Sterling S-6410-A User Manual
Specifications and Main Features
- Model: S-6410-A
- Type: Water circulatory unit, single zone
- Heater: Trencher, 3 phase/4500 watts
- Temperature range: 10 to 121 degrees celsius.
- Pumping capacity: 15 GPM at 20 psi (57 L/M at 1.4 Kg/cm²)
- Electrical specifications: 3/60/230 or 3/60/460 zg standard; control circuit 115 volt, fuse protected
- A solid state thermostat with adjustable dead band.
- Valley: A large dial and indicator easy to read.
- All controls on the front panel.
- An electrical system which is balanced built to rigid standards.
- Protective components against operation switch without water.
- Other operators form welded steel frame cabinet to ensure easy access to the controls.
- Measurements: 11 wide, 18 deep, 21 high.
- Weight pneumatic package: 135 lbs/3/60/230, 145 lbs/3/60/460.
- Also 4” delivery and return connections and 1/2 “ water supply and drain connections.
- Power on lights heating or cooling indicators.
- For accurate control of the specified mold part temperature a water system is used to proportion.
- Pushing a button before simple operation starts to vent.
Frequently Asked Questions
Q: What model number has the operating temperature range of 50-250 degrees Fahrenheit?
A: The S-6410-A operating temperature range is between 50-250 degrees Fahrenheit.
Q: In terms of power supply what does the environmental use unit comply to?
A: The environmental use unit works under a 3/60/230 or a 3/60/460 power supply,105 volts control.
Q: How can I vent the unit before startup?
A: The trapped air and water can be drained out by using the push button vent, and that is how the unit can be vented.
Q: The thermostat indicates that the unit should be heating, but the unit is not heating up. What should be done?
A: Hot water loss from the system should not be continuous and also purging of the system from air has to be carried out, before starting the unit. But in some cases, there may also be a need to check if the heater is working.
Q: If I mistakenly switch on the machine with a pressure switch ON what will happen?
A: The pressure switch safeguards the unit against the operational use with less than the required amount of water pressure so as to prevent damage to the pump and the heater.
Q: Is warranty included on the S-6410 – A model?
A: Yes, for one year from the date of shipment the buyer is covered against any defect in material and workmanship provided there is no misuse.
Q: Is it possible for the unit to cool?
A: It is possible for the unit to cool by letting warm water discharge to the drain and cool water to enter from the water supply.
Q: What is the shipping weight of the S-6410-A model?
A: The 3/60/230 model has a shipping weight of 135 lbs and 3/60/460 model has a shipping weight of 145 lbs.
Q: How can I guarantee careless installation?
A: Begin by bolting the unit such that the connections cannot be undone easily, ensure the grounding conductor is correct, and that the power supply has the recommend capacity of the unit. Any and all connections should be verified prior to commencing operation of the unit.
Q: In the case that the unit is on longer service how do I drain the unit?
A: Considering that the unit is either being serviced for a longer period of time or is planned to be subjected to sub-zero temperatures, all plugs that provide for draining of the unit shou7td be employed in order to ensure the unit is fully drained.
User Manual
Loading...