This equipment complies with the EMC Directive 2004/108/EC and LVD 2006/95/EC
Please read this manual carefully before using
your unit for the rst time.
This equipment complies with the EMC directive 2004/108/EC
and LVD 2006/95/EC
This product is approved to safety standards
IEC 60065:2005 +A1:2005
EN60065:2006 +A1:2006 + A1:2008
UL60065 7th Edition
CAN/CSA-E60065-03 +A1:2006
And EMC standards
EN55103-1: 2009 (E2)
EN55103-2: 2009 (E2)
Warning: Any modication or changes made to this device, unless explicitly approved by Harman, will
invalidate the authorisation of this device. Operation of an unauthorised device is prohibited under
Section 302 of the Communications act of 1934, as amended, and Subpart 1 of Part 2 of Chapter 47
of the Code of Federal Regulations.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
by HARMAN
* Reorient or relocate the receiving antenna
* Increase the separation between the equipment and the receiver
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help
For further details contact
Harman International Industries Ltd, Cranborne House, Cranborne Road, Potters Bar, Hertfordshire EN6 3JN, UK
Telephone +44(0) 1707 665000 Fax +44 (0)1707 660742 email: soundcraft@harman.com
All rights reserved. Parts of the design of this product may be protected by worldwide patents.
Part No. 5028913
®
Soundcraft is a trading division of Harman International Industries Ltd. Information in this manual is subject
to change without notice and does not represent a commitment on the part of the vendor. Soundcraft shall
not be liable for any loss or damage whatsoever arising from the use of information or any error contained in
this manual.
No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any
means, electronic, electrical, mechanical, optical, chemical, including photocopying and recording, for any
purpose without the express written permission of Soundcraft.
Harman International Industries Limited
Cranborne House, Cranborne Road, POTTERS BAR, Hertfordshire, EN6 3JN, UK
Soundcraft Mini Stagebox 32 User/Installation Guide 08132
CONTENTS
INTRODUCTION 4
SAFETY NOTICES 4
SAFETY SYMBOL GUIDE 4
IMPORTANT SAFETY WARNINGS 5
ELECTROSTATIC DISCHARGE (ESD) 6
IMPORTANT SAFETY INSTRUCTIONS 7
WORKING SAFELY WITH SOUND 8
FEATURES 9
MINI STAGEBOX FRONT PANEL 10
MINI STAGEBOX REAR PANEL 10
MOUNTING MINI STAGEBOX 11
MADI LINK CARD 11
CONNECTING IT UP 12
MINI STAGEBOX CONNECTING TO Vi2-Vi6 RANGE CONSOLES 12MINI STAGEBOX CONNECTING TO Si OR Vi1 CONSOLES 13
MINI STAGEBOX CONNECTING TO TWO CONSOLES 14
SPECIFICATIONS 15
WARRANTY 16
Soundcraft Mini Stagebox 32 User/Installation Guide 08133
INTRODUCTION
SAFETY NOTICES
FOR YOUR OWN SAFETY AND TO AVOID INVALIDATION OF THE WARRANTY
PLEASE READ THIS SECTION CAREFULLY.
SAFETY SYMBOL GUIDE
For your own safety and to avoid invalidation of the warranty all text marked
with these symbols should be read carefully.
WARNINGS
The lightning ash with arrowhead symbol, is intended to alert the
user to the presence of un-insulated “dangerous voltage” within
the product’s enclosure that may be of sufcient magnitude to
constitute a risk of electric shock to persons.
CAUTIONS
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating
and maintenance (servicing) instructions in the literature
accompanying the appliance.
NOTES
Contain important information and useful tips on the operation
of your equipment.
HEADPHONES SAFETY WARNING
Contain important information and useful tips on
headphone outputs and monitoring levels.
ESD WARNING
The crossed-out hand symbol is intended to alert the user to
devices sensitive to electrostatic discharge. Please refer to the
instructions on page 6.
Soundcraft Mini Stagebox 32 User/Installation Guide 08134
IMPORTANT SAFETY WARNINGS
THIS APPARATUS MUST BE EARTHED. Under no circumstances should the safety
earth be disconnected from the mains lead.
The mains supply disconnect device is the mains plug. It must remain accessible so as
to be readily operable when the apparatus is in use.
If any part of the mains cord set is damaged, the complete cord set should be
replaced. The following information is for reference only.
The wires in the mains lead are coloured in accordance with the following code:
Earth (Ground): Green and Yellow (US - Green/Yellow)
Neutral: Blue (US - White)
Live (Hot): Brown (US - Black)
As the colours of the wires in the mains lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal
in the plug which is marked with the letter E or by the earth symbol.
The wire which is coloured Blue must be connected to the terminal in the plug
which is marked with the letter N.
The wire which is coloured Brown must be connected to the terminal in the plug
which is marked with the letter L.
Ensure that these colour codes are followed carefully in the event of the plug being
changed.
This unit is capable of operating over a range of mains voltages as marked on the rear panel.
The internal power supply unit contains no user serviceable parts. Refer all servicing
to a qualied service engineer, through the appropriate Soundcraft dealer.
Soundcraft Mini Stagebox 32 User/Installation Guide 08135
ELECTROSTATIC DISCHARGE (ESD)
Many semiconductor components are sensitive to electrostatic discharge (ESD).
The lifespan of assemblies contain ing such components can be drastically reduced
by improper handling during maintenance and repair. Please observe the following
rules when handling ESD sensitive components:
ESD sensitive components should only be stored and transported in the
•
packing material specically provided for this purpose.
When performing a repair by replacing complete assemblies, the removed
•
assembly must be sent back to the supplier in the same packing material in
which the replacement assembly was shipped. If this should not be the case,
any claim for a possible refund will be null and void.
Unpacked ESD sensitive components should only be handled in ESD protected
•
areas (EPA, e.g. area for eld service, repair or service bench) and only be
touched by persons wearing a wristlet connected to the ground potential of the
repair or service bench by a series resistor. The equipment to be repaired or
serviced as well as all tools and electrically semi-conducting work, storage, and
oor mats should also be connected to this ground potential.
The terminals of ESD sensitive components must not come in uncontrolled
•
contact with electro statically chargeable or metallic surfaces (voltage puncture,
discharge shock hazard).
To prevent the components from undened transient stress and possible
•
damage due to inadmissible voltages or compensation currents, electrical
connections should only be established or separated when the equipment is
switched off and after any capacitor charges have decayed.
Soundcraft Mini Stagebox 32 User/Installation Guide 08136
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.