TCL 65Q825, 75Q825 User Manual

Hi! Let’s get started.

8-Series

65Q825/75Q825

DO NOT RETURN TO STORE

TCL SUPPORT:

http://support.tclusa.com/

1-877-300-9509

WE ARE READY TO HELP

TAKE CARE WHEN REMOVING THE TV

Important Information

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

Caution: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts

This symbol indicates “dangerous voltage” inside the product that presents a risk of electric shock or personal injury.

inside. Refer servicing to qualiﬁed service personnel.

WARNING

To reduce the risk of ﬁre or electric shock, do not expose this product to rain or moisture. This product should not be exposed to dripping or splashing. No objects ﬁlled with liquids, such as vases, should be placed on the apparatus.

This symbol indicates that this product incorporates double insulation between hazardous main voltage and user accessible parts. When servicing, use only identical replacement parts.

This symbol indicates important instructions accompanying the product.

WARNING

The TV is unstable if it is not properly attached to the base or mounted to the wall. Please follow the base or wall mounting instructions provided in the User’s Guide to ensure your safety.

Warning: The batteries shall not be exposed to excessive heat such as sunshine, ﬁre or

the like. proper operating

Cable TV Installer:

National guidelines for proper connected to the grounding system of the building as close to the point of cable entry as practical.

Important:

place the unit will ventilation for this receiver and 2 inches from the

Also, make sure the stand or base you use is of adequate size and strength to prevent the TV from and/or damage Power button on this TV and your remote control puts the TV into a very low-power standby power o, you will plug/appliance coupler is used to turn o the device, you should install the power cord when desired.

Product Registration

Please register your TCL TV purchase on-line at www.tclusa.com. It will make it easier to contact you

Refer to the identiﬁcation/rating label located on the back panel of your product for its

voltage.

Electrical Code (Section 54 of the Canadian Electrical Code, Part 1) which provides

This television is a table model and is designed to sit on a ﬁrm, ﬂat surface. Don’t

the TV on soft carpeting or similar surface because the ventilation slots on the bottom of

be blocked, resulting in reduced lifetime from overheating. To assure adequate

being accidentally tipped over, pushed o, or pulled o. This could cause personal injury

mode but will not completely turn the power o. In order to completely shut the

should it ever be necessary. Registration is not required for warranty coverage.

This reminder is provided to call your attention to Article 820-40 of the

grounding and, in particular, speciﬁes that the cable ground should be

product, maintain a spacing of 1 inch from the top and side of the TV

to the TV. Refer to the Important Safety Instructions on the next page.

need to disconnect the power cord from the outlet. The mains

rear of the TV receiver and other surfaces.

completely turn o the device. If you prefer to completely

TV in a manner that allows you to disconnect the

The

Product Information

Keep your sales receipt to obtain warranty parts and service and for proof of purchase. Attach

and record the serial and model numbers in case you need them. These numbers are

it here located on the Warning: Changes or modiﬁcations to this unit not expressly approved by the party respons ble for apparatus at least 8

product.

compliance could void the user’s authority to operate the equipment. Keep the

inches away from the human body.

Input Signal Compatibility

Antenna/Cable Composite Video HDMI

For the best viewing experience, remove the energy guide label from the TV front panel or TV screen

before use.

Model No.

Purchase Date

480i, 480p, 720p, 1080i (NTSC, ATSC, and QAM formats) 480i 480i, 480p, 720p/60Hz, 1080i/60Hz, 1080p/60Hz, 2160p/24/30/60Hz

Serial No.

Dealer/Address/Phone

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus

(including

Protect the power cord from being walked on or pinched particularly at plugs, convenience

receptacles,

10. information

11. remain

12. When not in use and during movement, please take care of the power cordset, e.g. tie up the power like that can the power cordset person to replace the power characteristics as the original one.

13. No naked ﬂame sources, such as lighted candles, should be placed on the apparatus.

14.

Unplug this apparatus during lightning storms or when unused for long periods of time.

15. Only use attachments/accessories speciﬁed by the manufacturer.

16. Use only with the cart, stand, tripod, bracket, or table speciﬁed by the manufacturer,

or sold with the apparatus. When a cart is used, use caution when moving the

cart/apparatus combination to avoid injury from tip-over.

17. Refer all servicing to qualiﬁed service personnel. Servicing is required when the apparatus has been spilled or objects moisture, does not operate

18. For safe operation of the apparatus, observe these installation requirements: inches of ventilation space between the rear cover of the apparatus and the wall. least 1 inch of ventilation space between the apparatus and all other surfaces. Do not allow any of the apparatus’ ventilation openings to be blocked by objects that might obstruct them, such apparatus to any external on the apparatus. Do not expose of moisture. When disposing of used regulations regarding proper disposal.

19. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system charges. Section Canadian Electrical Code, mast and supporting structure, of grounding conductors, location of and requirements for the grounding electrode.

See following example:

ampliﬁers) that produce heat.

and the point where they exit from the apparatus.

WARNING: Please refer the information on exterior bottom enclosure for electrical and safety

before installing or operating the apparatus.

WARNING: The mains plug is used as disconnect device, the disconnect device shall

readily

operable.

cordset with cable tie or something like that. It shall be free from sharp edges and the

cause abrasion of the power cordset. When put into use again, please make sure

being not damaged. If any damages found, please look for the service

cordset speciﬁed

by the manufacturer or have the same

damaged in any way, such as power-supply cord or plug is damaged, liquid has been

have fallen into the apparatus, the apparatus has been exposed to rain or

normally, or has been dropped.

Keep at least 2

Keep at

as newspapers, curtains, table-cloths or any other objects. Do not expose the

heat sources. Do not place any heat sources such as candles, lamps, etc.

the device to high levels of humidity or to any possible sources

batteries

from the remote control, consult local

is grounded so as to provide some protection against voltage surges and built-up static

810 of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of

Part 1) provides information with respect to proper grounding of the

grounding of the lead in wire to an antenna-discharge unit, size

antenna discharge unit, connection to grounding electrodes,

ELECTRIC SERVICE EQUIPMENT

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PARTH)

This product incorporates HDMI technology.

The terms HDMI, HDMI High-Deﬁnition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Manufactured under license from Dolby Laboratories.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit dierent from that to which the receiver is

connected.

● Consult the dealer or an experienced radio/TV technician for help. This Class B digital apparatus complies with Canadian ICES-003. 8-series, include models (65Q825/75Q825) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)

This device must accept any interference received, including interference that may cause

operation. Supplier Name: TTE Technology, Inc. (dba TCL North America) Supplier Address: 1860 Compton Ave, Corona, CA 92881, USA Supplier phone number and internet contact information: 1-877-300-9509, http://support.tclusa.com/

Battery Caution & Disposal Information

1. For best results, use alkaline type batteries.

2. Install only new batteries of the same type in your product.

3. Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten

the life of the batteries or cause batteries to leak.

4. Do not mix old and new batteries.

5. Do not use Rechargeable (Nickel Cadmium or Nickel Metal Hydride) batteries.

Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium or Nickel Metal

Hydride) batteries.

7. Batteries should be recycled or disposed of as per state and local guidelines.

8. Do not dispose of batteries in ﬁre.

undesired

ELECTRONICS RECYCLING INFORMATION FOR CONSUMERS

TCL strives to provide a high level of service to our customers and in the communities we serve, and recommends that consumers always look for a recycling or reuse alternative to throwing away televisions and other electronics. We encourage customers to recycle end-of-life electronic devices using one of the many convenient methods available today. In many states TCL has programs in place to enable consumers to drop-o and recycle televisions free of charge. For information on electronics recycling in all 50 states, including drop-o locations, please visit the "Electronics Recycling" area of the TCL USA website at www.tclusa.com

+ 11 hidden pages

TCL 65Q825, 75Q825 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual