Sunfire Speaker User Manual
®
Satellite Loudspeaker Stand Kit
Introduction
Thank you for purchasing this Sunfi re loudspeaker
stand. It has been designed as a perfect match
for the CRM-2 satellite loudspeakers – following
the cabinet's taper and producing an elegant,
one-piece look. A high-gloss lacquered base and
column ensures that form meets function. This
guide shows you how to assemble the stand and
mount the CRM-2. Please read the CRM-2 User's
Manual for further details of these loudspeakers,
including location, operation and features. Please
note that the CRM-2 is sold separately.
Assembly overview
The column is attached to the base using four
Allen screws supplied. The CRM-2 loudspeaker
has an adapter plate that lines up with a keyhole
bracket in the column, and the loudspeaker is held
in place by two locking screws. Speaker wires are
neatly hidden within the column and exit from the
base. Four rubber screw-on feet are supplied to
fi t on the base.
Unpacking
Your stand kit should reach you in perfect condition. If you do notice any shipping damage, please
contact Sunfi re immediately. Make sure that
you keep your sales receipt. It is the only way to
establish the duration of your Limited Warranty.
Contents of each stand kit
• Base
• Column
• Speaker Adapter Plate
• 4 Allen screws for attaching the column to the base
• 1 Allen screw for attaching your CRM-2 satellite loudspeaker to the speaker adapter plate
• 2 Allen screws for attaching the speaker adapter plate
to the column
• Allen wrench
• 4 screw-on spikes, 4 screw-on rubber feet, with wrench
CRM-2
Column
Assembly Guide
Base
1
Assembly Guide
Stand Assembly
Tools required:
• Allen wrench supplied
6. Feed the speaker wires through the base until
they can be gently pulled through the rectangular
hole near the top of the column.
Preliminary steps:
• Run the loudspeaker cables to each location, so these
can be fi tted to the loudspeaker during the assembly
of the stand.
• Unpack your CRM-2 loudspeaker, and get it ready for
use.
• Refer to the CRM-2 owner's manual to determine the
optimum placement of your loudspeakers.
• Alternatively, you can just assemble the column to the
base by following steps 1 through 5 below, and add
the loudspeaker and speaker wires later.
Procedure:
1. Place the column on the fl oor with the top side
face down on the fl oor.
2. Place the stand base onto the column.
3. Make sure the column is locked in the stand
base.
4. Using the four supplied screws, attach the stand
base to the column.
5. Fit the four rubber feet (or spikes) to the base,
and tighten with the supplied wrench.
4 Screws
Wires
Wires
7. Line up the adapter plate with the CRM speaker
making sure the hole on the bottom of the speaker
lines up with the center hole on the adapter plate.
8. Attach the adapter plate to the CRM speaker
using the included Allen head screw.
2
4 Spikes
Base
Column
Bracket
Allen Screw
Loading...