SoundOff Signal LED Strip Light 90 Degree Corner User Manual

INSTALLATION

1. Using the holes in the base as a template, mark and
drill pilot holes for #10 screws (drill size #29 or 9/64).

2. If a wire entry hole is required, drill n3/8” hole for wire.
Make sure there are no burrs that can abrade the
wires.

3. After completing the wiring mount the strip light using
customer supplied mounting screws. Make sure that
wires do not bind or can be abraded by n3/8” hole.

CARGO/STORAGE LIGHT

ECVCSLLED(xx)

MOUNTING HOLES

WIRING

1. Connect the black wire to the vehicle’s ground (-) wire.

2. Connect the red wire to the vehicle’s positive
(+12Vdc) wire.

WARRANTY

Except for our limited warranty, available on our website at www.soundoffsignal.com, a hard copy of which can be obtained from SoundOff Signal upon request, all other guarantees or
warranties including the implied warranty of merchantability and the implied warranty of fitness for any particular purpose are void and of no effect, unless specifically agreed to in
writing by SoundOff Signal

ECVCSLLED(xx) 07.08