Targus ACW10US Quick Start Manual

wifi scout
hot spot locator

Introduction

Congratulations on your purchase of the Targus WiFi Scout. Radio frequency signals are, by their nature, variable in strength and coverage.
This small and compact device helps you identify the best place for accessing the wireless Internet.

Fe at u re s

• Locate hotspot (2.4GHz, 802.11b/802.11g Wireless Internet Access Point) without opening your notebook computer

• Quickly locate hotspots up to 160 feet away

• Easy operation - Just push one button to activate the 60-second detection process

• Easy-to-read indicators displays the area's signal strength

• Small, lightweight design that can be carried on a keychain

Using the WiFi Scout

Press the button once and the device will begin searching for the WiFi signal. After a few seconds, observe the signal as per the
indications below:

› Red LED keeps FLASHING - There is little or no (802.11b/802.11g) wireless signal detected. This signifies

that the area you are in is not favorable for wireless Internet connection.

› Red LED stays ON - A weak wireless signal is detected. This is a sign that a wireless connection may be

possible, but it may not be stable.

› Both Red and Yellow LEDs stay ON - A good wireless signal is detected. This implies that the area is favor-

able for accessing a wireless Internet connection.

› All three Red, Yellow & Green LEDs stay ON - A strong wireless signal is detected. This indicates that you

are situated in an area that is ideal for accessing a wireless Internet connection.

Once the button is pressed, the WiFi Scout will search for one minute. After this timeframe the WiFi Scout will automatically stop detection.

NOTE: A strong signal does not indicate the network is open and publicly accessible. The network could have WEP, WPA, or
other methods of security enabled that could prevent access.

Replacing the Batteries

If the detection distance is weaker than usual, this may indicate that the batteries need to be replaced. To open the battery cover, remove the screws at the back.

NOTE: The detection distance may vary according to environmental differences. The signal strength displayed by the wireless
connection monitor on your PC will not necessarily match the signal strength indicated by the WiFi Scout. Your PC can detect
WiFi signals at a greater range than the WiFi Scout.

For best performance, please hold the unit from one corner to allow the internal antenna a clear path.

Technical Support

For technical questions, please visit:

US

Internet: www.targus.com/support.asp

Australia

Internet: www.targus.com.au
Email: [e-mail]
Telephone: [phone]

New Zealand

Telephone: [phone]

Product Registration

Targus recommends that you register your Targus accessory shortly after
purchasing it. Go to: http://www.targus.com/registration.asp
You will need to provide your full name, email address, phone number, and
company information (if applicable).

Warranty

Targus warrants this product to be free from defects in materials and
workmanship for one year. If your Targus accessory is found to be defective
within that time, we will promptly repair or replace it. This warranty does not
cover accidental damage, wear and tear, or consequential or incidental loss.
Under no conditions is Targus liable for loss of, or damage to a computer;
nor loss of, or damage to, programs, records, or data; nor any consequential
or incidental damages, even if Targus has been informed of their possibility.
This warranty does not affect your statutory rights.

Regulatory Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.

FCC Statement

Te s te d t o C o mp l y

This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna;

• Increase the separation between the equipment and receiver;

• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected;

• Consult the dealer or experienced radio/TV technician for help.

ACW10US/410-0005-001A

All trademarks and registered trademarks are the property of their respective owners. Features and specifications
subject to change without notice. © 2006, Targus Group International, Inc. and Targus, Inc., Anaheim, CA 92806 USA.

Quick Start