Steelcase Verb User Manual

®

Verb™ Media Tables

If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at

888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.

(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com

©

2015 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.

Printed in U.S.A.

R2

Page 1 of 6

24450602 Rev A

®

Attaching Access Legs to a Media Worksurface

1. Place worksurface upside down

on a clean, scratch resistant surface,
such as on a table.

2. Align the marked identification holes

on the leg top plate with the pilot holes as
shown. Install #10 x 1" wood screws into
the three (3) pilot hole locations (2a).

Install six (6) wood screws in the
remaining hole locations on the leg
top plate (2b).

2a 2b

Align the marked identification holes with the inward
most pilot holes.

NOTICE: DO NOT install Access (Fixed Height) legs in
the hole pattern for the Post (Height-Adjustable) legs.

A properly installed leg will have a caster or glide that
does not extend past the edge of the worksurface.

Example of a marked
identification hole.

Page 2 of 6

24450602 Rev A