Sprint 250U Instruction Manual
INSTRUCTION GUIDE
Inserting the
Sprint 250U 3G/4G Modem
in the Rocket Lid
Items Needed
1. 2. 3. 4. 5.
1. Rocket with New Retrofitted Lid
2. Direct Connect Cable
3. USB Extension Cord
4. Polycarbonate Lid Insert
5. Sprint 250U 3G/4G modem
Installing the Sprint Modem
• On the Sprint 250U 3G/4G modem, open the USB connector all
the way until it clicks into place.
• Plug in the Direct Connect Cable into the front port
on the left side of the modem, as shown below.
• Insert the modem’s USB Connector through the center hole,
as shown below and fold the USB connector all the way to
hold the polycarbonate lid insert in place.
• Locate the two
holes on the
polycarbonate
insert, and drop
the direct connect
cable through
the left hole.
direct
connect
slot
USB
slot
• Plug the USB extension cord into the modem, as shown
below.
utility.com
INSTRUCTION GUIDE
Installing the Sprint Modem
Continued
• Open the Rocket Lid and slide out the Hinged Lid Support.
• Close the Hinged Lid Support with both cables extending
through the center.
• Plug the USB extension cord into the Rocket
• Plug the direct connect cable into the Rocket and hand
tighten, as shown below.
• Lay the opened Rocket down with the serial number and
ports on the label facing up, as shown below.
• Position the polycarbonate insert with attached modem into
the lid as shown above with cornered foam edges entering
first.
USB
• Tuck in both cables and close the Rocket Lid.
direct connect
Contact us or visit our web site to learn more.
40 4.816.0300 • email: info@utility.com
utility.com
Loading...