Star TSP700 Installation Manual

Attaching the TSP700 vertical stand

1. Unpacking : Confirm that all accessories are included.

M3 ×12 screws (2)
(for attaching the holder plate)

M3 ×12 screw with flat washer (2)
(for attaching the holder plate)

M4 × 8 screws (2)
(for attaching the stand)

Shafts(D)

2. Attachment procedures :

Note: Ensure that power that is supplied to the printer

and that all devices connected to the printer have
been switched OFF and that the cables have been
unplugged before starting the modification. If the
AC adapter is connected to the printer, unplug it
from the main socket.
The base for setting the stand should be within a
range of

2-1. Attaching the shafts

Attach the three shafts to the printer.

±2° in reference to the horizontal direction.

Shaft(C)

Roll stoppers

Brand seal

Holder plate

Stand

Shaft(C)

Shafts(D)

2-2. Attaching the roll stoppers

Attach the two roll stoppers in the positions shown
in the figure. Ensure that any dirt has been
completely wiped away before attaching the
stoppers.

2-3. Removing the tension bar unit

Use a regular screwdriver to remove the clips at both
ends of the bar to remove the tension bar unit.

fig.1 Attaching the shafts

fig.2 Attaching the roll stoppers

fig.3 Removing the tension bar unit

2-4. Attaching the brand seal

Place the brand seal that was supplied over the
existing brand seal. (The characters on the operation
panel will be inverted when the printer is attached
to a wall or onto a stand.)

2-5. Attaching the holder plate

1 Remove the two screws from the printer as shown

in the illustration.

2 Attach the holding plate to the printer. Then tighten

the four M3 screws that were supplied to secure it
in place.
The screws fitted with flat washers are used where
the screws were previously removed.

fig.4 Attaching the brand seal

2-6. Setting the printer on the stand

Insert the two hooks on the holding plate through
the two holes on the stand. Three different positions
are available for insertion. Select the position you
require.
Once the hooks have been inserted into the holes,
secure the printer on the stand using the two screws.

2-7. Setting the roll paper in place

1 Push the cover open lever, and open the printer cover .
2 Insert the roll paper as shown.

Remove the screws

fig.5 Attaching the holder plate

fig.6 Setting the printer on the stand

fig.7 Setting the roll paper in place

80871191 VS-T700