-04087 Bolt, Hex- 3/8-16 x 3-1/4”
SST
J 65-05216 Bracket, FieldPilot Valve,
Case STX, Part 1
K 65-05217 Bracket, FieldPilot Valve,
Case STX, Part 2
L 68-01227 Hose, Hydraulic - 1/2” x
185”, #8FORF x #8FJIC 90º
FieldPilot
®
M 68-01228 Hose, Hydraulic - 1/2” x 82”,
#8FJIC x #12FJIC 90º
N 68-01229 Hose, Hydraulic - 1/2” x 82”,
#12FJIC x #12FJIC 90º
O 68-01230 Hose, Hydraulic - 3/8” x 86”,
#6FJIC x #6FORF 90º
P 68-02012 Hydraulic Load Shuttle Tee-
#6FORB
5
FieldPilot
Item Part # Description Illustration
Q 68-02026 Adapter, Hydraulic. Run Tee
R 68-02051 Adapter, Hydraulic. 90º -
S 68-02052 Adapter, Hydraulic. 90º -
®
- #8 ORF
#12MJIC x #12FJIC
#12MJIC x #12MORB
T 68-02073 Adapter, Hydraulic. -
#6MORF x #6MORB
U 68-02093 Adapter, Hydraulic. 90º -
#8MJIC x #8FJIC
6
Loading...
+ 16 hidden pages