SPP-98/99
SERVICE MANUAL
Singapore Model
Handset
unit
Photo: SPP-98
SPECIFICATIONS
General
Operating channel 10 channels
Dial signal
Tone, 10 PPS (pulse) selectable Supplied accessories
AC power adaptor (AC-T47) (1) Telephone line cord (1)
Rechargeable battery pack (BP-T16) (1) (SPP-98) Rechargeable battery pack (BP-T16) (2) (SPP-99) Wall bracket/stand (1)
Screws (2)
Handset
Power source
Rechargeable battery pack BP-T16 Battery life
Standby : Approx. 8 days Talk : Approx. 6 hours
Battery charging time Approx. 12 hours
Dimensions
Approx. 54 × 195 × 49 mm (w/h/d), antenna excluded
(approx. 2 1/4 × 7 3/4 × 1 15/16 inches) Antenna: Approx. 285 mm
(approx. 11 1/4 inches) Mass
Approx. 240 g (approx. 8 oz), battery included
Base unit
Power source
DC 9V from AC power adaptor Rechargeable battery pack BP-T16 (SPP-99 only)
Battery charging time
Approx. 20 hours (SPP-99 only) Dimensions
Approx. 120 × 64 × 223 mm (w/h/d), antenna excluded
(approx. 4 3/4 × 2 5/8 × 8 7/8 inches) Antenna: Approx. 680 mm (approx. 26 7/8 inches)
Mass
Approx. 350 g (approx. 12 oz), wall bracket and battery excluded
Design and specifications are subject to change without notice.
CORDLESS TELEPHONE
MICROFILM
– 1 –
SPP-98/99
5-4. SCHEMATIC DIAGRAM — BASE SECTION — • Refer to page 37 for IC Block Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. pF: μμF 50 WV or less are not indicated except for electrolytics and tantalums.
• All resistors are in Ω and 1/4 W or less unless other-
|
wise specified. |
|
• |
¢ |
: internal component. |
• |
C |
: panel designation. |
• |
U |
: B+ Line. |
• |
H |
: adjustment for repair. |
• Power voltage is dc 9 V and fed with regulated dc power supply from external power voltage jack.
• Voltage is dc with respect to ground under no-signal condition.
• Voltage dc with respect to ground under no-signal conditions.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production tolerances.
• Signal path.
N : RX
O : TX
P : bell
– 27 – |
– 28 – |