STEVAL-ILD003V1
Analog wall dimmer for CFL/LED lamps based on the TS820 (EU version 220 V)
Data brief − production data
Features
■Line voltage: 198 - 264 V 50/60 Hz
■Maximum operating ambient temperature: 60 °C
■Incandescent 230 V lamp power:
–Minimum power: 20 W
–Maximum power: 350 W (without heatsinks mounted on SCRs(a))
■Dimmable lamps that can be used:
–CFL lamp (typically 14 W)
–LED lamp (typically 6 W)
■RoHS compliant
Description
The purpose of the STEVAL-ILD003V1 demonstration board is to evaluate ST’s SCR dimming solution for low-consumption lamps, particularly CFL and LED lamps, eliminating flicker, and to be able to directly test most dimmable loads currently on the market.
Through-hole technology is used for the most important components such as the LC filter, gate resistor, turn-on delay capacitor, etc., in order to allow board modification, if needed.
AC light dimmers based on SCR dimming technology eliminate flickering as a continuous current is applied through the gate. An SCR dimmer could easily replace a standard low-cost analog Triac light dimmer by using a Diaccontrolled circuit.
a.Higher power could be reached with a different filter inductor and SCR heatsink.
March 2012 |
Doc ID 022409 Rev 2 |
1/4 |
This is information on a product in full production. For further information contact your local STMicroelectronics sales |
www.st.com |
office. |
|
Circuit schematic |
STEVAL-ILD003V1 |
|
|
$0 Y
2/4 |
Doc ID 022409 Rev 2 |