Subaru H7110FS400 User Manual

SECURITY SYSTEM

UPGRADE

INSTALLATION

FORESTER

INSTRUCTIONS

P/N: H7110FS400

NOTE: This system requires prior installation of Keyless Entry

System. If installing both systems at the same time, install the Keyless Entry System first.

Kit Contents:

1 Security Control Module w/Integral Bracket 1 Starter Interrupt Relay w/Integral Bracket 1 Extension Harness 1m (3 ft.) 1 M6 Nut 1 Wire tie 2 Window Decals 1 Installation Manual

Tools Required:

#1 Flat-tip Screwdriver #2 Phillips Head Screwdriver (short) Electrical Tape 1/4” Drive Ratchet 10-inch 1/4” Drive Extension 12mm Socket 10mm Socket

This device complies with FCC rules part 15. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference that may cause undesired operation.

99.11

UT27S-11

Printed in Japan

A. Pre-Installation Notes

1. Vehicle Preparation

a. Lower the driver’s side window to avoid inadvertently locking the keys in the vehicle dur-

ing installation.

b. Disconnect negative battery terminal to prevent accidental shorting of any power circuits.

2. System Preparation

Remove the security module from the package and inspect for any physical damage.

3. Shock Sensor Adjustment

The shock sensor adjustment knob is recessed inside the unit and is covered by a protective seal. This adjustment is PRESET at the factory.

B. Security Module Installation

1. Open the parking brake/tray cover which is shown in Figure 1.

2. Remove the two screw caps and two screws indicated by the arrows in Figure 2 and disengage the four hooks indicated by the arrows in Figure 1.

3. If applicable disconnect the two harnesses (white housing and blue housing) on the parking brake cover, then remove the parking brake cover.

NOTE: Depending on the vehicle type, your vehi-

cle may not have these harnesses.

4. Remove the gearshift cover by pulling up in areas indicated by the arrows in Figure 3. a. For manual transmission, the shift knob must be

removed by unscrewing.

b. For automatic transmission, shifter must tem-

porarily be placed into neutral.

NOTE: The negative battery terminal will have

to be reconnected and then disconnected to move the shifter into neutral.

Figure 1

Figure 2

Figure 3

5. Remove and retain for reinstallation, the black M8 bolt indicated by the arrow “A” in Figure 4. Loosen the M8 bolt indicated by the arrow “B.”

6. Route the male connector of the extension harness under the center console from the driver’s seat side. See Figure 5.

7. Insert the male connector of the extension harness into the security module 18-pin connector.

Figure 4

8. Install the security module onto the bolt indicated by the arrow “B” which was loosened in step 5, then tighten the bolts indicated by the arrows “A” and “B” to 13±3.6 ft. lbs. Refer to Figure 6.

NOTE: The security module must be properly

and firmly mounted. If it is not properly and firmly installed, the system’s shock sensor will not function as intended.

Figure 5

Figure 6

+ 5 hidden pages