Star Manufacturing SST-30, SST-50, SST-75 Operation Manual

DRAWER ROLL/

IL1889

BUN WARMER

MODEL

SST-20
SST-30
SST-50
SST-75

Installation and

Operation

Instructions

2M-Z3235 Rev. G 8/2/2010

1

SST-75

2

These symbols are intended to alert the user to the presence of
important operating and maintenance instructions in the manual ac­companying the appliance.

RETAIN THIS MANUAL FOR FUTURE REFERENCE

NOTICE

Using any part other than genuine Star factory supplied parts relieves the
manufacturer of all liability.

Star reserves the right to change specications and product design without

notice. Such revisions do not entitle the buyer to corresponding changes,
improvements, additions or replacements for previously purchased
equipment.

Due to periodic changes in designs, methods, procedures, policies and

regulations, the specications contained in this sheet are subject to change
without notice. While Star Manufacturing exercises good faith efforts to provide
information that is accurate, we are not responsible for errors or omissions

in information provided or conclusions reached as a result of using the

specications. By using the information provided, the user assumes all risks in
connection with such use.

MAINTENANCE AND REPAIRS

Contact your local authorized service agent for service or required maintenance. Please record

the model number, serial number, voltage and purchase date in the area below and have it ready when you call to ensure

a faster service.

SAFETY SYMBOL

Model No.

Serial No.

Voltage

Purchase Date

Business 8:00 am to 4:30 p.m. Central Standard Time
Hours:

Telephone: [phone] Local [phone]
Fax: [phone] Local [phone]

E-mail [e-mail]

[e-mail]

[e-mail]

Website: www.star-mfg.com

Service Help Desk

Authorized Service Agent Listing

Reference the listing provided with the unit

or
for an updated listing go to:

Website: www.star-mfg.com
E-mail [e-mail]
Telephone: [phone] Local [phone]

Mailing Address: Star International Holdings Inc., Company

10 Sunnen Drive

St. Louis, MO 63143

U.S.A

2

CAUTION

WARNING

GENERAL INSTALLATION DATA

This equipment is designed and sold for commercial use only by personnel trained and experienced
in its operation and is not sold for consumer use in and around the home nor for use directly by the
general public in food service locations.

Before using your new equipment, read and understand all the instructions & labels associated with
the unit prior to putting it into operation. Make sure all people associated with its use understand the
units operation & safety before they use the unit.

All shipping containers should be checked for freight damage both visible and concealed. This
unit has been tested and carefully packaged to insure delivery of your unit in perfect condition. If
equipment is received in damaged condition, either apparent or concealed, a claim must be made
with the delivering carrier.

Concealed damage or loss - if damage or loss is not apparent until after equipment is unpacked, a
request for inspection of concealed damage must be made with carrier within 15 days. Be certain to
retain all contents plus external and internal packaging materials for inspection. The carrier will make
an inspection and will supply necessary claim forms.

INSTALLATION

This bun warmer is equipped for the voltage shown on the nameplate. It will operate on
alternating current only; however, the correct voltage must be applied. The unit should be

installed by a qualied installer.

DO NOT CONNECT TO DIRECT CURRENT (DC).

GENERAL OPERATING PROCEDURES

Using the power switch, turn the unit on. The pilot light on the front of the unit will indicate when the
power is on. Select a setting on the thermostat for warming or holding rolls.
To keep the rolls soft and fresh, turn the control knob to a low position. Higher settings should be
used only for short periods or preheating the warmer. Keep the drawers as full as possible. When
adding new rolls to the drawer, pull the rolls and buns that are left in the drawer toward the front and

use them rst, giving time for the new rolls to become heated. Do not heat the rolls more than once,

as they will not be palatable if reheated. If the rolls dry out, reduce temperature.

WARNING

WARNING

NOTE: This unit may smoke and have a slight odor when rst used. We suggest you

turn the thermostat to a high heat position and let unit heat for approximately two (2) hours
before using.

ELECTRICAL CONNECTIONS

For your protection, this appliance is equipped with a 3-conductor cord with a grounding type plug.
Connect only to a grounding receptacle.

Before making any electrical connection to this unit, check that the power supply is adequate for the
voltage, amperage and requirements stated on the rating plate.
A wiring diagram is included herewith.

Disconnect the unit from the power source before installing or removing any parts.

Be absolutely sure that the ground connection for the receptacle is properly wired. Do not connect

equipment to power without proper ground connections. Improper grounding may result in personal
injury or fatality.

DO NOT CUT OR REMOVE THIS PLUG OR GROUNDING PRONG FROM THE PLUG.
CONNECT/PLUG UNIT INTO DEDICATED A.C. LINE ONLY SPECIFIED ON THE DATA

PLATE OF THE UNIT.

3

CLEANING

To remove the drawer for cleaning:

1. Pull the drawer out until it stops.

2. Remove the interior pan.

3. Grasp the drawer assembly with both hands.

4. Lift the drawer in an upward direction while slowly pulling out.

This will disengage the drawer from the drawer stops. To re-install the drawer, reverse the
procedure. The unit should be cleaned with a damp cloth using a mild detergent or non
abrasive cleaner. Clean the entire unit daily to ensure long life and satisfactory performance

as well as to maintain an attractive appearance. Do not clean with water jet equipment.

MAINTENANCE AND REPAIRS

Contact the factory, a service representative, or a local service company for service or required
maintenance.

4