Symmons S-9603-PLR User Manual

Page 1
CG
S-9603-PLR Hand Shower System
Specification Submittal
Location:
®
Origins
Specification
Hand shower system powered by the Temptrol® Pressure Balancing valve with integral volume control. Hand shower system shall include adjustable stop screw to limit handle turn, 36" slide bar, in-line vacuum breaker, 60" exible metal hose, ADA hand shower and standard
2.5 gpm (9.5 L/min) ow restrictor. Components shall be made from metal and nonmetallic construction, plated in standard polished chrome nish.
Model Numbers
S-9603-PLR
Origins hand shower system
S-9603-PLR-TRM
Origins hand shower, trim only
S-46-1-BODY
Temptrol Pressure Balancing shower valve body
S-46-1X-BODY
Temptrol Pressure Balancing shower valve body with stops
Finish Options
-STN
Satin Nickel finish
Compliance
-ASME A112.18.1/CSA B125.1
-WaterSense 1.5 gpm (5.7 L/min)
2.0 gpm (7.6 L/min)
Certied by CSA Group
Warranty
Limited Lifetime - to the original end purchaser in
consumer/residential installations. 5 Years - for industrial/commercial installations. Refer to www.symmons.com/warranty for complete warranty information.
Modifications
1.5 gpm (5.7 L/min) ow restrictor
☐ ☐ ☐ ☐
☐ ☐ ☐ ☐
☐ ☐
☐ ☐ ☐ ☐ ☐ ☐
☐ ☐
-1.5
-2.0
-72
-ADAHS
-B
-B30
-B48
-CHKS
-D
-H321-V
-H323-V
-IPS
-LAM
-LP
-L/HS
-OP
-QD
-R
-REB
-REV
-T724
-T748
-VB
-VP
-X
2.0 gpm (7.6 L/min) ow restrictor
72" hose in place of 60" hose
ADA hand shower wand (white) Brass escutcheon (chrome only) 30" slide bar in place of 36" grab bar 48" slide bar in place of 36" grab bar Integral check stops - for use in installations
where a positive shut-off device is used downstream of mixing valve Brass dome cover (chrome only)
1 mode hand shower unit with slide bar in place of standard hand shower unit
3 mode hand shower unit with slide bar in place of standard hand shower unit
1/2" female IPS connections
Lever handle
Loop handle
Less hand shower
13" oval plate (PLR only)
Quick-disconnect on hand spray units
60" white vinyl hose in place of 60" metal hose
Rebuild trim kit, includes TA-10 and TA-4
Reverse coring, hot on right, cold on left, for back to back installations
24" slide bar/grab bar with ADA hand shower in place of standard hand shower unit
48" slide bar/grab bar with ADA hand shower in place of standard hand shower unit
Elevated vacuum breaker Vandal resistant escutcheon screws in place of
standard screws Integral service stops - allows water shutoff at valve for service
Note: Append appropriate -sufx to model number.
Page 2
Dimensions
DD
BB
AA
CC
WOOD
WOOD
BLOCKING
BLOCKING
JJ
HH
KK
Measurements
A 3", 76 mm B 3-1/2", 89 mm
Male 1/2" NPT tting must
C
D
E 3-5/8", 92 mm
F
G Ref. 32", 813 mm H Ø 5-3/4", 146 mm
I 3-3/8", 86 mm
J Ø 2-1/2", 64 mm
MM
LL
K Ø 3-1/8", 79 mm L 36", 914 mm
M 39", 991 mm
protrude 3/8" from
nished wall
Shower Valve Hole Size
Min. Ø 3", 76 mm
Max. Ø 4", 102 mm
Rough-in
2-3/8" ± 1/2", 60 mm ± 13 mm
EE
II
FF
GG
FLOORFLOOR
Notes:
1) All dimensions measured from nominal rough-in (see F as reference).
2) Dimensions subject to change without notice.
Symmons Industries, Inc. 31 Brooks Drive Braintree, MA 02184 Phone: (800) 796-6667 Fax: (800) 961-9621
Copyright © 2018 Symmons Industries, Inc. symmons.com gethelp@symmons.com ZV-1318 REV C 110718
Page 3
Emplacement:
CG
CSA Group
®
Origins
S-9603-PLR Système douche à main
Présentation des spécifications
Spécification Modifications
Le système de douche à main comprend la vanne à pression autorégularisée Temptrol® avec contrôle du volume intégré. Figurer la vis d’arrêt réglable pour limiter le tournage de la poignée, une barre de glissement de 36 po, 60 po tuyau exible en métal et 1 douche à main avec un réducteur de débit régulier de 2,5 gpm (9,5 L/min). Les composants sont faits de matériaux métalliques et non métalliques au ni chrome poli standard.
Numéro de modèle
S-9603-PLR
Système de douche à main Origins
S-9603-PLR-TRM
Garniture seulement de douche à main Origins
S-46-1-BODY
Pression autorégularisée Temptrol
S-46-1X-BODY
Pression autorégularisée robinet d’interruption du service Temptrol
Options de finition
-STN
Fini nickel satiné
Conforme
-ASME A112.18.1/CSA B125.1
-WaterSense 1.5 gpm (5.7 L/min)
2.0 gpm (7.6 L/min)
Certied by
Garantie
À vie limitée - à l’acheteur original dans les installations
du consommateur ou résidentielles. 5 ans - pour des installations commerciales et industrielles. Se reporter au site www.symmons.com/warranty (en an­glais) pour l’information complète concernant la garantie.
☐ ☐ ☐ ☐
☐ ☐
☐ ☐ ☐
☐ ☐ ☐ ☐ ☐
☐ ☐
☐ ☐
-1.5
-2.0
-72
-ADAHS
-B
-B30
-B48
-CHKS
-D
-H321-V
-H323-V
-IPS
-LAM
-LP
-L/HS
-OP
-QD
-R
-REB
-REV
-T724
-T748
-VB
-VP
-X
Régulateur de débit de 1,5 gpm (5,7 L/min)
Régulateur de débit de 2,0 gpm (7,6 L/min)
Tuyau de 72 po à la place du tuyau de 60 po
Douche à main ADA (blanc) Vanne de la rosace chrome laiton Barre coulissante de 30 po au lieu d'une barre
d'appui de 36 po
Barre coulissante de 48 po au lieu d'une barre d'appui de 36 po Valve d’arrêt intégrée
Couvercle en dôme chrome laiton Douche à main à 1mode avec barre
coulissante au lieu de l’unité de douche à main standard Douche à main à 3modes avec barre coulissante au lieu de l’unité de douche à main standard
Raccords IPS femelles de 1/2 po
Poignée du lévier
Poignée de boucle
Sans douche à main
Assiette ovale 13 po
Débranchement rapide pour de douche à main
Tuyau de vinyle blanc
L’ensemble de remise en état de la nition,
incluant TA-10 et TA-4
Corps central inversé our installations dos à dos
Barre à glissière de 24 po barre d'appui avec douchette à main ADA Barre à glissière de 48 po barre d'appui avec douchette à main ADA Reniard surélevé
Des vis anti-vandalisme de la rosace remplacent les vis régulières
Robinet d’interruption du service
Remarque: Juxtaposer le -sufxe approprié au numéro de modèle.
Page 4
Dimensions
PLANCHERPLANCHER
GG
AA
CC
BLOCAGE
DES BOIS
BLOCAGE
DES BOIS
LL
MM
BB
EE
DD
JJ
KK
II
HH
FF
Mesures
A 3 po, 76 mm B 3-1/2 po, 89 mm
1/2 po mâle à lets NPT doit
C
D
E 3-5/8 po, 92 mm
F
G Réf. 32 po, 813 mm H Ø 5-3/4 po, 146 mm
I 3-3/8 po, 86 mm J Ø 2-1/2 po, 64 mm K Ø 3-1/8 po, 79 mm L 36 po, 914 mm
M 39 po, 991 mm
faire saillie de 3/8 po
du mur ni
Taille du trou
Min. Ø 3 po, 76 mm
Max. Ø 4 po, 102 mm
Robinetterie brute
2-3/8 po ± 1/2 po,
60 mm ± 13 mm
Remarques:
1) Toutes les dimensions sont mesurées à partir de la robinetterie brute nominale (voir F en référence).
2) Les dimensions sont sujettes à changer sans préavis.
Symmons Industries, Inc. 31 Brooks Drive Braintree, MA 02184 Phone: (800) 796-6667 Fax: (800) 961-9621
Copyright © 2018 Symmons Industries, Inc. symmons.com gethelp@symmons.com ZV-1318 REV C 110718
Loading...