5-013-006-41(1)
Wireless Speaker
Reference Guide
SRS-XB43
©2020 Sony Corporation
Printed in China
https://www.sony.net/
English Wireless speaker
Before operating the unit, please read this guide thoroughly and retain it for future reference.
Please access the following URL and read the contents of the END USER LICENSE AGREEMENT.
https://rd1.sony.net/help/speaker/el20/h_zz/
CAUTION
To reduce the risk of fire or electric shock, do not expose the AC adaptor to dripping or splashing, and
do not place objects filled with liquids, such as vases, on the AC adaptor.
Do not expose the appliance to naked flame sources (for example, lighted candles).
Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.
As the main plug of the AC adaptor is used to disconnect the AC adaptor from the mains, connect it to
an easily accessible AC outlet. Should you notice an abnormality in it, disconnect it from the AC outlet
immediately.
The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
Do not expose the batteries (battery pack or batteries installed) to excessive heat such as sunshine, fire
or the like for a long time.
Do not expose the batteries to extreme low temperature conditions that may result in overheating and
thermal runaway. Do not dismantle, open or shred secondary cells or batteries. In the event of a cell
leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash
the affected area with copious amounts of water and seek medical advice. Do not use any charger other
than that specifically provided for use with the equipment. Secondary cells and batteries need to be
charged before use. Always use the correct charger and refer to the manufacturer’s instructions or
equipment manual for proper charging instructions. After extended periods of storage, it may be
necessary to charge and discharge the cells or batteries several times to obtain maximum performance.
Dispose of properly.
Do not place this product close to medical devices
This product (including accessories) has magnet(s) which may interfere with pacemakers, programmable
shunt valves for hydrocephalus treatment, or other medical devices. Do not place this product close to
persons who use such medical devices. Consult your doctor before using this product if you use any
such medical device.
This equipment has been tested and found to comply with the limits set out in the EMC regulation using
a connection cable shorter than 3 meters.
Caution on charging
Inserting the USB plug while it is wet may cause a short circuit due
to foreign matter or liquid (tap water, salt water, soft drinks, etc.)
getting on the main unit or charging cable. This may cause
malfunctions or abnormal overheating.
Never insert the USB plug while the main unit or
charging cable is wet.
Precautions
On safety
If your skin touches the AC adaptor or this product for a long time when the power is on, it may cause
a low temperature injury.
Important information such as the model name is located as follows:
– On the inner surface of the cap on the rear side of the unit
– On the surface of the AC adaptor
On the AC adaptor
Use only the supplied AC adaptor. To avoid damaging the unit, do not use any other AC adaptor.
On placement
To eliminate the risk of malfunctions, avoid the following locations when placing or leaving this unit.
– A place subject to high temperatures, such as under direct sunlight or lighting equipment, near a
heat source, or in a sauna
– Inside a vehicle with the windows closed (especially in summertime)
– A place subject to excessive dust
– A place subject to strong vibration
Place this unit on a flat, level surface. When placed on a sloped surface, the unit may fall over or fall
off the surface due to its own vibration, resulting in injuries, malfunctions, or performance
degradation.
Depending on the conditions where this unit is placed, it may fall over or fall off the surface. Do not
leave any valuables near the unit.
This unit is not anti-magnetic. Keep objects susceptible to magnetism (recorded tapes, watches, cash
cards and credit cards with magnetic coding, etc.) away from the unit. When you carry around the
unit, keep this in mind as well.
Others
Do not use or leave the unit in an extremely cold or hot environment (temperature outside the range
of 5 °C – 35 °C). If the unit is used or left in outside the above range, the unit may automatically stop to
protect internal circuitry.
At high temperature, the charging may stop or the volume may reduce to protect the battery.
Even if you do not intend to use the unit for a long time, charge the battery to its full capacity once
every 6 months to maintain its performance.
About the Voice Guidance
IMPORTANT: THE SOUND GUIDANCE IS AVAILABLE IN THIS PRODUCT ONLY IN ENGLISH
Depending on the status of the unit, the voice guidance outputs from the unit as followings.
When entering pairing mode: “BLUETOOTH pairing”
When establishing a BLUETOOTH connection: “BLUETOOTH connected”
When disconnecting a BLUETOOTH connection: “BLUETOOTH disconnected”
When pressing the BATT (battery) button to check the battery power during the unit is turned on:
“Battery fully charged/Battery about 70%/Battery about 50%/Battery about 30%/Please charge”
When pressing and holding the ST PAIR button during the Stereo Pair function: “Left/Right”
On Copyrights
Android, Google Play and other related marks and logos are trademarks of Google LLC.
LDAC™ and LDAC logo are trademarks of Sony Corporation.
The BLUETOOTH® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
and any use of such marks by Sony Corporation is under license.
The N-Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States and in
other countries.
Apple, the Apple logo, iPhone, iPod and iPod touch are trademarks of Apple Inc., registered in the U.S.
and other countries.
App Store is a service mark of Apple Inc., registered in the U.S. and other countries.
Use of the Made for Apple badge means that an accessory has been designed to connect specifically
to the Apple product(s) identified in the badge, and has been certified by the developer to meet
Apple performance standards. Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
Please note that the use of this accessory with an Apple product may affect wireless performance.
USB Type-C® and USB-C® are trademarks of USB Implementers Forum.
Other trademarks and trade names are those of their respective owners.
™ and ® marks are omitted in the documents.
Notes on waterproof and dust proof features
(Read before using the unit)
Waterproof and dust proof performance of the unit
The unit, with the cap fastened securely, has a waterproof specification of IPX7*1 as specified in “Degree
of protection against water immersion” of the IEC60529 “Ingress Protection Rating (IP Code)”*
dust proof specification of IP6X*
2
as specified in “Degrees of protection against solid foreign objects”*3.
Liquids that the waterproof performance specifications apply to
Applicable fresh water, tap water, pool water, salt water
Not applicable liquids other than the above (soapy water, water with detergent or bath
1
IPX7 (Degree of protection against water immersion): For details, refer to the Help Guide.
*
*2 IP6X (Degrees of protection against dust): For details, refer to the Help Guide.
*3 The supplied accessories and the connectors of this unit (USB/AUDIO IN) are neither waterproof nor
dust proof. To reduce the risk of fire or electric shocks, do not expose the unit to water or droplets
while using either or both of the connectors (USB/AUDIO IN). Do not place a vase or any other
liquid-filled container on the unit.
The waterproof and dust proof performance of the unit is based on our measurements under the
conditions herein described. Note that malfunctions as a result of water immersion or dust intrusion
caused by misuse by the customer are not covered by the warranty.
agents, shampoo, hot spring water, etc.)
3
, and a
To avoid deterioration of waterproof and dust proof performance
Check the following and use the unit correctly.
This unit does not have a design that is resistant to water pressure. Use of the unit in a location where
high water pressure is applied, such as in the shower, may cause a malfunction.
Do not pour high-temperature water or blow hot air from a hair dryer or any other appliance on the
unit directly. Also never use the unit in a place subject to high temperatures, such as in a sauna or
near a heat source.
Handle the cap with care. The cap plays a very important role in maintenance of the waterproof and
dust proof performance. When using the unit, make sure that the cap is closed completely. When
closing the cap, be careful not to allow foreign objects inside. If the cap is not closed completely the
waterproof and dust proof performance may deteriorate and may cause a malfunction of the unit as a
result of water or dust particles entering the unit.
Passive
radiator
How to care for the unit
Although the fabric part of the unit has water repellent treatment applied, you can use the unit more
comfortably and for a longer period of time by following the maintenance procedure below.
If the surface of the unit gets dirty in the following cases, wash the unit with fresh water (tap water,
etc.) promptly to remove the dirt. Leaving dirt on its surface may cause the fabric part or the passive
radiator section to discolor or deteriorate, or the unit to malfunction.
Ex.
When salt, sand, etc. is stuck on the unit after using it on a beach, pool side, etc.
When the unit is stained with foreign substances (sunscreen, suntan oil, etc.)
If the unit gets wet, wipe off the moisture using a dry soft cloth immediately. In addition, dry the unit
in an airy place until no moisture remains.
The sound quality may change when water enters the speaker or passive radiator section of the unit.
It is not malfunction. Wipe off the moisture on its surface, and put the unit on a dry soft cloth to drain
the collected water inside the unit. Then, dry the unit in an airy place until no moisture remains.
Note
If the surface of the unit gets dirty, do not use detergent, thinner, benzine, alcohol, etc. to clean the
unit because it will affect the water repellent function of the fabric part of the unit.
Especially in cold regions, be sure to wipe off the moisture after using the unit. Leaving moisture on
its surface may cause the unit to freeze and malfunction.
If sand grains, etc. enter the fabric or other part of the unit, remove them carefully. Never use a
vacuum cleaner, etc. on the unit. It may cause damage of the speaker section or other part of the unit.
Notes on the License
This product contains software that Sony uses under a licensing agreement with the owner of its
copyright. We are obligated to announce the contents of the agreement to customers under
requirement by the owner of copyright for the software.
Please access the following URL and read the contents of the license.
https://rd1.sony.net/help/speaker/sl/20/
Notice on GNU GPL/LGPL applied software
This product contains software that is subject to the following GNU General Public License
(hereinafter referred to as “GPL”) or GNU Lesser General Public License (hereinafter referred to as
“LGPL”). These establish that customers have the right to acquire, modify, and redistribute the
source code of said software in accordance with the terms of the GPL or LGPL supplied. The source
code for the above-listed software is available on the Web.
To download, please access the following URL then select the model name “SRS-XB43”.
URL: http://oss.sony.net/Products/Linux/
Please note that Sony cannot answer or respond to any inquiries regarding the content of the
source code.
Cap
Compatible BLUETOOTH Profiles*2
Supported Codec*
Transmission range (A2DP)
1
The actual range will vary depending on factors such as obstacles between devices, magnetic fields
*
around a microwave oven, static electricity, reception sensitivity, aerial’s performance, operating
system, software application, etc.
2
BLUETOOTH standard profiles indicate the purpose of BLUETOOTH communications between devices.
*
*3 Codec: Audio signal compression and conversion format
Note
Depending on the network environment, there may be an interruption at the high bitrate transmission.
Microphone
Type Electret condenser
Directional characteristic
Effective frequency range
General
Input AUDIO IN jack (stereo mini jack)
DC OUT USB jack Type A (for charging the battery of a connected device)
Power DC 5 V (using the supplied AC adaptor connected to AC 100 V - 240 V,
Lithium-ion battery life (with playback via a BLUETOOTH connection)
Dimensions (including projecting parts and controls)
Mass Approx. 2.95 kg including battery
Supplied accessory AC adaptor (AC-E0530MC) (1)
4
Measured value acquired by playing our specified music source with the volume level of the unit set
*
to 31, the sound mode set to STAMINA, and the illumination turned off.
5
Measured value acquired by playing our specified music source with the volume level of the unit set
*
to 30 and with the factory default settings (illumination: ON and sound mode: EXTRA BASS).
6
Measured value acquired by playing our specified music source with the volume level of the unit set to
*
maximum and with the factory default settings (illumination: ON and sound mode: EXTRA BASS).
7
Actual performance time may vary from the listed time due to the volume, songs played, surrounding
*
temperature, and usage conditions.
Compatible iPhone/iPod models
iPhone XS Max, iPhone XS, iPhone XR, iPhone X, iPhone 8 Plus, iPhone 8, iPhone 7 Plus, iPhone 7,
iPhoneSE, iPhone 6s Plus, iPhone 6s, iPhone 6 Plus, iPhone 6, iPhone 5s, iPod touch (6th generation)
The unit is compatible with iOS 10.0 or later.
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio Video Remote Control Profile)
HSP (Headset Profile)
HFP (Hands-free Profile)
3
SBC (Subband Codec)
AAC (Advanced Audio Coding)
LDAC
20 Hz - 20,000 Hz (Sampling frequency 44.1 kHz)
Omni directional
100 Hz - 7,000 Hz
(DC 5 V, Max.1A)
50Hz/60Hz power supply) or, DC 5 V (using a commercially-available USB AC
adaptor capable of feeding in 3.0 A) or, using built-in lithium-ion battery
4 *7
6 *7
5 *7
Approx. 24 hours*
Approx. 14 hours*
Approx. 4 hours*
Approx. 325 mm × 123 mm × 117 mm (w/h/d)
Plug (1)
Design and specifications are subject to change without notice.
Specifications
Speaker section
Woofer unit Approx. 61 mm × 68 mm (2)
Tweeter unit Approx. 20 mm dia. (2)
Enclosure type Passive radiator model
BLUETOOTH
Communication System
Maximum communication range
Frequency band 2.4 GHz band (2.4000 GHz - 2.4835 GHz)
Modulation method FHSS
BLUETOOTH Specification version 5.0
Line of sight approx. 30 m*
1
Loading...