TeeJet SmartPad II User Manual
Bulletin 98-01123 R1
! IMPORTANT NOTICE !
Status Detect Revision for SmartPad II
“BLUE WIRE - Input 2”
Who will this affect?
1. Any operator using the SmartPad II and an existing switch in the cab to signal to the SmartPad II
that application has begun (Status Detect).
2. When Upgrading an existing Swath XL or Guideline system to the SmartPad II the operator will
need to Switch from the green wire to the BLUE wire for status detect.
How to use Status Detect
1. When using an existing switch in the cab to signal to the SmartPad II that application has begun, two
things must be done.
• On the SmartPad, under the guidance setup menu the Status Detect option must be
set to 1 Section. See Page 2 of this bulletin for Status Detect setup to 1 Section.
• See diagram below. When Status Detect is set to 1 Section 12v+ must be supplied to
Input 2 when applying. Connect Input 2 (Blue Wire) to the switched12v+ side of the
master switch (status switch) when the implement is applying.
WHEN STATUS DETECT IS ON
12v+ MUST BE SUPPLIED TO
INPUT 2 WHEN APPLYING
Fieldware for SmartPad II v 4.02 Important Notice
Bulletin 98-01123 R1 Page 1 of 2
12v+
(NOT USED) INPUT 1
T
HIF
S
D
N
2
RL
CT
T
L
A
H
C
G
P
A
C
S
O
L
W
A
B
T
DER
+V
NEERG
1
EULB
2
POWER
SMARTPAD
INTERFACE
®
5 Amp
1. From the Main Launcher page (first screen after powering on) select Guidance by highlighting and
pressing the enter key or by using the touch screen and touch guidance.
2. The next screen is the Start Guidance / Setup screen. Select Setup to advance to the Guidance,
Data, and Lightbar setup selections, select Guidance to bring up the guidance setup options.
3. The final step is to select Status Detect from the setup options. Use the down arrows to scroll and
find Status De tect. Status Detect has two settings, Of f an d 1 Section . Sele ct Status detect and u se the
Up and Down arrows on the SmartPad to select between OFF and 1 Section, press the enter key to
accept the selection.
Bulletin 98-01123 R1 Page 2 of 2
Loading...