Sta-Rite Polaris 180 Installation Manual

Disposable Sand/Silt Bag

Installation Instructions

When used on Polaris® brand pressure pool cleaners, this bag is used inside of other non-disposable filter bags.

When used on Legend® brand pressure pool cleaners, this bag is used instead of other non-disposable filter bags.

Use this bag to capture very fine sand and silt, when full, remove it and throw it away.

Replacement instructions for Legend®, Legend® II, Legend® Platinum and Legend® Platinum Truck or

Polaris

180

1. Remove the filter bag.

2. For Legend® brand cleaners, remove the debris valve.

3. Slip the new disposable sand/silt bag over the vacuum tube outlet and secure it with a double wrapped rubber band.

4. For the Polaris® 180 pool cleaner, attach a standard filter bag over the disposable sand/silt bag. For the Legend

brand of cleaners, no extra filter bag is needed.

Pentair replacement instructions for Polaris® 280/380

1. Remove the filter bag.

2. Place the disposable bag inside the vacuum tube outlet with the open end up.

3. Fold the open end of the disposable bag over the outside of the vacuum tube outlet.

4. Snap the filter bag into the vacuum outlet. Once the cleaner is operating, the disposable bag will be pushed inside the filter bag.

5. Fold the open end of the disposable bag up and over the cuff of the filter bag so both bags can be removed together.

Pentair Water Pool and Spa, Inc.

1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 W. Los Angeles Ave., Moorpark, CA 93021 • (805) 553-5000

This document is subject to change without notice.

Trademarks and Disclaimers: The Pentair Water Pool and Spa logo is a registered trademark of Pentair Water Pool and Spa, Inc. Other

trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Pentair Water Pool and Spa, Inc. disclaims any proprietary interest in trademarks and trade names other than its own.

P/N 370257 Rev. A 8/11/06