TMAA01-05 and TMAA01-07 Options
Installation parts
internal
options loom
D-range hood parts
D-range plug
external options
connector
internal options connector
options extender board
external options
cover seal
Extender Boards
Installation Instructions
The TMAA01-05 and TMAA01-07 options extender boards
provide external access to most of the signal lines provided
by the radio’s internal options connector.
The options extender board fits inside the radio in the options
cavity and is connected to the main PCB by the internal
options connector and loom.
The internal options connector signals are then made available
on the high-density 15-way D-range connector mounted on
the options extender board. This connector fits through the
external options connector hole provided in the radio chassis.
Notice The radio does not meet the IP54 protection
standard once an options extender board has been
installed unless the external options cover seal is
installed.
Installation Warning
Notice This equipment contains devices that are susceptible to static charges. The pro-
cedures outlined in this installation guide should therefore be carried out in a static-safe
environment. You can obtain information on antistatic precautions and the dangers of
electrostatic discharge (ESD) from standards such as ESD S4.1-1997 (revised) or BS EN
100015-4 1994. The Electrostatic Discharge Association website is
http://www.esda.org/.
Installing an Options Extender Board
Parts Required
The following table describes the parts required to install an options extender board in a radio.
The parts marked with an asterisk (*) are not shown in the diagram and are used to connect
to the radio’s ex ternal o ptions c onnecto r.
© Tait International Limited August 2018
www.taitradio.com
402-00008-05
Parts required for installation
e
h
i
1@
b
c
1!
j
1)
d
f
g
Quantity Internal Part Number Description Reference
1 362-01111-XX
1 362-01108-XX
2 347-00011-00 4-40x3/16 screws
2 354-01043-00 screw-lock fasteners
6 349-02062-00 M3x8 screws
1 240-00010-80 D-range plug
*
1 240-06010-29 D-range hood
*
a.Contact Technical Support for the exact IPN (Internal Part Number).
Options extender board installation
a
a
foam seal
cover seal
d
1!
1@
h
j
—
—
b
c
d
e
f
g
2 TMAA01-05 and TMAA01-07 Options Extender Boards
radio lid
external options connector bung
foam seal
external options connector cavity
options extender board
external options connector
screw-lock fasteners
h
mounting posts
i
M3x8 self-tapping screws
j
internal options loom
1)
external options cover seal
1!
4-40x3/16 screws
1@
© Tait International Limited August 2018
Loading...