DigiScan DS-02
Portable Digital Image Scanner
User Manual
The Declaration of Conformity for this device is under the Internet link: www.technaxx.de/
(in bottom bar “Konformitätserklärung”); Before using the device the first time, read the user manual carefully.
Features
Portable, high-resolution scanner for negative filmes and slide films
High brilliance of colour (white balance & exposure compensation are automatically)
5 megapixle CMOS sensor
2.4" TFT display
SD / SDHC card slot up to 32GB
USB 2.0 interface (high speed)
Usable as stand alone device
Also usable with PC [Windows XP + Windows Vista, Win7 + Win8 (32/64 bit)]
Small, light-weight, handy and easy to use
1. Description of Parts
Positive Slide Holder
135-Negative Film Holder
Rapid Slide Feeder
Cleaning Brush
Note: Place the scanner on its side and slide the end of the brush into the opening on the right side. Then you can clean the backlight panel placed in the film scanner.
2. Using the included Holders
Place the rapid slide feeder, like shown in the picture, into the FILM HOLDER SLOT.
Push the lever towards the left, then pull the lever back to the right again to load a slide from the feeder. Repeat this step for subsequent slides (which will push the used slides out the other side).
Loading Slides
Hold up the slide toward the light. Face the trademark slide of the slide away from you. The slide should not appear as a mirror image, but „normal“. Turn the the slide on it’s head (but it still need to be shown the same side).
Open the slide holder at the marked spot on the top (OPEN). Insert the slide into the holder so that it fits perfectly.
Close the slide holder and press the edges so that it locks in place. Hold the slide holder as shown in the picture (you see the front page) and insert the Slide Holder into the slot on the right side of the scanner. Note: Dust, scratches or finger prints will show up on your saved images.
Loading Negatives
Hold up the negative toward the light. As you look through the negative, you should be able to read the small negative numbers normally (not a mirror image). Turn the the negative on it’s head (but it still need to be shown the same side).
Open the negative holder at the marked poin (OPEN). With the negative holder laid open place the negative into holder so that the notches of the negative are aligned with the notches in the holder. Close the negative holder and press the edges so that it locks in place. Insert the negative holder into the slot on the right side of the film scanner, like shown in the picture.
Loading...