Features
■ 5 V power jack supply
■ Audio play
■ Micro SD Card™
■ 64 Kbit I
■ One channel of RS-232 communication
■ Bi-color LED
■ Economic analog voltage measurement based
on comparator
■ SWIM debug support
■ 122 x 32 dot-matrix serial interface LCD
module
■ Joystick with 4-direction control and selector
■ Reset and User button
■ 3 LEDs
■ Extension connector for daughterboard
■ One 10 K potentiometer
2
C EEPROM
STM8L101-EVAL
STM8L101-EVAL evaluation board
Data brief
The full range of hardware features on the
Description
The STM8L101-EVAL is composed of two boards,
a motherboard and a daughterboard. The
STM8L1/L2 motherboard is called MB709. It
STM8L101-EVAL helps you to evaluate all
peripherals (micro SD Card, USART, EEPROM,
LCD, for example) and develop your own
applications.
includes all peripherals which are connected to
the MCU on the daughterboard and connects to
the daughterboard via two 36-pin connectors. The
STM8L1 daughterboard is called MB710 and has
an STM8L101 MCU.
The motherboard and daughterboard are a
complete development platform for the
STM8L101 microcontroller with comparator, I
2
C,
SPI, USART and SWIM debugging support.
August 2010 Doc ID 17773 Rev 1 1/4
For further information contact your local STMicroelectronics sales office.
www.st.com
4
Figure 1. Functional block diagram
STM8L101-EVAL
I2C EEPROM
SWIM connector
Bi-color LED
LED’s
Joystick
Push button
BNC connector
Potentiometer
STice connector
I2C
SWIM
GPIO’s
ADC
STM8L1/L2-MB
GPIO’s
Extension connector
STM8L101
STM8L1-DB
MCU
ADC
PWM
BEEP
USART
SPI
Compa
rator
Audio circuit
RS232
transceiver
Level
translator
Economic
Measurement
1.8 to 3.3V
regulator
STM8L1/L2-MB (MB709)
RS232
connector
MicroSD card
LCD
5V power
jack
3.3V
regulator
STM8L1-DB (MB710)
ai18610
2/4 Doc ID 17773 Rev 1
Ordering information STM8L101-EVAL
1 Ordering information
Table 1. Device summary
Order code Reference
STM8L101-EVAL STM8L101-EVAL evaluation board
2 Revision history
Table 2. Document revision history
Date Revision Changes
02-Aug-2010 1 Initial release.
Doc ID 17773 Rev 1 3/4
STM8L101-EVAL
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2010 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
4/4 Doc ID 17773 Rev 1
Loading...