4-747-828 -42(1)
Wireless Speaker
Reference Guide
SRS-XB32
©2019 Sony Corporation
Printed in China
https://www.sony.net/
Before operating the unit, please read this guide thoroughly and retain it for future reference.
CAUTION
This equipment has been tested and found to comply with the limits set out in the EMC regulation
using a connection cable shorter than 3meters.
Caution on charging
When the USB plug is inserted in a wet condition, a short circuit
occurs due to the liquid (tap water, salt water, refreshing drink etc.)
attached to the main unit and charging cable or foreign matter, it
may cause abnormal heat generation or malfunction.
Never insert USB plug when the main unit or charging
cable is wet condition.
Precautions
On safety
If your skin touches this product for a long time when the power is on, it may cause a low
temperature injury.
Important information such as the model name is located inside of the cap on the rear side of the
unit.
About the Party Booster function
If the unit hits a person or thing, it may cause an accident, injury or
malfunction. When using the Party Booster function, notice the
following.
Be sure to disconnect the micro-USB cable, etc. from the unit.
Be sure to close the cap when using the unit.
When using the function, hold firmly and do not shake the unit
violently so that you do not throw or drop the unit from your hand.
Before using the function, make sure that you have secured sufficient
space around the unit.
Do not hit the unit with a tool.
Do not use the function while you are driving or walking.
Keep 20 cm or more away from the face and eyes while in use.
Avoid using the function for a long time. Take breaks regularly.
When using the function, if you get tired, feel uncomfortable or
experience pain somewhere in your body, stop using the function
immediately.
On placement
Do not set the unit in an inclined position.
Do not leave the unit in a place subject to high temperatures, such as direct sunlight, near a heat
source or under lighting equipment.
Do not leave any objects susceptible to magnetism (cash cards, credit cards with magnetic
coding, etc.) near the unit.
Do not use or leave the unit in a car.
Others
Do not use or leave the unit in an extremely cold or hot environment (temperature outside the
range of 5 °C – 35 °C). If the unit is used or left in outside the above range, the unit may
automatically stop to protect internal circuitry.
At high temperature, the charging may stop or the volume may reduce to protect the battery.
Even if you do not intend to use the unit for a long time, charge the battery to its full capacity
once every 6 months to maintain its performance.
About the Voice Guidance
IMPORTANT: THE SOUND GUIDANCE IS AVAILABLE IN THIS PRODUCT ONLY IN ENGLISH
Depending on the status of the unit, the voice guidance outputs from the speaker as followings.
When setting the unit to the pairing mode; “Bluetooth pairing”
When pressing the BATT (battery) button to check the battery power during the unit is turned on;
“Battery fully charged/Battery about 70%/Battery about 50%/Battery about 20%/Please charge”
When the battery power is low; “Please charge”
When the settings are completed for the Speaker Add function; “Double mode”
When pressing and holding the ADD (Speaker Add) button during the Speaker Add function;
“Left/Right/Double mode”
On Copyrights
Android, Google Play and other related marks and logos are trademarks of Google LLC.
LDAC™ and LDAC logo are trademarks of Sony Corporation.
The BLUETOOTH® word mark and logos are registered trademarks owned by the Bluetooth SIG,
Inc. and any use of such marks by Sony Corporation is under license.
The N-Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States and in
other countries.
Apple, the Apple logo, iPhone, iPod and iPod touch are trademarks of Apple Inc., registered in the
U.S. and other countries.
App Store is a service mark of Apple Inc., registered in the U.S. and other countries.
Use of the Made for Apple badge means that an accessory has been designed to connect
specifically to the Apple product(s) identified in the badge, and has been certified by the
developer to meet Apple performance standards. Apple is not responsible for the operation of
this device or its compliance with safety and regulatory standards.
Please note that the use of this accessory with an Apple product may affect wireless
performance.
Other trademarks and trade names are those of their respective owners.
™ and ® marks are omitted in the documents.
Notes on waterproof and dust proof features (Read
before using the unit)
Waterproof and dust proof performance of the unit
The unit, with the cap fastened securely, has a waterproof specification of IPX7*1 as specified in
“Degree of protection against water immersion” of the IEC60529 “Ingress Protection Rating (IP
*3
, and a dust proof specification of IP6X*2 as specified in “Degrees of protection against solid
Code)”
foreign objects”
Liquids that the waterproof performance specifications apply to
Applicable fresh water, tap water, pool water, salt water
Not applicable liquids other than the above (soapy water, water with detergent or
1
IPX7 (Degree of protection against water immersion): For details, refer to the Help Guide.
*
2
IP6X (Degrees of protection against dust): For details, refer to the Help Guide.
*
3
The supplied accessories and the connectors of this unit (USB/AUDIO IN) are neither waterproof
*
nor dust proof.
The waterproof and dust proof performance of the unit is based on our measurements under the
conditions herein described. Note that malfunctions as a result of water immersion or dust
intrusion caused by misuse by the customer are not covered by the warranty.
*3
.
bath agents, shampoo, hot spring water, etc.)
To avoid deterioration of waterproof and dust proof performance
Check the following and use the unit correctly.
The unit passes the drop test from 1.22 m on plywood of 5 cm thickness conforming to MIL-STD
810 F Method 516.5-Shock. However, this does not guarantee no damage, no breakdown, or
waterproof and dust proof performance in all conditions. Deformation or damage from dropping
the unit or subjecting it to mechanical shock may cause deterioration of the waterproof and dust
proof performance.
This unit does not have a design that is resistant to water pressure. Use of the unit in a location
where high water pressure is applied, such as in the shower, may cause a malfunction.
Do not pour high-temperature water or blow hot air from a hair dryer or any other appliance on
the unit directly. Also, never use the unit in high temperature locations such as in saunas or near
a stove.
Handle the cap with care. The cap plays a very important role in maintenance of the waterproof
and dust proof performance. When using the unit, make sure that the cap is closed completely.
When closing the cap, be careful not to allow foreign objects inside. If the cap is not closed
completely the waterproof and dust proof performance may deteriorate and may cause a
malfunction of the unit as a result of water or dust particles entering the unit.
Cap
How to care for the unit
Although the fabric part of the unit has water repellent treatment applied, you can use the unit
more comfortably and for a longer period of time by following the maintenance procedure below.
If the surface of the unit gets dirty in the following cases, wash the unit with fresh water (tap
water, etc.) promptly to remove the dirt. Leaving dirt on its surface may cause the fabric part to
discolor or deteriorate, or the unit to malfunction.
Ex.
When salt, sand, etc. is stuck on the unit after using it on a beach, pool side, etc.
When the unit is stained with foreign substances (sunscreen, suntan oil, etc.)
If the unit gets wet, wipe off the moisture using a dry soft cloth immediately. In addition, dry the
unit in an airy place until no moisture remains.
The sound quality may change when water enters the speaker section of the unit. It is not
malfunction. Wipe off the moisture on its surface, and put the unit on a dry soft cloth with the
fabric part facing down to drain the collected water inside the unit. Then, dry the unit in an airy
place until no moisture remains.
Note
If the surface of the unit gets dirty, do not use detergent, thinner, benzine, alcohol, etc. to clean
the unit because it will affect the water repellent function of the fabric part of the unit.
Especially in cold regions, be sure to wipe off the moisture after using the unit. Leaving moisture
on its surface may cause the unit to freeze and malfunction.
If sand grains, etc. enter the fabric part of the unit, remove them carefully. Never use a vacuum
cleaner, etc. on the unit. It may cause damage of the speaker unit.
Specifications
Speaker section
Speaker system Approx. 48 mm dia. × 2
Enclosure type Passive radiator model
BLUETOOTH
Communication System
Maximum communication range
Frequency band 2.4 GHz band (2.4000 GHz - 2.4835 GHz)
Modulation method FHSS
Compatible BLUETOOTH Profiles*
Supported Codec*
Transmission range (A2DP)
1
The actual range will vary depending on factors such as obstacles between devices, magnetic
*
fields around a microwave oven, static electricity, reception sensitivity, aerial’s performance,
operating system, software application, etc.
2
BLUETOOTH standard profiles indicate the purpose of BLUETOOTH communications between devices.
*
3
Codec: Audio signal compression and conversion format
*
4
Subband Codec
*
5
Advanced Audio Coding
*
6
LDAC is an audio coding technology developed by Sony that enables the transmission of
*
High-Resolution (Hi-Res) Audio content, even over a BLUETOOTH connection. Unlike other
BLUETOOTH compatible coding technologies such as SBC, it operates without any downconversion of the Hi-Res Audio content*
than those other technologies to be transmitted over a BLUETOOTH wireless network with
unprecedented sound quality, by means of efficient coding and optimized packetization.
7
Excluding DSD format contents.
*
8
In comparison with SBC when the bitrate of 990 kbps (96/48 kHz) or 909 kbps (88.2/44.1 kHz) is
*
selected.
Microphone
Type Electret condenser
Directional characteristic
Effective frequency range
General
Input AUDIO IN jack (stereo mini jack)
DC OUT
Power DC 5 V (Using a commercially-available USB AC adaptor capable of feeding in
Lithium-ion battery life (with playback via a BLUETOOTH connection)
BLUETOOTH Specification version 4.2
Line of sight approx. 10 m*
2
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio Video Remote Control Profile)
HSP (Headset Profile)
HFP (Hands-free Profile)
3
SBC*4, AAC*5, LDAC*
1
6
20 Hz - 20,000 Hz (Sampling frequency 44.1 kHz)
7
, and allows approximately three times more data*8
Omni directional
100 Hz - 7,000 Hz
USB jack Type A (for charging the battery of a connected device) (DC 5 V,
Max.1 A)
1.5 A) or, using built-in lithium-ion battery
9 *12
11 *12
10 *12
Approx. 24 hours*
Approx. 14 hours*
Approx. 4 hours*
Dimensions (including projecting parts and controls)
Mass Approx. 900 g including battery
Supplied accessory Micro-USB cable (1)
9
Measured value acquired by playing our specified music source with the volume level of the unit
*
set to 21, the sound mode set to STANDARD, and the illumination turned off.
10
Measured value acquired by playing our specified music source with the volume level of the unit
*
set to 21 and with the factory default settings (illumination: ON and sound mode: EXTRA BASS).
11
Measured value acquired by playing our specified music source with the volume level of the unit
*
set to maxim and with the factory default settings (illumination: ON and sound mode: EXTRA
BASS).
If the built-in lithium-ion battery is running low, the maximum volume is reduced to about half to
protect the circuit. This is a specification.
The usage life mentioned here also includes when playing back music at about half the volume.
12
Actual performance time may vary from the listed time due to the volume, songs played,
*
surrounding temperature, and usage conditions.
System requirements for charging battery using USB
Using a commercially-available USB AC adaptor capable of feeding in 1.5 A
Compatible iPhone/iPod models
iPhone X, iPhone 8 Plus, iPhone 8, iPhone 7 Plus, iPhone 7, iPhone SE, iPhone 6s Plus, iPhone 6s,
iPhone 6 Plus, iPhone 6, iPhone 5s, iPhone 5c, iPhone 5, iPod touch (6th generation)
The unit is compatible with iOS 10.0 or later.
Approx. 238 mm × 85 mm × 83 mm (w/h/d)
Design and specifications are subject to change without notice.
Loading...