SoundOff Signal Predator2 WS Light Permanent Mount Headliner User Manual

HEADLINER BRACKET SYSTEM

WARNING: Warning devices are strictly

regulated and governed by Federal, State and
Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to
ensure compliance.

The PERMANENT MOUNT HEADLINER BRACKET
is designed for the Ford Crown Vic Police Interceptor.
Although it may fit other applications, the installer
assumes all responsibility for its installation.

Refer to the instructions included with the
PPRH1BKT for proper installation.

PERMANENT MOUNT

ASSEMBLY INSTRUCTIONS

EP2SWSA+(x) [single] EP2DWSA+(x) [dual]

!

WARNING

This product contains high intensity LED

devices. To prevent eye damage, DO NOT

stare into light beam at close range.

OPERATING INSTRUCTIONS

1. Plug the Predator II power cord into the vehicle
cigarette lighter plug.

Note: The Predator II protection fuse is located in

the nose of the cigarette lighter plug (not shown).
Unscrew metal retaining ring to expose fuse.

2. To activate the Predator II push the red button (#4)
on the left (driver's side) of the unit.

3. To deactivate the Predator II push and HOLD the
red button until unit turns off.

4. The Predator II can generate 33 different light
patterns (see table at right). To change light
patterns, momentarily push the red button, A,
while the unit is operating. Each push of the red
button will advance the Predator II to the next
pattern. When desired pattern is reached release
red button. That pattern will be stored in the
Predator II memory and will automatically come up
every time the unit is turned on.

Replacement Parts / Accessories

PPRH1BKT Permanent Mount Headliner Bracket

Optional Mounting Brackets

PPRDWBRKT Predator Windshield Bracket w/ Suction Cups
PZBKT248 Z Bracket for Mounting to Headliner - Permanent Mount
PPRDGMBRKT Predator Permanent Glass Mount Kit w/ Adhesive

EP2xWSA+(x) 4.08