Synology DS107, DS108j Quick Installation Guide

Disk Station

DS107+, DS107, DS108j

Quick Installation Guide

SAFETY INSTRUCTIONS

Please read these safety instructions carefully before use, and keep this manual in
a safe place for your future reference.

Keep away from
direct sunlight
and away from
chemicals. Make
sure the
environment
does not
experience
abrupt changes
in temperature or
humidity.

Do not place the
Synology product
on a cart, table,
or desk, which is
not stable to
avoid the product
from falling over.

Do keep
Synology product
upright. Do not
lay it down
horizontally.

The power cord
must plug in to
the right supply
voltage. Make
sure that the
supplied AC
voltage is correct
and stable.

Do not place the
Synology product
close to any
liquid.

There are slots on the button of
Synology product for ventilation. To
make sure Synology product is
operating under normal condition,
please do not block or cover those
slots to avoid the product from
overheating.

Before cleaning,
unplug the power
cord first. Wipe
Synology product
with damp paper
towels. Do not
use chemical or
aerosol cleaners
to clean it.

1

PACKAGE CONTENTS

Before you begin, please check the package content s to verify that you have
received the items below.

Main Unit X 1 Installation CD AC power adapter

2M RJ-45 LAN cable AC power cord

Assembling Kit

Screws for
fixing Hard
Disk X 6 (1
spares)

* Not included in the cable-less models.

Screws for
fixing the
Synology Case
X 3 (1 spare)

HDD Data
Cable* X 1

HDD Power
Cable* X 1

2

INSTALL HARD DISK

Disk Station requires one 3.5” SATA hard disk for installation. Refer to the following
steps for details:

Warning! If you use a hard disk with data on it to install, system will format the
hard disk and erase all data in some cases. Please back up the data if you
need it in the future.

1. Connect the HDD Data Cable and HDD Power Cable to the hard disk. (Not
included in the cable-less models.)

2. Place the server horizontally on a desk. The rear panel sho uld be facing you.

3. Push to slide away the upper case.

3

4. Pull up the upper case.

5. Place the hard disk inside the HDD bay.

4