Sony Trinitron KV-H29TF User Manual

3-860-682-11 (1)



Trinitron Color TV

#############

KV-H29TF

1997 by Sony Corporation

20 mm

3.8 mm

2

(

MONO

AUTO

L

R

)

3

ENTER

PROGR

– MENU+

AUTO

PROGR

AUT O P ROGRAM
PR: 01

TV SYS: D / K
VHF LO W

1

21

3

4

WARNING Table of contents

• Dangerously high voltages are present inside the TV.

• Operate the TV only at 110-240 V AC.

• Do not open the cabinet and the rear cover of the TV.
Refer servicing to qualified personnel.

• To prevent fire or shock hazard, do not expose the TV
to rain or moisture.

• Do not operate the TV if any liquid or solid object
falls into it. Have it checked immediately by qualified
personnel only.

• Do not block the ventilation openings.

• Do not install the appliance in a confined space, such
as a bookcase or built-in cabinet.

• Do not install the TV in hot, humid or excessively
dusty places.

• Do not install the TV where it may be exposed to
mechanical vibrations.

• Do not keep the TV plugged in if you are not going to
use it for several days.

• Do not pull the power cord to disconnect the TV. Pull
it out by the plug.

• Use only the supplied screws (as shown on page 2) to
fasten the TV to the TV stand or to stabilize the TV
against a wall or a pillar. Use of other screws may
damage the TV.

Getting Started

6 Connections
8 Introducing the menus
9 Changing the menu language

10 Presetting channels

Operations

12 Watching the TV
14 Adjusting the picture and sound
16 Listening to the woofer sound (3D WOOFER)
17 Listening to the surround sound (SURROUND)
18 Customizing the TV

Additional Information

19 Troubleshooting
Back cover Specifications

EN

Note on the remote commander

• The supplied remote commander is used on several models of
the TV. If you do not find instructions for some controls that
are on the remote commander, that means your TV does not
employ the features of those controls, e.g.

Notes

• When you turn on the TV, you may hear the “boon” sound
that is caused by the demagnetization of the TV. This does not
indicate a malfunction.

• The picture color may become abnormal if you change the
direction of your TV. To obtain the normal picture color, press
U on the TV to turn off the TV for five minutes and then turn it
on again.

.

All contents are subject to change without notice.
Design and specificafions are subject to change without
notice.

Getting Started

5

-EN

Getting Started

Connections

Connecting the 3D WOOFER

1 Attach the 3D WOOFER into the footholds on the top of the TV.
2 Connect the wires to the 3D WOOFER (8Ω) terminals at the rear of the TV.

The red wire should be connected to the ‘ red terminal and the black wire to the ’ black terminal.

3D WOOFER

1

Notes

• Connect only the supplied 3D WOOFER; otherwise the TV may malfunction.

• Unplug the TV from the wall outlet when connecting the 3D WOOFER.

• Make sure that none of the 3D WOOFER wire strands stick out, making contact with the neighbouring speaker terminal, to prevent a
malfunction caused by a short circuit of the terminals.

2

Black wire

Red wire

Connecting a VHF antenna or a combination VHF/UHF antenna
— 75-ohm coaxial cable (round)

Attach an optional IEC antenna connector to the 75-ohm coaxial cable.
Plug the connector into the (antenna) socket at the rear of the TV.

Rear of TVRear of TV

or

Getting Started

-EN

6

On a wall