Page 1
sPOD Source Installation Instructions
10 mm socket
12 mm socket
Circuit Breaker
After installation
!!!Must start engine to activate system!!!
through opening in plastic
key facing outward
2
3
6
4
www.4x4s-POD.com
• Connect Positive & Ground wire to battery terminals. Use supplied cable ties to secure all cables.
`
Run white connector up
1. Attach your accessories here.
SWx Is the Positive and GND is the negative terminals.
2. Negative battery terminal.
3. Positive battery terminal.
4. Switch panel harness input.
5. Low voltage detection circuit.
6. Low voltage detection circuit fuse. Remove this fuse to
disable LVCO
7. Accessory fuses. Any fuse can go here up to 30 AMPs. (6 pl.)
8. Relays that are removable.
Plug connector in with
Auto Reset
• If the LVCO detects a low voltage (10.6VDC) and
shuts the sPOD down, turn off all switches on sPOD
and start the vehicle to enable the sPOD again.
Always keep your engine running
whenever possible when powering
electrical accessories
1
Loading...