GETTING STARTED
1. Download the Atomic Connected app in the Apple App Store or the Android
Play Store.
2. Charge the Movesense Module (A). Attach both to the adapter (B) and
connect the USB cable to a 5Vdc, 0.5A outlet.
When connected to adapter:
- FLASHING RED: Not charging. Device either too hot or too cold or charger
faulty.
- FLASHING YELLOW: Movesense Module is charging
- CONSTANT GREEN: Charging complete
- FLASHING BLUE: Bluetooth connected
3. Flip open the protective flap on the back of the liner. Place Movesense Module
into designated holder on the Power Strap and attach the Movesense
connector to the matching connector on the liner. Flip down the protective flap
on the back of the liner after connecting.
When connected to liner:
- FLASHING GREEN: Connected to liner, Movesense Module running
- FLASHING RED: Battery charge below 10%
- FLASHING PURPLE:
- FLASHING BLUE: Connected to Bluetooth
4. Ensure the Bluetooth function of your phone is turned on and open the Atomic
Connected app on your smartphone. Follow the directions for pairing your
boots in the app. Once the boots are properly paired you can begin to use the
Atomic Connected app.
Pairing
Pairing procedures may vary, so refer to the instructions of your mobile application
for guidance. When pairing, ensure you are at least 10 m (33 ft) away from other
Bluetooth devices.