Sony XS-F1020SL User Manual
Specifications
3-046-197-11 (1)
Speaker Coaxial 2-way:
Maximum input power 80 W
Rated input power 25 W
Impedance 4 ohms
Sensitivity 89 dB/W/m
Frequency response 45 – 30,000 Hz
Mass Approx. 480 g per speaker
Design and specifications are subject to change without notice.
Dimensions
Woofer 10 cm, polypropylene cone type
Tweeter 2.5 cm
PEI, balance dome type
ø 136
,
4 – 5 × 7
ø 117
103
ø
ø 102
ø 70
ø 90
10cm Coaxial
2-way Speaker
Instructions
ø 102
16.5
1.8 49.3*
* Mounting depthUnit: mm
XS-F1020SL
Sony Corporation 2000 Printed in China
Precautions
•Do not continuously drive the speaker system over the power handling capacity.
•Keep recorded tapes, watches, and personal credit cards using magnetic coding away from the
speaker system to protect them from damage caused by the magnets in the speakers.
If you cannot find an appropriate mounting location, consult your car dealer or your nearest Sony
dealer before mounting.
Mounting
Before Mounting
•A depth of at least 49.3 mm is required for mounting the woofer. Keep the following in mind when
choosing a mounting location.
•A hole may already be provided in the metal frame of the front door.
•Nothing should interfere with the speaker inside the door.
•The speaker inside the door must not come into contact with the window when it is open.
•Be careful that speakers are out of the way of the window cranks, door handles, and arm rests.
If you cannot find an appropriate mounting location, check with your car dealer or consult the
nearest Sony dealer.
Parts List
1
4
23
× 1
5
2.5 m
× 2
6
M4 × 30
× 8
Mounting example
1
Mark the four bolt holes. Make them 3.3 mm* in diameter.
* When using 4 = 5 mm
1
c
ø3.3 mm*
ø 104
2
Remove the grille net.
× 8
× 2
× 2
6
5
3
5
Black-striped cord
*
2
Power amplifier, etc.
Press and insert the edges of the grille net.
* White cord — Left speaker
Grey cord — Right speaker
6
4
3
5
How to remove the grille net
Speaker
4
Door panel
6
5
5
Flat mounting (installed flush with the surface of the dash)
This speaker can be made to fit almost any type of car by removing the mounting tabs.
Use clippers or pliers, etc. to cut or snap the mounting tabs off so that it is even with the edge
of the speaker frame as illustrated.
Notes
After removing the mounting tabs, handle the speaker frame with care, as the edges may be sharp.
ø 91 mm
Loading...