TeeJet RX375P User Manual

INSTALLATION

RX375P RECEIVER

INSTALLATION AND SPECIFICATIONS

Mounting Considerations

1. When mounting the RX375P Receiver, a space of at least 6 inches (15 cm) between the receiver and any bend in the cable is required. Any length shorter than 6 inches puts undue stress on the cable and the enclosure for the RX375P.

2. The Receiver should not be mounted where water can pool around it. The receiver housing is designed to withstand rain and splashing, but not submersion in liquids for sustained periods of time.

3. Mount the receiver above all other metal objects to avoid multipath. Satellite signals received by the GPS

receiver by a reection from an object can decrease

positioning accuracy. For example, roof racks, large headlight enclosures, etc., can cause multipath that may result in a jump in GPS position.

Mount antenna at a minimum of 6 inches (15 cm) before applying a bend to the cable

RX375P Receiver Installation

1. Make sure the surface of the vehicle is clean, dry, and free of dust particles.

2. To magnetically mount the RX375P, attach the black magnetic base unit to the underside of the receiver and mount it to a metal surface.

3. To mount the receiver to a berglass surface, remove the adhesive pad and attach it to the vehicle. Adhere the metal disk to the other side of the

adhesive pad, holding rmly in place for 10 seconds to ensure a secure

connection. Magnetically mount the RX375P to the disk.

5.7 inches / 14.5 cm

4.1 inches / 10.4 cm

LED Status Indicator Red - power is ON Amber - GPS lock Green - DGPS solution

Deutsch connector

Port A: 4800 GGA 1Hz VTG 1Hz

Port B: 19200 GGA 5Hz VTG 1Hz

www.teejet.com

SPECIFICATIONS

INSTALLATION

Calibration Numbers

TeeJet Technologies Typical Speed Products Calibration Number

Radion .......................................................................................................... 8590

IC18 .............................................................................................................. 8590

Legacy PCM/DCM ........................................................................................ 1064

TASC/ARC ......................................................................................1064

TeeJet 844/854/834 .............................................. 859 (With RAD “ON”)

LH 70 Series ................................................................................... 8590

LH 85 .............................................................................................. 8590

LH 500 Series ................................................................................. 8590

LH 5000 .......................................................................................... 8590

LH 6000 .......................................................................................... 8590

LH IC 24 ....................................................8590 or 1.064 cm per pulse*

LH IC 34 ......................................................................................... 8590

* Depending on the application can operate in Autonomous Mode

Electrical Connection Specications

Deustch Connector’s Pin-outs

1. Manual mark in

2. TxB

3. RxB

4. CAN high

5. Signal Ground

6. TxA

7. One PPS

8. RxA

9. CAN low

10. Power in (12V)

11. Power Ground

12. Speed out

GPS Sensor Specications

Receiver Type .....................L1, C/A code with carrier phase smoothing

...(Patented COAST technology during differential signal outage)

Channels ................................................... 12-channel, parallel tracking

................................... (10-channel when tracking SBAS) (WAAS)

Update Rate .............................................................1 - 20 Hz Positions

Horizontal Accuracy ............ < 2.0 ft / 60 cm 95% condence (DGPS)¹ *

............. < 8.2 ft / 2.5 m 95% condence (Autonomous, no SA)² **

Differential Options ........... SBAS (WAAS, EGNOS, MSAS), e-Dif, L-Dif

SBAS (WAAS) Tracking...............................2-channel, parallel tracking

Start Up Time.........................Cold Start: < 60 s (no almanac and RTC)

.........................................Warm Start: < 30 s (almanac and RTC)

................... Hot Start: < 10 s typical (almanac, RTC and position)

Satellite Reaquisition ...................................................................... < 1 s

* Depends on multipath environment, number of satellites in view, satellite

geometry, baseline length (for local services), and ionospheric activity.

** Depends on multipath environment, number of satellites in view, satellite

geometry, and Ionospheric activity.

Communication Specications

Serial Ports ............................................................ 2 Full Duplex RS232

CAN .................................................................... NMEA 2000 broadcast

Pulse Output .................... 1 PPS (CMOS, active low, falling edge sync)

Baud Rates ...................................................................... 4800 - 115200

Differential Correction I/O Protocol .......................... RTCM SC-104 v2.x

Data I/O Protocol ..................NMEA 0183, SLX Binary and NMEA 2000

Ground Speed Output

Range: ...............................................0.5 -> 200 mph / 0.8 -> 322 km/h

Signal: .................................................................................... Pulse Out

Frequency Conversion: ..........................................................94 Hz/m/s

.................................................... (28.65 Pulse Per Foot Traveled)

Event Mark Output ................................................... CMOS, Active Low,

..................................... Falling Edge Sync, 10 K-ohm, 10pF Load

Part Numbers

Kits and Components

45-05495 Cable, RX370P or RX375P Speed Only 45-05338 Cable, GPS Data w/12 position Deutsch 45-05496 Cable, RX370P or RX375P DB9, Speed, Power 45-05340 Cable, Deutsch to DB9 45-05350 Cable, Com 1 & 2 w/Power In 78-50203 Receiver, GPS RX375P SBAS

Environmental Specications

Operating Temperature .........................-22°F - +158°F / -30°C - +70°C

Storage Temperature ............................-40°F - +185°F / -40°C - +85°C

Humidity ...............................................................95% Non-Condensing

Enclosure .......................................................Waterproof and Dustproof

Compliance ...............................................................................FCC, CE

Shock ................................................EP455 Section 5.14.1 Operational

Vibration ................................................EP455 Section 5.15.1 Random

EMI Certication ...................CE (ISO 14982 Emissions and Immunity),

.................................................................................. FCC Part 15,

..................................................................... Subpart B, CISPR 22

Power Specications

Input Voltage......................................................................... 7 - 32 VDC

Power Consumption .......................................< 3 W @ 12VDC (typical)

Current Consumption .................................. 249 mA @ 12VDC (typical)

Power Connector .................. Cable Mount and Environmentally Sealed

Physical Specications

Height .............................................................................4.1 in / 10.4 cm

Width ..............................................................................5.7 in / 14.5 cm

Weight .........................................................................<19.7 oz /<558 g

Mounting Options ..........................................................Magnetic Mount

........ Fixed Mount (5/8 inch or no. 8-32 screws); 1" mounting hole

TeeJet Technologies 1801 Business Park Drive

Springeld, Illinois 62703 USA

www.teejet.com

TeeJet RX375P User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual