TMAC70 Hand-Held Control Head
Introduction
The TMAC70 is a hand-held control head
for TM9100 radios that enables the user to operate
the radio at a distance from the radio body.
The hand-held control head plugs into one of the
RJ45 sockets on the TMAC34-1T remote control
head. The TMAC34-1T remote control head is
installed as part of the TMAA03-08 enhanced
remote kit.
A TMAA10-03 remote speaker (for 25W radios) or
TMAA10-06 remote speaker (for 40/50W radios)
is required when a hand-held control head is used.
Tait accessories
Installation Instructions
Channel 12
Zone 11
Menu
Talkgr
Note: The hand-held control head cannot be used
with the TMAA03-25 remote kit.
Operation
The keys and controls work in the same way as those on the standard control head,
with the exception of the PTT and volume up and down keys. The hand-held
control head also has two additional function keys.
Turning the radio on
Press either the on/off key or the PTT key.
Turning the radio off
Press the on/off key for about half a second.
Adjusting the volume
Press the key to increase the speaker volume and
the key to decrease the volume.
+
_
on/off key
PTT key
volume
402-00042-00 www.taitworld.com
Installation
Installation of the hand-held control head involves:
■ Plugging the control-head cord into either
socket on the TMAC34-1T remote
control head.
TMAA10-03 or
remote speaker
TMAA10-06
■ Installing the control-head mounting clip.
TMAC34-1T
TMAC70
Installing the hand-held control head
Important:
The hand-held control head grommet must be installed whenever the control head
is plugged into the RJ45 socket. When installed, the grommet has two functions:
■ to prevent damage to the control-head socket when there is movement of the
control-head cord, and
■ to ensure that the control head is sealed against water, dust and other
environmental hazards.
1. Make sure the radio is turned off, then plug the control-head cord into either of the
RJ45 sockets on the TMAC34-1T remote control head.
2. Slide the control-head grommet along the control-head cord and push two adjacent
corners of the grommet into the control-head socket cavity.
3. Squeeze the grommet and push the remaining corners into
position.
4. Check that the grommet is seated correctly in the cavity.
Installing the mounting clip
Install the mounting clip in the most convenient location for the radio user. It must be within
easy reach of the user, but in such a position that the hand-held control head PTT key cannot
be inadvertently activated or jammed on.
Radio Programming
Note: The radio must be programmed with the hand-held control head installed.
1. Use the tool provided in the TMAC70 kit or an 8 mm AF
Allen key to remove the rear programming connector cover.
2. Connect a PC to the programming connector and use the
TM9100/TP9100 programming application to program
the radio.
3. Assign functions to Key 1 to Key 6 of the hand-held control head, if required (Function Ctrl Settings form).
Refer to the online help of the programming application for
more information.
More Information
Refer to your radio provider for more information about this product.
2 TMAC70 Hand-Held Control Head
© Tait Electronics Limited December 2006
Loading...