Sony XBR-55X850C, KDL-75W850C, KDL-65W850C, KDL-55W800C Wall-Mount Installation in Portrait Orientation

To Customers and Sony Dealers

Wall-Mount Bracket

C-250-100-12(1)

Wall-Mount Installation in Portrait Orientation

Installation du support de fixation murale dans l’orientation portrait

Instalación del soporte de montaje mural en posición vertical

GB

FR

ES

SU-WL500

© 2015 Sony Corporation

Thank you for purchasing this product.

To Cus tomer s

Sufficient expertise is required for installing this
product. Be sure to subcontract the installation to
Sony dealers or licensed contractors and pay
special attention to safety during the installation.
Sony is not liable for any damages or injury
caused by mishandling or improper installation, or
installing any other than the specified product.
Your Statutory Rights (if any) are not affected.

On Safety

Products by Sony are designed with safety in mind. If
the products are used incorrectly, however, it may
result in a serious injury through fire, electric shock,
the product toppling over, or the product dropping.
Be sure to observe the precautions for safety to
prevent such accidents.

CAUTION

WARNING

Specified products

The following products are subject to change

If the safety precautions are not observed or the
product is used incorrectly, it may result in serious
injury or fire.

This manual shows the correct handling of the
product and important precautions necessary to
prevent accidents. Be sure to read this manual
thoroughly and use the product correctly. Keep this
manual available for future reference.

without notice, may be out of stock, or
discontinued.
Also, certain models are sold in some regions.

XBR-75X850C
XBR-65X850C

LCD Color TV

XBR-55X850C
KDL-75W850C
KDL-65W850C
KDL-55W800C

To Sony dealers

Sufficient expertise is required for installing this
product. Be sure to read this manual thoroughly to do
the installation work safely. Sony is not liable for any
damages or injury caused by mishandling or
improper installation. Please give this manual to the
customer after installation.

To install the TV to the wall in portrait orientation, the SU-WL500 Wall-Mount Bracket, spacers, and screws listed
below are necessary.
For further details/terms & conditions, contact the sales representative for professional use.

TV model

XBR-75X850C

XBR-65X850C

XBR-55X850C

KDL-75W850C

KDL-65W850C

KDL-55W800C No need –

Wall-Mount Bracket Spacer Screw

Model Qty Specification Qty Specification Qty

Washer with an

outside diameter of 18

mm, inside diameter

of 10 mm, and

SU-WL500 1

thickness of 2 mm

(SONY Part Number

7-688-000-32)

2 (GB)

20

PSW M6×25 mm

(SONY Part Number

4-577-327-01)

Supplied with

SU-WL500

4

4

WARNING

Unit: mm (inches)

300

(11

7

/8)

100

(4)

100

(4)

100

(4)

If the following precautions are not observed,
serious injury or death through fire, electric
shock, the product toppling over, or the
product dropping can result.

Be sure to read thoroughly the all safety information
described in the instruction manual of SU-WL500.
Do NOT use SU-WL450 for installation in portrait
orientation.

Provide adequate clearances
around the TV.

The following illustration shows how much space is
required around the TV.

Others

• When installing in portrait orientation, only the
following input/output jacks are available:
– HDMI IN 1/2/3/4 jacks (4K supported)
– MHL jack (shared with the HDMI IN 2 jack)
– DIGITAL AUDIO OUT (OPTICAL) jack
–AUDIO OUT / jack
–  LAN connector
– (USB 1/2) ports, (USB 3) port

• If you cover the illumination LED and its
surroundings with tapes or other objects, the
status of the TV cannot be recognized and the
remote control may not work.

• When carrying the TV, hold it in landscape
orientation, and take care not to drop it when
installing. Do not apply excessive force to the TV;
otherwise, it may be deformed.

GB

English

Use the TV within the operating
temperature range.

The operating temperature is 0°C to 35°C (When
using XBR-55X850C, set the Brightness setting to
Standard or Custom 44/50 or below).

Do not block the ventilation holes of
the TV.

If you block the ventilation holes with tapes or other
objects, heat builds up inside the TV and may cause a
fire.

3 (GB)

Step 1:

Soft cloth

1.5 N·m {15 kgf·cm}

Wall-Mount
Attachment

Step 4:

Checking the parts
required for the
installation

Follow Step 1 in the SU-WL500 instruction manual to
check the parts.

Step 2:
Deciding on the

installation location

Follow Step 2 in the SU-WL500 instruction manual to
decide on the installation location. Refer to page 8 of
this manual for the TV installation dimension table.

Preparing for the
installation of the TV

(For XBR-75X850C/XBR-

1

65X850C/KDL-75W850C/KDL­65W850C only) Remove four
screws from the rear of the TV.

Step 3:
Installing the Base

Bracket on the wall

Follow Step 3 in the SU-WL500 instruction manual to
install the Base Bracket.

(For KDL-55W800C only) Attach

2

the Wall-Mount Attachment
(supplied with the TV) to the rear
of the TV (to make it parallel
with the wall).

4 (GB)

When using an electric screwdriver, set the torque

Screw
(+PSW6 × 25)
(not supplied)

Mounting
Hook

Five spacers
(not supplied)

Notes

setting to approximately 2 N·m {20 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the TV cabinet.

Referring to the Screw and Hook

3

locations diagram/table on
page 9, determine the screw
positions, and secure the
Mounting Hook to the rear of the
TV.

 Secure the Mounting Hook to the rear of the

TV temporarily, using the four screws (+PSW6
× 25).

 Be sure that both screws are securely

tightened with equal torque strength to the
rear of the TV.

Make sure that the screw 

4

firmly secures the arm base of
the Mounting Hook (both left
and right).

• When installing in portrait orientation, be sure to
keep the Mounting Hook angle to 0 degrees. Do
not use another angles.

• Make sure that the two arm bases are screwed in
securely.

5 (GB)

Step 5:

WARNING

Notes

WARNING

Mounting Hook

Base Bracket

Installing the TV on the
wall

Install the TV onto the Base

2

Bracket.

 Referring to the Screw and Hook locations

diagram/table on page 9, determine the
holes of the Base Bracket for latching the
upper hooks of the Mounting Hook.

 Hold the TV securely with both hands, and

gently align it on the wall.

Be sure to complete the installation before
connecting the AC power cord to the wall outlet. If
you allow the AC power cord to be pinched under
or between pieces of equipment, this may result
in a short circuit or an electric shock.
Be careful not to stumble over the AC power cord
or the TV, as you may hurt yourself.

Connect the AC power cord and

1

the connecting cable(s) supplied
with the TV to the TV.

Connect the AC power cord and the connecting
cable(s) to the connectors on the rear of the TV.
For details on connecting the AC power cord
and the connecting cable(s), refer to the
instruction manual of the TV.

• You cannot connect the cables to the TV after
installing it on the Base Bracket.

• Subcontract the cable routing in the wall to a
licensed contractor.

• Be sure that two or more persons hold the TV when
carrying it.

• When carrying the TV, hold it in landscape
orientation, and take care not to drop it when
installing. Do not apply excessive force to the TV;
otherwise, it may be deformed.

6 (GB)

Firmly secure the TV and the

Note

Screw
(+BVST4 × 12)

WARNING

Be sure to tighten the securing screw firmly.
If you fail to do so, the TV may fall when it is
pushed upward and cause injury.

3

Base Bracket using the screw
supplied with SU-WL500
(+BVST4 × 12).

Confirming the
completion of the
installation

Follow the instructions in the SU-WL500 instruction
manual to confirm.

When removing the TV

Follow the instructions in the SU-WL500 instruction
manual to remove.

When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.

7 (GB)

WARNING

TV installation dimensions table

Screen center point

Front view Side view

The table below shows the dimensions of the TV that is mounted on this product. Refer to this table to decide
on the installation location.

Unit: mm (inches)

Length for each

mounting angle

Angle (0º)

1,009

(39 3/4)

898

(35 3/8)

739

(29 1/8)

1,010

(39 7/8)

899

(35 1/2)

786

(31)

141

(5 5/8)

141

(5 5/8)

122

(4 7/8)

141

(5 5/8)

141

(5 5/8)

121

7

/8)

(4

XBR-75X850C

XBR-65X850C

XBR-55X850C

KDL-75W850C

KDL-65W850C

KDL-55W800C

Model Name

Display dimensions Screen center dimensions

      

970

1

/4)

(38

844

1

/4)

(33

722

1

/2)

(28

969

1

/4)

(38

843

1

/4)

(33

715

1

(28

/4)

1,675

(66)

1,453

(57 1/4)

1,236

(48 3/4)

1,677

(66 1/8)

1,455

(57 3/8)

1,230

(48 1/2)

171

3

/4)

(6

171

(6 3/4)

121

(4 7/8)

171

(6 3/4)

171

(6 3/4)

171

(6 3/4)

192

(7 5/8)

130

(5 1/8)

35

(1 7/16)

192

(7 5/8)

130

(5 1/8)

53

(2 1/8)

300

(11 7/8)

300

(11 7/8)

335

(13 1/4)

300

(11 7/8)

300

(11 7/8)

314

(12 3/8)

Some models may not be available in certain regions.
Figures in the above table may differ slightly depending on the installation.

The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of
the TV.
Refer to your TV’s instructions for its weight.

8 (GB)