Symmons S-6095-AC-12V Service Manual

Ultra-Sense™

Sensor Activated Lavatory Faucet

S-6095-AC/ACM-12V, S-6098-AC/ACM-12V

Installation, Operation & Service Instructions

Model Numbers

■ S-6095-AC-12V

Faucet with 5¼" spout, AC transformer
wall plug, faucet p/n SF-01399

■ S-6098-AC-12V

Faucet with 8" spout, AC transformer
wall plug, faucet p/n SF-01400

■ S-6095-ACM-12V

Multi-faucet installations,
5¼" spout, 10' DC power cord,
faucet p/n SF-01399

■ S-6098-ACM-12V

Multi-faucet installations,
8" spout, 10' DC power cord,
faucet p/n SF-01400

Tools & Materials

2.5 mm
(included)

Aerator removal
key (included)

Solenoid valve
removal wrench
(included)

 Need Help?

Symmons customer service:
[phone], [phone]
[e-mail]
Mon - Fri 7:30 am - 7:00 pm EST

 www.symmons.com/service

■ Technical help

■ Product information

■ Warranty policy

Quick Install Guide Ultra-Sense Lavatory Faucet, S-6095-AC-12V, S-6098-AC-12V

Model S-6095-AC-12V, p/n SF-01399 (5¼" spout) ■ Model S-6098-AC-12V, p/n SF-01400 (8" spout)

Single

hole mount

Step 1

Attach faucet

to deck

Step 2

Connect water

supply line

nished deck

front view

Operation

Date Code

-nn = year

-11

Three

hole mount

with deck plate

Step 1

Attach faucet

and deck plate

to deck

Step 2

Connect water

supply line

supply

input

supply

input

AC

nished deck

front view

AC

Spout swivel modifications

120°

2.5 mm

remove all pins for 360º

60°

top view

top view

Installation Instructions, S-6095-AC-12V and S-6098-AC-12V

Important! Prior to connecting the water supply, ensure

supply lines are ushed. Particles can clog lter and result
in malfunction. Excessive particles from supply lines may
require installing a separate ecient lter.

Step 1 Attach faucet to deck (1 hole)

Single hole mount

nished deck

front view

Step 2 Connect power and supply line

™

strainer
check/

adapter

12 VDC
power

HOT

120 VAC

power outlet

Symmons MAXLINE

5-210 water temperature

limiting valve shown for
illustration if required.

temp

adjust

COLD

3/8"

1/2"

tempered supply output

Step 3 Test operation & check for leaks

Step 1 Attach faucet to deck (3 hole)

Three hole mount with deck plate

nished deck

front view

Operation

Sensor range: typically 1/2 to 10
inches

Place hands under faucet, water will ow
automatically for 10 seconds and shut o.

*******************************

Auto shut-off: 1/2 to 1 second

Remove hands, water will stop
automatically within 1/2 to 1 second.

*******************************

Security OFF: 10 seconds

Faucet will automatically shut o aer
continuous water ow for 10 seconds.

Page 2

Multi-Faucet Installation Instructions, S-6095-ACM-12V and S-6098-ACM-12V

+LEAD #1

-LEAD #2

Visual Install Guide

Multi-Faucets S-6095/6098-ACM-12V

+12 VDC

– RET (GND)

Input: 100 - 240 VAC
47-63 Hz @ 1.0 amps

Standard 10 foot DC power cable (optional 20 foot)
included with each faucet.

Power supply supports up

to eight (8) Sensor Faucets

AWG #20

AWG #16

AWG #16

AWG #20

12 inch (305 mm) DC power cable

DC power receptacle

DC power cable plug

Model S-6244 (p/n SF-194)
Termination Enclosure

Switching Power Supply
Output: 12 VDC
@ 3.33 amps max

Model S-6240-12V
(p/n SF-01448)

Wire nut,
terminate wires together

Wire nut,
terminate wires together

green-yellow...(Protective earth)

blue................ (Neutral)

brown............. (Line)

wire labels

+LEAD #1 = +12 VDC

-LEAD #2 = -RET (GND)

Installation Requirements

e following items are not
included and purchased separately:

Switching Powers Supply,
Model# S-6240-12V

Power Supply supports up to eight
faucets. Mounting strap and screws
are included.

Input: 120/240 VAC @ 1.0 amp
Output: 12 VDC @ 3.3 amps max

Termination Enclosure Box,
Model # S-6244

Standard electrical termination
enclosure or equivalent
(6"H x 10"H x 4"D).

Model S-6244 enclosure box may
be purchased from Symmons or
similar type from a local electrical
supplier.

Page 3

Wire nuts - Secure wire connections

using two wire nuts that can join (8)
AWG #20 wires and (1) AWG #16
wire. Purchace from a local electrical
supplier.

Electrical Installation

120/240 VAC to 12 VDC power
supply must be mounted in a
electrical termination enclosure box
with wire connection in accordance
with local state electrical codes.

Important! A licensed
electrician must connect
AC power source to
power cord leading into
termination enclosure.

4-5/8" (118 mm)

2"

(52 mm)

1-3/8"

(35 mm)

1/64"

(0.5 mm)

Male

Receptical

AC Input

(IEC 320

Inlet)

Symmons p/n, SF-01448

12VDC
Output

4 foot DC power cord

6 foot

AC power

cord

Dimensions

Power Supply, S-6240-12V

Installation Instructions, S-6095-AC-12V and S-6098-AC-12V

Multi-Faucet Installation

Reference Visual Guide illustration on page 3.

Step 1 Install Faucets

■ Install each sensor faucet per installation instructions
on page 2.

■ e maximum number of faucets DC power supply
can support is (8) eight.

■ A 10 foot (20 foot optional) extended DC power
cable is supplied with each faucet.

Step 2 Mount Termination Box

■ Mount box to a wall, under a
sink or closet location.

■ Ensure the furthest faucet is
located within 19 feet (5.8
meters) of the termination
enclosure.

Step 3 Run faucet’s extended DC power cable

■ Plug extended DC power cable plug into each faucet’s
power receptacle.

■ Run each extended power cable from faucet under
the sink to the termination box. Feed cable through
a strain relief and punched-out hole into the
termination box.

Avoid contact with water pipes and secure
cable in accordance with state and local
electrical codes.

Step 6 Connect AC Power

■ Connect 120/240 VAC power source to wire ends of

AC power cord. Note: A licensed electrician must
connect AC power source to power cord.

Wire color codes

green-yellow. .................. (Protective earth)

blue .................................(Neutral)

brown..............................(Line)

■ Plug AC power cord into power supply.
Faucets may all activate for one cycle on initial power up.

Step 4 Prepare power cable wire ends

■ Faucet extended DC power cables
Strip o a few inches of cable jacket and then strip
each wire to expose copper ends.

■ Power supply DC power cable
Strip o a few inches of cable jacket and then strip
ends of each wire to expose copper ends.

Step 5 Connect DC power wires

■ +12 VDC line - Connect each of the faucet’s

+LINE #1 black wires to the power cables red wire.

■ -RET (GND) line - Connect each of the faucet’s

- LINE #2 black wires to the power cables black wire.

■ Wire nuts - Secure wire connections using two wire
nuts with size that can join (8) AWG#20 wires and (1)
AWG#16 wire.

Dimensions Enclosure Box, S-6244

Symmons p/n, SF-194

10"

(254 mm)

6" (152 mm)

Note: Dimensions subject to change without notice.

Page 4

4"

(102 mm)

120 VAC

power

2.5 mm wrench

(included)

wrench

(included)

1

5

2

4

3

Service

Replace Solenoid Valve

Replace sensor

Cleaning water supply strainer

COLD

™

5-210 water

120 VAC

HOT

Symmons MAXLINE
temperature limiting valve shown for
illustration only and is not required

Troubleshooting

No water flow

■ Faucet is not receiving power from AC outlet. In multi­faucet installations, faucet is not receiving power.

■ Filter in strainer is clogged. Excessive clogged lter
may require installing of separate ecient lter into
supply line.

■ Solenoid valve connector inside faucet is loose.

■ Circuit board is faulty. Do not attempt repair, please

2

contact Symmons customer service.

■ Solenoid valve is faulty. Do not attempt repair, please
contact Symmons customer service.

1

120 VAC

power

3

5

4

6

Faucet care

Cleaning surface finish

■ Block sensor with sensor cu to
prevent faucet from turning on
while cleaning.

■ Clean nish area by using
mild soap and water or non­abrasive cleaner and then rinse
immediately. A non-abrasive
wax may be used to preserve
nish area.

Precautions

■ Ensure sensor is not damaged through impact or
scratches.

■ Ensure sensor is not blocked or disturbed by any
objects.

■ Ensure a strong light source is not aimed directly at
sensor or through a mirror.

Page 5

Dimensions Ultra-Sense Lavatory Faucet, S-6095-AC-12V, S-6098-AC-12V

S-6095-AC-12V, p/n SF-01399......5¼" Spout

S-6098-AC-12V, p/n SF-01400......8" Spout

Model Spout Dimension

series size A B

5-1/4" 11-3/4"

S-6095 5-1/4"

(133 mm) (299 mm)

8.0" 12-11/16"

S-6098 8"

(203 mm) (322 mm)

1" dia
(25 mm)

2-7/16" dia
(62 mm)

B

see table

7-11/16"

(196 mm)

A

see table

5º

Deck thickness

1-3/16" (30 mm) max

Center hole size
1-5/16" (34 mm) min
1-3/8" (37 mm) max

hose length

14-9/16"

(370 mm)

strainer / adapter

Note: Dimensions subject to change without notice.

3/8" compression

Parts Assembly Ultra-Sense Lavatory Faucet, S-6095-AC/ACM-12V, S-6098-AC/ACM-12V

S-6095-AC/ACM-12V, p/n SF-01399......5¼" Spout

S-6098-AC/ACM-12V, p/n SF-01400......8" Spout

aerator

1.5 gpm

removal key

spout, swivel or
xed forward
position

2.5 mm wrench

(included)

spout removal
screw

faucet body

2.5 mm wrench

(included)

snap on-off

sensor

protector

body fastener
screw

o-ring
sensor
sensor holder

removal tool

solenoid valve

120 VAC
transformer
wall plug

valve body

p/n SF-236

u-washer

hex nut

S-6095 / S-6098 Replacement Parts

Part Number Item

SF-240

SF-01531

SF-01532

SSF-108

SF-01657

SF-01535

FLR-130-1.5-KIT

FLR-01526
FLR-01524

Ordering replacement parts:

Call Symmons customer service at [phone],
[phone] M-F 7:30 am - 7:00 pm EST
or check our website at www.symmons.com for a
list of Symmons distributors.

Solenoid valve
with removal tool

Sensor

Sensor holder

Check / strainer kit
for ex hose
connections

Single hole
mounting kit

Spout rotation limit pins
and 60˚ limiter

Aerator, vandal resistant, with
removal key #FLR-130-KEY

■ 1.5 gpm (5.7 L/min)

Non-aerated laminar ow spray
outlet, vandal resistant, with
removal key #FLR-130-KEY

■ 0.5 gpm (1.9 L/min)

■ 1.5 gpm (5.7 L/min)

housing

check

screen

ex hose

check / strainer / adapter

3/8" compression

Symmons Industries, Inc. 31 Brooks Drive ■ Braintree, MA 02184 ■ ©2012 Symmons Industries, Inc.
[phone], [phone] ■ Fax: [phone] ■ www.symmons.com ■ [e-mail]
Model# S-6095-AC/ACM-12V, Part# SF-01399 ■ Model# S-6098-AC/ACM-12V, Part# SF-01400 ■ Doc# ZV-1037 ■ Date 020312

12 VDC
power receptical