Features
■ Three 5 V power supply options: Power jack,
ST-LINK/V2 USB connector or daughter board
■ Audio speaker and microphone connected to
DAC and ADC of STM8L152M8T6
■ 1G Byte (or more) SPI interface MicroSD card
■ 128 Mbit SPI serial Flash
2
■ I
C compatible serial interface 64 Kbit
EEPROM and SMBus temperature sensor
■ RS232 communication
■ IrDA transceiver
■ Inductor Motor Control connector
■ SWIM debug support, embedded ST-LINK/V2
■ 122x32 Dot matrix LCD connected to SPI
interface of STM8L152M8T6
■ Joystick with 4-direction control and selector
■ Reset, Tamper and User button
■ Two touch-sensing buttons
■ 4 color LEDs and one bi-color LED
■ MCU consumption measurement circuit
■ LCD glass (40seg x 8com) connected to the
on-chip LCD driver of the MCU
■ Extension connector for daughter board or
wrapping board
■ MCU voltage selectable to 3.3 V or adjustable
from 1.65 V to 3.6 V
■ IR LED and receiver
STM8L1528-EVAL
STM8L1528-EVAL evaluation board
Data brief
program memory as well as SWIM debugging
support.
The full range of hardware features on the board
is provided to help you evaluate all the MCU
peripherals (motor control, USART, microphone,
audio DAC, LCD, IR LED, IrDA, SPI Flash,
MicroSD card, temperature sensor, EEPROM…
etc.) and develop your own applications.
Extension headers make it possible to easily
connect a daughter board or wrapping board for
your specific application.
An ST-LINK/V2 is integrated on the board as
Description
The STM8L1528-EVAL evaluation board is
designed as a complete demonstration and
development platform for the STM8 core based
STM8L152M8T6 microcontroller with I2C, two
SPI channels 3 USART channels, 12-bit ADC, two
12-bit DACs, LCD driver, internal 4 KByte SRAM,
2 Kbyte data EEPROM and 64 KByte Flash
December 2010 Doc ID 18310 Rev 1 1/3
For further information contact your local STMicroelectronics sales office.
embedded in-circuit debugger and programmer
for the STM8 MCU.
Table 1. Device summary
Part number Reference
STM8L1528-EVAL
STM8L1528-EVAL evaluation
board
www.st.com
3
Revision history
Table 2. Document revision history
Date Revision Changes
09-Dec-2010 1 Initial release.
STM8L1528-EVAL
2/3 Doc ID 18310 Rev 1
STM8L1528-EVAL
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2010 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 18310 Rev 1 3/3
Loading...