Sony S-Frame 4-185-902-13 (1), S-Frame DPF-X95, S-Frame 7525000093C, S-Frame DPF-X85 User Manual

4-185-902-13 (1)

P/N:7525000093C

For your safety

Digital Photo Frame

DPF-X85/X95

Operating Instructions

Before operating this unit, please read this manual thoroughly and retain it for future reference.

Owner’s Record

The model and serial numbers are located at the rear. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. DPF-X85/X95 Serial No. ________________________

Let’s get the photo

frame ready

Let’s view an image

Try using various functions

Troubleshooting

Additional information

Product lineup differs by country and region.

WARNING

To reduce fire or shock hazard, do not expose the unit to rain or moisture.

Do not expose the batteries to excessive heat such as sunshine, fire or the like.

CAUTION

Replace the battery with the specified type only. Otherwise, fire or injury may result. Dispose of used batteries according to the instructions.

For the customers in the U.S.A.

CAUTION

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

If you have any questions about this product, you may call:

Sony Customer Information Services Center 1-800-222-SONY (7669)

The number below is for the FCC related matters only.

Regulatory Information

Declaration of Conformity

Trade Name: SONY Model No.: DPF-X85 Responsible Party: Sony Electronics Inc. Address: 16530 Via Esprillo, San Diego,

CA 92127 U.S.A. Telephone No.: 858-942-2230 This device complies with part 15 of the FCC

Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Declaration of Conformity

Trade Name: SONY Model No.: DPF-X95 Responsible Party: Sony Electronics Inc. Address: 16530 Via Esprillo, San Diego,

CA 92127 U.S.A. Telephone No.: 858-942-2230 This device complies with part 15 of the FCC

Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna. – Increase the separation between the equipment and

receiver.

– Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV

technician for help.

For the State of California, USA only

Perchlorate Material - special handling may apply, See

www.dtsc.ca.gov/hazardouswaste/perchlorate Perchlorate Material: Lithium battery contains

perchlorate.

For the Customer in Europe

This product has been tested and found compliant with the limits set out in the EMC Directive for using connection cables shorter than 3 meters (9.8 feet).

Attention

The electromagnetic fields at the specific frequencies may influence the picture of this digital photo frame.

Notice

If static electricity or electromagnetism causes data transfer to discontinue midway (fail), restart the application or disconnect and connect the communication cable (USB, etc) again.

Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems)

This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative

consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product.

Disposal of waste batteries (applicable in the European Union and other European countries with separate collection systems)

This symbol on the battery or on the packaging indicates that the battery provided with this product shall not be treated as household waste. On certain batteries this symbol might be used in combination with a chemical symbol.

The chemical symbols for mercury (Hg) or lead (Pb) are added if the battery contains more than 0.0005% mercury or 0.004% lead. By ensuring these batteries are disposed of correctly, you will help prevent potentially negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of the battery. The recycling of the materials will help to conserve natural resources. In case of products that for safety, performance or data integrity reasons require a permanent connection with an incorporated battery, this battery should be replaced by qualified service staff only. To ensure that the battery will be treated properly, hand over the product at end-of-life to the applicable collection point for the recycling of electrical and electronic equipment. For all other batteries, please view the section on how to remove the battery from the product safely. Hand the battery over to the applicable collection point for the recycling of waste batteries.

For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product.

Notice for the customers in the countries applying EU Directives

The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. The Authorized Representative for EMC and product safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents.

Notice for users

Read this before using

All rights reserved. This manual or the software described herein, in whole or in part, may not be reproduced, translated or reduced to any machine readable form without prior written approval from Sony Corporation.

IN NO EVENT SHALL SONY CORPORATION BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES, WHETHER BASED ON TORT, CONTACT, OR OTHERWISE, ARISING OUT OF OR IN CONNECTION WITH THIS MANUAL, THE SOFTWARE OR OTHER INFORMATION CONTAINED HEREIN OR THE USE THEREOF.

Sony Corporation reserves the right to make any modification to this manual or the information contained herein at any time without notice.

The software described herein may also be governed by the terms of a separate user license agreement.

Any design data such as sample pictures provided in this software cannot be modified or duplicated except for the purpose of personal use. Any unauthorized duplication of this software is prohibited under copyright law.

Please note that unauthorized duplication or modification of portraits or copyrighted work could infringe the rights reserved by rights holders.

On the illustrations and screen shots used in this manual

The illustrations and screen shots used in this manual are of the DPF-X85 unless noted otherwise.

The illustrations and screen shots used in this manual may not be identical to those actually used or displayed.

Notes on playback

Connect the AC adaptor to an easily accessible AC outlet. Should you notice an abnormality in it, disconnect it from the AC outlet immediately.

Notes on copyrights

Duplication, edition, or printing of a CD, TV programs, copyrighted materials such as pictures or publications, or any other materials except for your own recording or creation is limited to private or domestic use only. Unless you hold copyright or have permission of copyright holders for the materials to be duplicated, use of those materials beyond this limit may infringe the provisions of the copyright law and be subject to the copyright holders claim for damages.

When using photo images with this digital photo frame, pay special attention not to infringe the provisions of the copyright law. Any unauthorized use or modification of other’s portrait may also infringe their rights.

For some demonstrations, performances, or exhibits, photography may be forbidden.

Recording contents are not guaranteed

Sony shall assume no responsibility for any accidental or consequential damages or loss of the recording contents which may be caused by use or malfunction of the digital photo frame or memory card.

Backup recommendations

To avoid potential risk of data loss caused by accidental operation or malfunction of the digital photo frame, we recommend that you save a backup copy of your data.

Notes on LCD screen

• Do not press against the LCD screen. The screen may be discolored and that may cause a malfunction.

• Exposing the LCD screen to direct sunlight for a long period may cause malfunctions.

• The LCD screen is manufactured using extremely high-precision technology, so over 99.99% of the pixels are operational for effective use. However, there may be some tiny black points and/or bright points (white, red, blue or green in color) that constantly appear on the LCD screen. These points are normal in the manufacturing process and do not affect the viewing in any way.

• Images may trail across on the LCD screen in a cold location. This is not a malfunction.

Read this before using ..................................................................................... 4

For your safety

Checking included items .................................................................................. 7

Identifying the parts ......................................................................................... 8

Digital photo frame .................................................................................................... 8

Remote control .......................................................................................................... 9

Let’s get the photo frame ready

Remote control .............................................................................................. 10

Stand .............................................................................................................10

To display the photo frame on the wall .................................................................... 11

Turning the photo frame on ........................................................................... 12

Operations in an initial state ........................................................................... 13

Setting the current time ................................................................................. 14

Let’s view an image

Inserting a memory card ................................................................................ 15

Changing the display ...................................................................................... 16

About the information displayed on the LCD screen ................................................ 17

Try using various functions

Various functions ........................................................................................... 18

Sorting images (Filtering) .............................................................................. 19

Specifying the playback device ...................................................................... 20

Adjusting image size and orientation (Zoom in/Zoom out/Rotate) ................. 20

Changing the settings of the auto power on/off function ............................... 21

Changing the settings .................................................................................... 22

Refresh mode ................................................................................................ 23

Connecting to a computer .............................................................................. 24

Continued

Troubleshooting

If an error message appears ...........................................................................25

If trouble occurs .............................................................................................25

Additional information

Precautions ....................................................................................................27

Installation ...............................................................................................................27

Cleaning ..................................................................................................................27

Restrictions on duplication ......................................................................................27

Disposing of the photo frame ...................................................................................27

Specifications .................................................................................................28

On trademarks and copyrights .................................................................................30

oyousaey

For your safety

Checking included items

Make sure that the following items are included.

Digital photo frame (1)

For your safety

Stand (1)

Remote control (1)

AC adaptor (1)

Operating Instructions (this manual) (1) CD-ROM (Digital Photo Frame Handbook) (1) Warranty (1)

(In some regions, the warranty is not supplied.)

Attaching to the screw hole (.page 10)

Removing the protective sheet (. page 10)

Connecting to the AC power source (.page 12)

The supplied CD-ROM contains the Digital Photo Frame Handbook that explains operations and setups of the digital photo frame in detail. To view the handbook, insert the CD-ROM into the computer and double-click the Handbook icon. (To display the handbook, you need Adobe Acrobat Reader. )

Identifying the parts

x Digital photo frame

Front

LCD screen

Remote sensor

Sony logo (.page 10)

Rear

VIEW MODE button (.page 16)

Standby indicator

1 (on/standby) button

MENU button

Direction (B/b/v/V) buttons, ENTER ( ) button

BACK button

Reset switch

Access lamp

Memory card slot (.page 15)

Holes for hanging unit on the wall

Space for storing the stand

USB B connector (.page 24)

x Remote control

SLIDE-SHOW ( ) button

CLOCK ( ) button

MENU button

BACK button

MARKING ( ) button

SORT button

SELECT DEVICE button

Stand (.page 10)

DC IN 5V jack (.page 12)

For your safety

VIEW MODE buttons

1 (on/standby) button

SINGLE button

INDEX ( ) button

Zoom in ( ) button

Direction (B/b/v/V) buttons

ENTER ( ) button

Zoom out ( ) button

IMPORT ( ) button

DELETE ( ) button

ROTATE ( ) button

About descriptions in this manual

The operations described in this manual are based on remote control operation. When an operation is performed differently, for example, with the remote control and the buttons on the photo frame, it will be explained in a tip.

Let’s get the photo frame ready

P Notes

• If the remote control stops working:

Replace the battery (CR2025 lithium battery) with a new one.

• When the lithium battery becomes weak, the operating distance of the remote control may shorten, or the remote control may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion.

Replacing procedures:

.CD-ROM (Handbook) page 9

P WARNING

Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.

z Tips

When the photo frame is

placed in the portrait orientation

If you set the photo frame with its operations buttons facing upwards, the display is also automatically rotated to the portrait orientation.

Remote control

Pull out the protective sheet before use as shown in the figure.

Protective sheet

Using the remote control

Point the top end of the remote control towards the remote sensor on the photo frame.

Stand

Screw the stand into the screw hole firmly until the stand stops turning.

x Sony logo

When the photo frame is placed in the portrait orientation or when you turn off the power, the Sony logo doesn't light up.

You can set the photo frame to portrait or landscape orientation by rotating it without moving the stand.

+ 22 hidden pages

Sony S-Frame 4-185-902-13 (1), S-Frame DPF-X95, S-Frame 7525000093C, S-Frame DPF-X85 User Manual

Read this before using

Table of Contents

For your safety

Checking included items

Identifying the parts

x Digital photo frame

x Remote control

Let’s get the photo frame ready

Remote control

Stand