SoundOff Signal nFORCE Oval Grommet Housing User Manual
nFORCE 6” Oval Recess Mount Grommet & Housing
PART NUMBER - PNFSLSRVMTB
SUPPLIED SCREWS x4
GROMMET
INSTALLATION INSTRUCTIONS
INSTALLATION:
1. Insert nFORCE Light into supplied housing and
1) Establish a position on the vehicle. Use the
secure using the 4 supplied screws. Do not
cutout template (provided) on 2nd page and cut
exceed 12 IN-LBF
hole. Insert grommet into cutout first and then
press the light assemble into the grommet.
2. Place grommet in hole
3. Insert bezel/light assembly into grommet,
ensuring lip of bezel is fully engaged to groove
of grommet
nFORCE LIGHT
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. Eastern Time or during extended after hours coverage between 5 p.m. & 8 p.m. Eastern
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
1.
BEZEL
IMPORTANT INFORMATION:
Time at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to techservices@soundoffsigal.com.
PNFSLSRVMTB 11.14
Loading...