Stovax PR1018 User Manual

Winchester Front

Installation Instructions

For use with the Logic Hotbox, Logic Convector, Logic IPF,

Logic E-Box™and E-Studio™

PR1018 Issue 2 (July 2008)

USER AND INSTALLATION INSTRUCTIONS

Covering the following front:

Logic 8698 MB

E-Box
E-Studio

8698 P

8697 MB
8697 P

USER INSTRUCTIONS

1. CLEANING AND CONTROLS

1.1 Only clean the front when it is cold. The front should be
cleaned using a damp cloth and buffed with a lint free
duster.

1.2 Access to the controls is behind the ash pan cover.

INSTALLATION

INSTRUCTIONS

These instructions are supplemental to and must be read in
conjunction with the Installation Instructions supplied with the
gas fire. Read both thoroughly before installing the appliance.

Fitting of this front is to be carried out after the appliance has
been fully installed but before the commissioning tests. Except
for use with the E-Box where commissioning will need to take
place prior to fitting the front.

1. FRONT DIMENSIONS

2

508

71

365

28

269

210

30

40

618

55

AR2178

2. FITTING FOR ALL FIRE TYPES

There is a bracket on the reverse side of the front at the top
edge:

• Hook the bracket onto the lugs at the top of the fire,

Diagram 3

3

Diagram 1 shows the Winchester Front dimensions for the

Logic hotbox, Logic Convector and Logic IPF:

1

508

71

Diagram 2 shows the Winchester Front dimensions for the

E-Box, E-Studio Conventional and Balanced Flue:

375

30

337

618

210

55

AR2177

AR2179

There are two flat clips supplied to grip the bottom edge of the
front to the fire:

• Clip each side of the front to the fire as shown in

Diagram 4

4

AR2180

• Slide the ash pan cover into place

Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG

Tel: [phone] Fax: [phone] E-mail: [e-mail]

A member of the Stovax Group