Steelcase 98665-3, 98665-2, 98665-1 User Manual
LINE
1
LINE
2
LINE
3
AMP
L2
N
G
L1
L3
AMP
L2
N
G
L1
L3
AMP
L2
N
G
L1
L3
MODEL NO. DESCRIPTION HOT WIRE CODE COLOR
98665-1 LINE 1 DUPLEX “L-1” (APPLICATION CIRCUIT) RED WIRE
98665-2 LINE 2 DUPLEX “L-2” (LIGHTING CIRCUIT) BLACK WIRE
98665-3 LINE 3 DUPLEX “L-3” (E.I.P CIRCUIT) BLUE WIRE
4 OR 5 WIRE
4 OR 5 WIRE
5-WIRE
POWERWAY SYSTEM
WIRING INFORMATION
Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-800-227-2960
Tools
Assembly Directions
Printed In U.S.A.
93-9501147 -
Page 1 of 4
Installation For 4 & 5 Wire Duplex Receptacle Into:
Series 9000
®
Structural Panel
2” P-Series Mobiles Power Panel
Series 9000
®
Energy Management Worksurface
All electrical installations should be done by a
qualified person in accordance with codes and
regulations applicable at the installation site.
NO CONTACT
NO CONTACT NO CONTACT
REV
LINE
1
LINE
1
Assembly Directions
93-9501147 REV -
Page
2 of 4
Panel Base Receptacle Installation
Remove trim by pushing down on steel tabs at the bottom extreme
1.
ends (in area of glides) and lifting straight up and out.
APPLY PRESSURE TO STEEL TABS
BASE TRIM
Position duplex receptacle to panel powerway assembly.
2.
Secure receptacle with (2) screws
STRUCTURAL PANEL
POWERWAY
DUPLEX
RECEPTACLE
SCREWS
Remove access cover from base trim.3.
Replace trim by reversing removal procedure.
4.
NOTE: If receptacle and base trim do not align, the
powerway may be adjusted by loosening the (2)
ACCESS
COVER
BASE
TRIM
powerway mounting screws and sliding the powerway to either end. Re-tighten screws and replace
base trim.
DUPLEX
RECEPTACLE
BASE
TRIM
Loading...