Sta-Rite BB-HCM381A Installation Manual

ScreenLogic

Interface

Video & Lighting Protocol

Adapter

*520936*

P/N 520936 - Rev B

ScreenLogic Video & Lighting Protocol Adapter User’s and Installation Guide

User’s and Installation Guide

ScreenLogic Video & Lighting Protocol Adapter User’s and Installation Guide

ScreenLogic® Interface Video & Lighting Protocol Adapter kit contents

The following items are included in the kit.

Kit contents

• ScreenLogic Interface Video & Lighting Protocol Adapter

(P/N 520854Z)

• AC/DC power adapter

• RJ45 cable

• DB9M to RJ45 adapter

• User’s and Installation Guide (this manual)

Technical Support

Sanford, North Carolina (8 A.M. to 5 P.M. ET) Moorpark, California (8 A.M. to 5 P.M. PT)

Phone: (800) 831-7133 - Fax: (800) 284-4151

Related manuals - Download the IntelliTouch® Controller ScreenLogic User’s Guide (P/N 520493) at: http://www.pentairpool.com/pdfs/ScreenLogicUG.pdf

FCC Regulatory Safety Notice - This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• Modifications not expressly approved by the party responsible for FCC compliance could void the user’s authority to operate the equipment.

IC Regulatory Notice

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Using the Light Interface

The ScreenLogic light screen displays the following light(s) controls.

Click anywhere on the light bar to set

the light intensity

Click to switch

light OFF

Click to switch light ON

1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 West Los Angeles Ave., Moorpark, CA 93021 • (800) 553-5000

IntelliTouch®, ScreenLogic® and Pentair Water Pool and Spa® are registered trademarks of Pentair Water Pool and Spa, Inc. and/or its affiliated companies in the United States and/or other countries. Unless noted, names and brands of others that may be used in this document are not used to indicate an affiliation or endorsement between the proprietors of these names and brands and Pentair Water Pool and Spa, Inc. Those names and brands may be the trademarks or registered trademarks of those parties or others.

P/N 520936 - Rev B - 01/26/2009

ScreenLogic Interface Video & Lighting Protocol Adapter User’s and Installation Guide

10. Click Done when finished.

11. Click the RED X box on the top right side of the dialog to exit the Configuration setup dialog.

12. Select the Video & Lighting Protocol Adapter in the lower dialog box as shown below.

13. Click the Start ScreenLogic button to start the ScreenLogic program.

Contents

Connection Diagram .............................................................................. 2

Connecting the Adapter ........................................................................ 3

Installing the Adapter ............................................................................ 4

Configuring the System ....................................................................... 5

Configuring the Video Camera(s) for the first time ................................ 6

Using the Video Camera Interface ......................................................... 9

Installing the Lights for the first time ................................................... 10

Using the Lights Interface ................................................................... 13

ScreenLogic Interface Video & Lighting Protocol Adapter

Using the SceenLogic Interface Video & Lighting Protocol adapter with your existing ScreenLogic system you can control up to four color video cameras to monitor your pool/spa and home areas via your ScreenLogic interface device or PC at home or remotely over the Internet. Also, using a Lighting Powerline Interface Module you can control any number of outside and inside lights.

Features:

• Remotely monitor your property via video cameras

• Control outside lights (pathway, front door, entry hallway, stairwells, garage entryway, etc.)

• Control lights inside the home

• Log on anywhere via your laptop or PC for full control

• Compatible with all IntelliTouch systems

Supported Video Cameras and Light Switches

The following video camera models and Powerline Control systems are supported for use with the ScreenLogic Video & Lighting Protocol adapter:

ScreenLogic Video &

Lighting Protocol

Adapter address

14. Click the Lighting tab to access the LIGHTING screen.

ScreenLogic Interface Video & Lighting Protocol Adapter User’s and Installation Guide

- Panasonic video camera Models: BL-C1A, BL-C111A, BB-HCM311A,

BB-HCM331A, KX-HCM110A, BB-HCM381A

Note: Panasonic video cameras are widely available for sale on the Internet

- Powerline Control Systems, PulseWorx PCS models:

Note: PCS light switches * are compatible with incondescent light bulbs only. Lights with florescent light bulbs cannot be used.

Powerline Interface Module (PIM) - Model PIM-R (Serial Interface)

Note: (*) PCS light switches are widely available on the Internet. Refer to the following links: http://www.hometech.com/brains/upb.html#PO-PIMR

http://www.hometech.com/modules/upb.html#PO-WS1D6W

ScreenLogic Interface Video & Lighting Protocol Adapter User’s and Installation Guide

Wall Switch Dimmer (600W)

Model # WS1D6

+ 4 hidden pages