To prevent fire or shock hazard, do
not expose the player to rain or
moisture.
This symbol is intended to alert
the user to the presence of
uninsulated “dangerous voltage”
within the product's enclosure
that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert
the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
Information
For customers in the United States
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced
radio/TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
CAUTION
The use of optical instruments with this
product will increase eye hazard.
WARNING
Do not install the appliance in a confined
space, such as a bookcase or built-in cabinet.
For customers in Canada
To prevent electric shock, match wide blade
of plug to wide slot, fully insert.
Introduction2
Owner's Record
The model number is located at the bottom
and the serial number is located in the battery
compartment.
Record the serial number in the space
provided below. Refer to these numbers
whenever you call upon your Sony dealer
regarding this product.
Model No. ZS-X7
Serial No.
Table of contents
Basic Operations
4Playing a CD
6Listening to the radio
The CD Player
8 Using the display
9 Locating a specific point in a
track
10 Playing tracks repeatedly
(Repeat Play)
11 Playing tracks in random order
(Shuffle Play)
12 Creating your own program
(Program Play)
14 Preventing sound from skipping
(ESP)
The Radio
15 Presetting radio stations
16 Playing preset radio stations
Basic Operations
Setting Up
22 Preparing the power sources
25 Using the shoulder strap
26 Selecting the audio emphasis
(SOUND/MEGA BASS)
Additional Information
27 Precautions
29 Troubleshooting
31 Maintenance
32 Specifications
33 Index
The Timer
17 Setting the clock
18 Waking up to music
20 Falling asleep to music
21 Using the countdown timer
3Introduction
Basic Operations
Playing a CD
1
2, 3, 4
Connect the supplied AC power adaptor (see page 23).
1Press POWER to turn on the
player.
2Turn the lid of the CD
compartment counterclockwise
and open it.
5
3Place the CD on the CD
compartment until it clicks into
place.
Basic Operations4
With the label side
facing to you
4Close the lid of the CD
compartment and turn it
clockwise until the
player and the
z mark on the
z mark on the lid
align.
5Press u.
The player plays all the tracks
once.
Basic Operations
Tip
You can change the
angle of your player.
Track number
Playing time
Use these buttons for additional operations
POWER
u
VOL –, +
., >
x
ToDo this
adjust the volumePress VOL +, –.
stop playbackPress x.
pause playbackPress u.
Press the button again to
resume play after pause.
go to the next trackPress >.
go back to the previous trackPress ..
remove the CDTurn the lid of the CD
compartment
counterclockwise and
open it.
turn on/off the playerPress POWER.
Basic Operations
5
Listening to the radio
2
Connect the supplied AC power adaptor (see page 23).
31
1Press POWER to turn on the
player.
2Press BAND until the band you
want appears in the display.
Display
3Hold down TUNING•TIME SET
+ or – until the frequency digits
begin to change in the display.
The player automatically scans
the radio frequencies and stops
when it finds a clear station.
If you can't tune in a station,
press the button repeatedly to
change the frequency step by
step.
Basic Operations6
Indicates an FM stereo
broadcast
Use these buttons for additional operations
POWER
PLAY MODE
MONO/ST
VOL –, +
Basic Operations
Tips
• If the FM broadcast is
noisy, press PLAY
MODE•MONO/ST
until “Mono” appears in
the display and the
radio will play in
monaural.
• You can change the
angle of your player.
ToPress
adjust the volumeVOL +, –
turn on/off the radioPOWER
To improve broadcast reception
Reorient the antenna for FM. Reorient the player itself
for AM.
for FM
for AM
Basic Operations
7
The CD Player
Using the display
You can check information about the CD
using the display.
Checking the total track number and playing
time
Press DISPLAY•ENT MEM in stop mode.
Total playing time
Total track number
DISPLAY
ENT MEM
Checking the remaining time
Press DISPLAY•ENT MEM while playing a CD.
To display
the current track numberonce
and the remaining time
on the current track*
the number of tracks lefttwice
and remaining time on the CD
the current track numberthree times
and playing time
* For a track whose number is more than 20, the remaining
time appears as “– –:– –”.
The CD Player8
Press
DISPLAY•ENT MEM
Locating a specific
point in a track
You can quickly find a specific point in
a track while playing a CD.
To locatePress
a point while listening to> (forward) or .
the sound(backward) while playing
a point while observing> (forward) or .
the display(backward) in pause and
., >
The CD Player
and hold down until you
find the point
hold down until you find
the point
The CD Player9
Playing tracks
repeatedly
(Repeat Play)
You can play tracks repeatedly in
normal, shuffle or program play
modes (see pages 11 - 13).
1 Press POWER to turn on the player.
2 Press x.
3 Proceed as follows.
POWERx., >u
“Cd” appears in the display.
To repeatDo this
a single track1 Press PLAY MODE•
all the tracks1 Press PLAY MODE•
tracks in random order1 Press PLAY MODE•
programed tracks1 Press PLAY MODE•
PLAY MODE
MONO/ST
MONO/ST until “REP 1”
appears.
2 Press . or > to select
the track that you want to
repeat.
3 Press u.
MONO/ST until “REP
ALL” appears.
2 Press u.
MONO/ST until “SHUF
REP” appears.
2 Press u.
MONO/ST until “PGM
REP” appears.
2 Program tracks (see step 4
on page 12).
3 Press u.
To cancel Repeat Play
Press PLAY MODE•MONO/ST until “REP”
The CD Player10
disappears from the display.
Playing tracks in
random order
(Shuffle Play)
POWERxu
PLAY MODE
MONO/ST
You can play tracks in random order.
1 Press POWER to turn on the player.
2 Press x.
“Cd” appears in the display.
3 Press PLAY MODE•MONO/ST until “SHUF”
appears in the display.
4 Press u to start shuffle play.
To cancel Shuffle Play
Press PLAY MODE•MONO/ST until “SHUF”
disappears from the display.
The CD Player
The CD Player11
Loading...
+ 25 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.