Sureheat Sgr27lp, Sgr27lp Owner's Manual

S
S
S
S
PLA
PLA
o
o
o
o
TINUM
TINUM
n
n
n
n
27” Model
o
o
o
o
EDITION
EDITION
m
m
m
m
a
a
a
a
TM
USE AND CARE MANUAL
FOR OUTDOOR USE ONLY
MADE IN THE U.S.A.
General Safety Instructions
IMPORTANT SAFETY INFORMATION
ead this manual carefully before using your grill to reduce the risk of fire, burn
- R
hazard or other injury.
Extreme care should be used because of the high temperatures produced by this
­appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED.
- This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not allow flammable materials to come in contact with grate, burner or hot surfaces.
- Use only outdoors and provide good ventilation to avoid carbon monoxide build-up which could result in injury or death.
- Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. A qualified service technician should conduct all other service.
- Follow the installation and servicing instructions provided with this product. Have your grill installed by a qualified service technician.
- Locate the main gas supply valve so that you know how to shut the gas off to your grill.
- If you smell gas, make sure all gas connections are tight before operation. If you continue to smell gas call a qualified technician.
- When lighting a burner, always pay close attention to what you are doing and be certain you are pushing the igniter that lights the burner you intend on using.
- Always keep your face and body as far away as from the grill as possible when lighting to reduce the risk of burn.
- Extinguish all flames and do not smoke while engaging gas and igniting the grill.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. Open grill hood.
4. If odor continues, immediately call your gas supplier.
CALIFORNIA PROPOSITION 65 - WARNING: The Burning of gas cooking fuels generates some by products which are on the list of substances which are known by the State of California to cause cancer or reproductive harm. California law requires busi­nesses to warn customers of potential exposure to
o minimize exposure to these
such substances. substances, always operate this unit according to the use and care manual, provide good ventilation when
cooking with gas.
T
This appliance is not intended to be
installed in or on recreational
vehicles or boats.
TESTED IN ACCORDANCE WITH ANSI Z21.58b-2002/CGA 1.6b-M02 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR OUTDOOR USE ONLY.
Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the National Fuel Gas Code No. Z223.1-2002 and the National Electrical Code ANSI/NFPA
No. 70-1990
FOR YOUR SAFETY
DO NOT store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
LP cylinder not connected for use shall not be stored in
An
the vicinity of this or any other appliance.
WARNING
DO NOT
try lighting this appliance without reading
the “LIGHTING INSTRUCTIONS” section of
this manual.
FOR OUTDOOR USE ONLY
1
Grill Features: SGR27LP
1
2
3
4
5
6
7
10
11
8
9
1. Roll top grill hood
2. Grilling/Cooking surface
3. Side Shelf
4. Control knobs: main burners
5. Convection vents
6. Hood Handle
7. Warming shelf
8. Electronic igniter: main & side burner
9. Cart with door
10. Side Burner
11. Control knob: Side Burner
2
Grill Assembly
IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling.
LEFT SHELF ASSEMBLY
1. Open the grill hood and place a piece of styrofoam from the packaging under the grill hood to prop the grill hood open slightly. (See Fig. 1)
2. Attach the left shelf by inserting the four shelf hooks into the slots on the side of the grill. (See Fig. 1)
3. After inserting the four shelf hooks, press the shelf against the grill and press downward until the shelf locks in place. Make sure the top strip is hanging all the way inside of the grill before pressing downward. (See Fig. 1)
4. Install one self tapping screw into the bottom front hole of the shelf to lock shelf in place. (See Fig. 2)
Fig. 1
Fig. 2
SIDE BURNER PARTS ASSEMBLY
1. Remove side burner assembly from packaging. (See
Fig. 3)
2. Place a piece of styrofoam from the packaging in the
grill to leave the grill hood propped open slightly. (See Fig. 4)
3. Attach the right side burner by inserting the four shelf
hooks into the slots on the side of the grill. (See Fig. 4)
4. After inserting the four shelf hooks, press the side burn-
er shelf against the grill and press downward until the shelf locks in place. Make sure the top strip is hanging all the way inside of the grill before pressing downward. (See Fig. 4)
Fig. 3
Fig. 4
3
Loading...
+ 11 hidden pages