Sure Heat SGR30 User Manual

S

S

S

S

PLA

PLA

Sonoma Platinum Edition Grill:

o

o

o

o

TINUM

TINUM

n

n

n

n

30” Model

o

o

o

o

EDITION

EDITION

m

m

m

m

a

a

a

a

TM

USE AND CARE MANUAL

FOR OUTDOOR USE ONLY

MADE IN THE U.S.A.

General Safety Instructions

IMPORTANT SAFETY INFORMATION

ead this manual carefully before using your grill to reduce the risk of fire, burn

- R

hazard or other injury.

Extreme care should be used because of the high temperatures produced by this

­appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA
WHERE THE GRILL IS BEING OPERATED.

- This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not
allow flammable materials to come in contact with grate, burner or hot surfaces.

- Use only outdoors and provide good ventilation to avoid carbon monoxide build-up which could result in injury or death.

- Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. A qualified
service technician should conduct all other service.

- Follow the installation and servicing instructions provided with this product. Have your grill installed by a qualified service
technician.

- Locate the main gas supply valve so that you know how to shut the gas off to your grill.

- If you smell gas, make sure all gas connections are tight before operation. If you continue to smell gas call a qualified
technician.

- When lighting a burner, always pay close attention to what you are doing and be certain you are pushing the igniter
that lights the burner you intend on using.

- Always keep your face and body as far away as from the grill as possible when lighting to reduce the risk of burn.

- Extinguish all flames and do not smoke while engaging gas and igniting the grill.

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flames.

3. Open grill hood.

4. If odor continues, immediately
call your gas supplier.

CALIFORNIA PROPOSITION 65 - WARNING:
The Burning of gas cooking fuels generates some by
products which are on the list of substances which
are known by the State of California to cause cancer
or reproductive harm. California law requires busi­nesses to warn customers of potential exposure to

o minimize exposure to these

such substances.
substances, always operate this unit according to the
use and care manual, provide good ventilation when

cooking with gas.

T

This appliance is not intended to be

installed in or on recreational

vehicles or boats.

TESTED IN ACCORDANCE WITH ANSI
Z21.58b-2002/CGA 1.6b-M02 STANDARD FOR
OUTDOOR COOKING GAS APPLIANCES.
THIS GRILL IS FOR OUTDOOR USE ONLY.

Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code No. Z223.1-2002
and the National Electrical Code ANSI/NFPA

No. 70-1990

FOR YOUR SAFETY

DO NOT store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

LP cylinder not connected for use shall not be stored in

An

the vicinity of this or any other appliance.

WARNING

DO NOT

try lighting this appliance without reading

the “LIGHTING INSTRUCTIONS” section of

this manual.

FOR OUTDOOR USE ONLY

1

Grill Features: SGR30LP

1

2

3

4

5

6

7

8

9

12

13

10

14

11

1. Roll top grill hood

2. Grilling/Cooking surface

3. Side Shelf

4. Control knob: back infrared burner

5. Control knobs: main burners

6. Convection vents

7. Hood Handle

8. Warming shelf

9. Infrared back burner

10. Electronic igniter: main, rear infrared & side
burner

11. Cart with door

12. Side Burner

13. Control knob: Side Burner

14. Drip Tray

2

Grill Assembly

IMPORTANT: Remove all protective plastic film from
stainless steel parts prior to assembly/use. This film
is installed at the factory to prevent damage that
could occur during shipment and handling.

SIDE SHELF ATTACHMENT

1. Attach the shelf to the left side of grill by inserting the
shelf hooks into the slots on the side of the grill and
pushing down on the shelf assembly until level with
grill. (See Fig. 1)

2. Lock the shelf in place by tightening the four (4) bolts
under the shelf. (See Fig. 2)

Fig. 1

INTERIOR PARTS INSTALLATION

1. Install the bottom Flavor Grids in the lower cutouts and

around the igniters. (See Fig. 3)

2. Insert the top row of Flavor Grids with the 90 degree

angled heat shield (bottom side of flavor grid) facing the
rear of the unit into cutouts with triangle ridges facing
up. (See Fig. 4-5)

3. Install cooking grates on the ledges provided on the grill

to create your cooking surface. (See. Fig. 6)

4. Place warming shelf on support brackets by setting it

flat across brackets allowing the two holes to line up
with the holes on each bracket. (See Fig. 6)

Cooking Grates

Warming Shelf

Fig. 6

Fig. 2

Fig. 3

Bottom Flavor Grids

in between burners

Faces the back of

the grill

Fig. 4

Fig. 5

3

Side Burner Assembly

SIDE BURNER PARTS ASSEMBLY

1. Remove burner assembly from packaging. (See Fig. 7)

2. Loosen the bolts on the side of the grill and attach the

shelf by allowing the bolt heads to fall through the large
openings in the bottom of the keyhole slots. Slide the
shelves downward until the bolts are resting against the
top of the key hole slots. Tighten the (4) shelf bolts.
(See Fig. 8-9)

3. Attach burner to burner shelf by inserting the valve

(toward front of the grill) end first, then sliding the
burner/igniter assembly through the holes in the top
of the burner shelf. It may be necessary to bend the
gas line slightly to fit the burner assembly.
(See Fig. 10-11 )

4. Insert two (2) 1/4" self tapping screws through the top of

the shelf to secure the burner assembly. (See Fig. 12)

5. Install 1 Phillips head screw through the knob bezel,

through the shelf, attaching the valve assembly to the
front of the side burner. (See Fig. 13)

Fig. 7

Fig. 8

Fig. 9

Fig. 12

Fig. 13

Fig. 10

Fig. 11

4