Date installed:......................................................................................................................................................
Model Description: ..............................................................................................................................................
Serial number: .....................................................................................................................................................
Installation Engineer
Company name: .....................................................................................................................................................................
PLEASE NOTE: THE INFORMATION GIVEN IN THIS MANUAL IS TYPICAL
FOR ALL THREE MODELS UNLESS STATED.
1. GENERAL
1.1This stove is designed for domestic heating and should only
e used for this purpose, and in accordance with the
b
manufacturers operating instructions.
It should be installed by a competent installer, in
accordance with the relevant local and national
regulations.
1.2The stove should only be used to burn approved fuels and
should not be used with liquid fuels or used as an
incinerator.
1.3As with all heating stoves the surfaces will become very hot
when in use, therefore due care should be taken when near
the stove. If it is to be used in the presence of young
children, elderly or infirm persons a suitable fireguard
should be used. Care should also be taken with the
placement of combustible items near the stove as
conducted and radiated heat could cause a fire hazard.
1.4Due to the high temperature of the convected air above the
stove we recommend that no valuable photographs,
paintings, porcelain or other items are placed in this area.
Such artefacts may be damaged by long term exposure to
fluctuating temperatures.
1.5Additional ventilation may be required for the safe use of
this stove should be kept free of any obstructions, both
inside and outside the building, at all times.
1.6Have your Stovax product serviced annually by a
competent service engineer, and if repairs are required use
only Stovax approved spare parts.
Do not make unauthorised modifications or changes to the
1.7
appliance.
XETERENGLAND
E
P
RODUCT
M
ODEL No.RVF40AV_ _
S
ERIAL No.
RIVA F40 _ _ _ _ _ _
_
_ _ _ _ _ _ _ _ _ _
1.9 ASHCOVER
PR7108
R7165
P
1.8SERIAL NUMBER
This number will be required when ordering spare parts or
making warranty claims. It is found inside the ash cover
door as shown
To operate the "touch latch" press the centre of the
ashcover to open and close the cover.
4
OPERATING INSTRUCTIONS
1.10 AIR CONTROLS
PEN
LOSE
C
O
PRIMARY AIR CONTROL
Lower ash pan cover and move
the control as shown using the
door tool.
1.11 DOOR HANDLE
PEN
O
LOSE
C
SECONDARY AIR CONTROL
Airwash
This control has a pre-set
"indent ball" stop in the closed
position "opti-burn" setting.
If the control is pushed past
this point the airwash will be
fully closed.
Lift To Open
1.12 RIDDLING GATE
De-ash the firebed, using the riddling grate system as shown
below.
Never operate the grate with your bare hands
2. USING THE RIVA FOR THE FIRST TIME
2.1When new it is best to burn the fire at a low output for the
first few days of use. This will allow the construction to
settle and all fixing glues and paint to fully cure.
Remove
To open and close the door use the tool provided as
shown.
AVOID TOUCHING THE PAINT DURING FIRST PERIOD
OF USE.
2.2During this time the appliance may give off some
unpleasant odours, and we recommend that you keep the
room well ventilated during this period to avoid a build-up
of fumes.
3. BURNING WOOD
CLOSE
3.1Open the
control
to approximately 25% open.
OPEN
CLOSE
Airwash control fully and open the Primary air
OPEN
Place some pieces of firelighter or dry crumpled paper on
3.2
the grate and cover with some small pieces of dry kindling
wood. Light the paper or firelighters.
3.3To avoid the build-up of condensation on the door glass it is
advisable to leave the door slightly open as the fire
establishes, and the glass warms.
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.