402-00035-00 www.taitworld.com
Tait accessories
TMAA10-07
Desktop Microphone
Installation Instructions
Introduction
The TMAA10-07 desktop microphone is
an omnidirectional dynamic microphone
which can be used in dispatch situations,
where the microphone is positioned on a
flat surface. The desktop microphone
plugs into the microphone socket on the
radio control head.
The desktop microphone has an internal
pre-amplifier and an adjustable output
control on the underside of the desktop
microphone base.
Operation
Hold down the MONITOR key and check
whether the channel is clear.
If the channel is clear, press the
TRANSMIT key (PTT) to transmit. Speak clearly into
the microphone and release the
TRANSMIT key when you have finished talking.
Note: The MONITOR key can be locked in the ‘on’ position. To do this, hold the
MONITOR key down and slide the LOCK key towards you. The MONITOR key
should now be locked on.
Installation
Important: The desktop microphone grommet must be installed whenever the
desktop microphone is plugged into the microphone socket. When installed,
the grommet has two functions:
■ to prevent damage to the microphone socket when there is movement of the
microphone cord, and
■ to ensure that the control head is sealed against water, dust and other
environmental hazards.
TRANSMIT
key
grommet
T
R
A
N
S
M
I
T
M
O
N
I
T
O
R
LOCK
key
MONITOR
key
2 TMAA10-07 Desktop Microphone
© Tait Electronics Limited January 2006
1. Plug the microphone cord into the microphone socket on the radio control head.
2. Slide the grommet along the cord and push two adjacent corners of the grommet
into the microphone socket cavity.
3. Squeeze the grommet and push the remaining corners into position.
4. Check that the grommet is seated correctly in the cavity.
Adjustment
Adjust the output level of the desktop microphone using the
control accessible from the underside of the desktop
microphone.
The microphone sensitivity is set to maximum by turning the
control fully clockwise.
Radio Programming
The desktop microphone has an internal pre-amplifier.
Therefore, the dynamic microphone support in the
UI Preferences form of the radio’s programming application
should not be enabled.
More Information
Refer to your radio provider for more information about this product.
Correct desktop microphone grommet seating
microphone
grommet
control head
adjust output level here
Loading...