Sony SAVA-700, SAVA-500 User Manual

3-866-402-11(1)

Home Theater

Active Speaker System

Operating Instructions

SAVA-700 SAVA-500

 1999 by Sony Corporation

WARNING

To prevent fire or shock hazard, do not expose the unit to rain or moisture.

This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

CAUTION

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

Owner’s record

The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product.

Model No. SAVA-700/500 Serial No. .

For the customers in Canada CAUTION

TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS POLARIZED AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

This Class B digital apparatus complies with Canadian IEES-003.

Precautions

On safety

Should any solid object or liquid fall into the cabinet, unplug the speaker system and have it checked by qualified personnel before operating it any further.

On power sources

• AC power cord must be changed only at the qualified service shop.

• Before operating the speakers, check that the operating voltage is identical with your local power supply. The operating voltage is indicated on the nameplate on the rear of the speakers.

• The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.

• If you are not going to use the speakers for a long time, be sure to disconnect the speakers from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord.

• One blade of the plug is wider than the other for the purpose of safety and will fit into the wall outlet only one way. If you are unable to insert the plug fully into the outlet, contact your dealer.

On placement

• Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.

• Do not place the speakers near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.

• Good ventilation is essential to prevent internal heat buildup. Place the speakers in a location with adequate air circulation, and in a way that does not block the rear ventilation holes.

• Do not drag the unit along the floor on installment.

On cleaning

Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.

If you have any question or problem concerning your speaker system, please consult your nearest Sony dealer.

Welcome!

TABLE OF CONTENTS

Thank you for purchasing the Sony speaker system. The SAVA-700 and SAVA-500 are home theater active speaker systems incorporating a Dolby Pro Logic decoder, 5.1-channel input jacks, and subwoofers. These systems are easy to setup and allows you to enjoy five different types of surround sound, accommodating a variety of program sources.

About This Manual

Before operating the unit, please read this manual thoroughly and retain it for future reference.

The instructions in this manual describe the controls on the left front speaker for SAVA-700 and SAVA-500. Check your model number by looking at the rear panel of your left front speaker. The SAVA-700 is the model used for illustration purposes unless stated otherwise. Any difference in operation is clearly indicated in the text, for example, “SAVA-700 only.”

Getting Started

Unpacking 4 Hooking Up the Speaker System 5 Hooking Up the Speaker System 5.1-channel Input 7 Choosing the Best Location 8 Turning the Speaker System On and Off 9

Home Theater Operations

Enjoying Surround Sound 10 Adjusting the Surround Sound 11 Adjusting the Sound 13 Operating Other Sony Components 14

Additional Information

Troubleshooting 15 Specifications 16 Glossary 18

Index 19

Convention

The following icons are used in this manual:

Indicates that you can use the

remote to do the task. Indicates hints and tips for

making the task easier.

This speaker system incorporates the Dolby* Pro Logic Surround System.

* Manufactured under license from

Dolby Laboratories Licensing Corporation. DOLBY, the double-D symbol a, “PRO LOGIC,” and “Dolby Digital (AC-3)” are trademarks of Dolby Laboratories Licensing Corporation.

Getting Started

Unpacking

Check that you received the following items with your speaker system:

• Satellite speakers SS-T100 (SAVA-700 only) (3; one for the center speaker, and two for the rear speakers)

• Mounting brackets (SAVA-700 only) (2)

• Wood screws (SAVA-700 only) (4)

• Foot pads (SAVA-700 only) (12)

• Center speaker SS-CN16 (SAVA-500 only) (1)

• Rear speakers SS-SR16 (SAVA-500 only) (2)

• Foot pads (SAVA-500 only) (4)

• Front L/R speaker connecting cord, 3.5 m (12 ft) (1)

• Center speaker connecting cord, 2.5 m (8 ft 2 (1)

• Rear speaker connecting cords, 10 m (32 ft 9 (2)

• Audio connecting cord, 1.5 m (5 ft) (1)

• Remote commander (remote) RM-J70 (1)

• Sony size-AA (R6) batteries (2)

• SCART adaptor (European model only) (1)

Inserting batteries into the remote

Insert two size-AA (R6) batteries with the terminals matched to the + and – on the battery compartment. When using the remote, point it at the remote sensor g on the left front speaker.

]

}

]

z When to replace batteries

Under normal use, the batteries should last for about 6 months. When the remote no longer operates the speakers, replace both batteries with new ones.

Notes

• Do not leave the remote in an extremely hot or humid place.

• Do not use a new battery with an old one.

• Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

• If you do not use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

/2 in.)

/4 in.)

Attaching the supplied foot pads to the center speaker

Attach the supplied foot pads to the bottom of the speaker, one in each of the four corners to place the center speaker on your TV set. Make sure the speaker is solidly placed on the top of the TV set.

Foot pads

Note

Do not place the speaker on top of a TV set which is smaller than the speaker.

Installing the rear speakers with the supplied accessories (SAVA-700 only)

Use the supplied accessories to properly install the rear speakers in their selected locations (see page 8).

Foot pads

If you install the rear speakers on a shelf or speaker stand, attach the supplied foot pads to the bottom of the speakers, one in each of the four corners, and make sure that the speakers are solidly placed.

Foot pads

Note

Do not place any speaker on shelves or stands which are smaller than the speaker.

Mounting brackets

If you wish to hang the rear speakers on a wall with hooks (not supplied), use the supplied wood screws to attach the supplied mounting brackets to the upper part of the back panel of each rear speaker.

Mounting bracket

Wood screw

Rear speaker

Notes

• You are responsible for the proper selection and use of mounting hardware that you purchase at hardware stores, and for the proper and safe mounting of the speakers.

• Each satellite speaker has a corresponding position for optimum sound effect. Before attaching the mounting brackets, see “Positioning the center and rear speakers for better surround effect (SAVA-700 only)” on page 8.

Hooking Up the Speaker System

This section describes how to connect the speaker system to your TV and VCR.

Getting Started

Rear speaker (right)

STEP 3

Front speaker (right)

Center speaker

STEP 1

TV set

VCR

* If you use an SA-IF70 Wireless

Speaker System (optional) for the rear speakers, connect the transmitter supplied with the SA-IF70 system to this connector. For details, refer to the Operating Instructions provided with the SA-IF70 system.

STEP 4

Rear speaker (left)

Transmitter for Wireless Rear Speaker* (option)

STEP 2 STEP 3

STEP 1

Front speaker (left)

STEP 3

STEP 5

To wall outlet

The arrow ç indicates signal flow.

STEP 1 Connecting the front speakers

Front speaker (right) Front speaker (left)

R-ch

SPEAKER

INPUT

R-ch

SPEAKER

OUTPUT

Ç

To disconnect a cord, hold down the release tab and pull out the connector. Never pull the cord itself.

STEP 2 Connecting the center speaker

Use the supplied 8-foot-2 1/2 inch (2.5 m) speaker cord to connect the center speaker. Insert the stripped wires into the speaker terminals.

Center speaker

Front speaker (left)

CENTER SPEAKER

–+

Ç

Be sure to connect matching speaker terminals (e.g., use the solid-color wire to connect + to +, and use the striped wire to connect – to –). If the connections are reversed (+ to –), the sound will lack bass.

(Continued)

Getting Started

STEP 3 Connecting the rear speakers

Use the supplied 32-foot-9 3/ cords to connect the left and right rear speakers. Insert the stripped wires into the speaker terminals.

Rear speaker

(right)

#3 #3

For customers in Canada

Use only the supplied SS-T100 Satellite Speakers for connection to the CENTER SPEAKER terminal and REAR SPEAKERS terminal of SAVA-700. Use only the supplied SS-CN16 Center Speaker for connection to the CENTER SPEAKER terminal of SAVA-500 and SS-SR16 Rear Speakers for connection to the REAR SPEAKERS terminal of SAVA-500.

inch (10 m) speaker

Rear speaker

–+

REAR SPEAKERS

(left)

If you use AUDIO OUT jacks marked VARIABLE

After making the connection as shown above, turn up the volume on the TV set. Use this speaker system’s volume control for regular volume adjustment. Turning down the volume on the TV set reduces the AUDIO OUT signal level and may cause a loss in sound quality and/or activate the auto-power on/off function (see page 9).

Connecting the SCART adaptor (European model only)

You can listen to the sound from the TV or VCR by connecting the audio signal from the TV or VCR to the left front speaker.

to TV audio

input

to VCR audio

input

Euro AV cable (not supplied)

ç

White (L)

Red (R)

White (L)

Red (R)

TV VCR

SCART adaptor

Front speaker (left) TV IN

LIN TVR

LINVIDEOR

Front speaker (left) VIDEO IN

(supplied)

STEP 4 Connecting your TV

Use the supplied a pair of audio connecting cords to connect the TV IN jacks on the left front speaker to the AUDIO OUT jacks on your TV.

Important

If your TV set has an on/off switch for its internal speaker, set this to off, and enjoy the sound of this speaker system. If your TV set does not, set the volume on your TV set to minimum.

Front speaker (left)TV

LIN

VIDEO

AUDIO

OUTPUT

ç

to TV set

If you have a Sony XBR2 series TV or Sony Projection TV equipped with a speaker switch (For U.S. and Canadian customers only)

If your Sony XBR2 series TV set or Projection TV is compatible with SAVA series speakers, you can use the TV set’s menu and remote control functions to operate this speaker system. For details, see the Operating Instructions supplied with your TV set. Be sure to connect the TV IN jacks on the left front speaker to the TV set’s FIXED AUDIO OUTPUT jacks if you make this connection.

+ 14 hidden pages